Characterization and light emission properties of β-FeSi2 precipitates in Si synthesized by metal vapor vacuum arc ion implantation

Author(s):  
Y. Gao ◽  
S.P. Wong ◽  
W.Y. Cheung ◽  
G. Shao ◽  
K.P. Homewood
2007 ◽  
Vol 515 (22) ◽  
pp. 8122-8128 ◽  
Author(s):  
S.P. Wong ◽  
C.F. Chow ◽  
Judith Roller ◽  
Y.T. Chong ◽  
Q. Li ◽  
...  

1991 ◽  
Vol 235 ◽  
Author(s):  
Kin Man Yu ◽  
Ian G. Brown ◽  
Seongil Im

ABSTRACTWe have synthesized single crystal Si1−xGex alloy layers in Si <100> crystals by high dose Ge ion implantation and solid phase epitaxy. The implantation was performed using the metal vapor vacuum arc (Mevva) ion source. Ge ions at mean energies of 70 and 100 keV and with doses ranging from 1×1016 to to 7×1016 ions/cm2 were implanted into Si <100> crystals at room temperature, resulting in the formation of Si1−xGex alloy layers with peak Ge concentrations of 4 to 13 atomic %. Epitaxial regrowth of the amorphous layers was initiated by thermal annealing at temperatures higher than 500°C. The solid phase epitaxy process, the crystal quality, microstructures, interface morphology and defect structures were characterized by ion channeling and transmission electron microscopy. Compositionally graded single crystal Si1−xGex layers with full width at half maximum ∼100nm were formed under a ∼30nm Si layer after annealing at 600°C for 15 min. A high density of defects was found in the layers as well as in the substrate Si just below the original amorphous/crystalline interface. The concentration of these defects was significantly reduced after annealing at 900°C. The kinetics of the regrowth process, the crystalline quality of the alloy layers, the annealing characteristics of the defects, and the strains due to the lattice mismatch between the alloy and the substrate are discussed.


2007 ◽  
Vol 25 (1) ◽  
pp. 110-116 ◽  
Author(s):  
K. P. Purushotham ◽  
L. P. Ward ◽  
N. Brack ◽  
P. J. Pigram ◽  
P. Evans ◽  
...  

2000 ◽  
Vol 648 ◽  
Author(s):  
X.Q. Cheng ◽  
H.N. Zhu ◽  
B.X. Liu

AbstractFractal pattern evolution of NiSi2 grains on a Si surface was induced by high current pulsed Ni ion implantation into Si wafer using metal vapor vacuum arc ion source. The fractal dimension of the patterns was found to correlate with the temperature rise of the Si substrate caused by the implanting Ni ion beam. With increasing of the substrate temperature, the fractal dimensions were determined to increase from less than 1.64, to beyond the percolation threshold of 1.88, and eventually up to 2.0, corresponding to a uniform layer with fine NiSi2 grains. The growth kinetics of the observed surface fractals was also discussed in terms of a special launching mechanism of the pulsed Ni ion beam into the Si substrate.


2003 ◽  
Vol 220 (1-4) ◽  
pp. 40-45 ◽  
Author(s):  
Chun Rong ◽  
Jizhong Zhang ◽  
Wenzhi Li

2014 ◽  
Vol 2014 ◽  
pp. 1-8 ◽  
Author(s):  
J. Bornacelli ◽  
J. A. Reyes-Esqueda ◽  
L. Rodríguez-Fernández ◽  
J. L. Ruvalcaba-Sil ◽  
F. J. Jaimes ◽  
...  

Efficient silicon-based light emitters continue to be a challenge. A great effort has been made in photonics to modify silicon in order to enhance its light emission properties. In this aspect silicon nanocrystals (Si-NCs) have become the main building block of silicon photonic (modulators, waveguide, source, and detectors). In this work, we present an approach based on implantation of Ag (or Au) ions and a proper thermal annealing in order to improve the photoluminescence (PL) emission of Si-NCs embedded in SiO2. The Si-NCs are obtained by ion implantation at MeV energy and nucleated at high depth into the silica matrix (1-2 μm under surface). Once Si-NCs are formed inside the SiO2we implant metal ions at energies that do not damage the Si-NCs. We have observed by, PL and time-resolved PL, that ion metal implantation and a subsequent thermal annealing in a hydrogen-containing atmosphere could significantly increase the emission properties of Si-NCs. Elastic Recoil Detection measurements show that the samples with an enhanced luminescence emission present a higher hydrogen concentration. This suggests that ion metal implantation enhances the hydrogen diffusion into silica matrix allowing a better passivation of surface defects on Si NCs.


2000 ◽  
Vol 611 ◽  
Author(s):  
X. W. Zhang ◽  
S. P. Wong ◽  
W. Y. Cheung ◽  
F. Zhang

ABSTRACTNickel disilicide layers were prepared by nickel ion implantation into silicon substrates using a metal vapor vacuum arc ion source at various beam current densities to an ion dose of 6×1017 cm−2. Characterization of the as-implanted and annealed samples was performed using Rutherford backscattering spectrometry, x-ray diffraction, electrical resistivity and Hall effect measurements. The temperature dependence of the sheet resistivity and the Hall mobility from 30 to 400 K showed peculiar peak and valley features varying from sample to sample. A two-band model was proposed to explain the observed electrical transport properties.


Sign in / Sign up

Export Citation Format

Share Document