Subsurface modification and relative optical density of synthetic diamond

1997 ◽  
Vol 119 (3-4) ◽  
pp. 181-184 ◽  
Author(s):  
Zhongquan Ma ◽  
Yufeng Zheng ◽  
H. Naramoto
2007 ◽  
Vol 31 (1) ◽  
pp. 861-868 ◽  
Author(s):  
Kuo Tian ◽  
Fengshan Liu ◽  
Min Yang ◽  
Kevin A. Thomson ◽  
David R. Snelling ◽  
...  

RSC Advances ◽  
2018 ◽  
Vol 8 (29) ◽  
pp. 16223-16231 ◽  
Author(s):  
Chien-Hao Chen ◽  
Yuan-Yuan Yao ◽  
Hao-Che Tang ◽  
Tung-Yi Lin ◽  
Dave W. Chen ◽  
...  

In this study, we developed a surface modification of 3D printing PLA disks. The relative optical density of the S. aureus in the solution can reduce to 40% using the PLA disk directly absorbed with suitable antibiotic agents.


2006 ◽  
Vol 144 (4) ◽  
pp. 782-791 ◽  
Author(s):  
Kuo Tian ◽  
Kevin A. Thomson ◽  
Fengshan Liu ◽  
David R. Snelling ◽  
Gregory J. Smallwood ◽  
...  

2020 ◽  
Vol 11 (1) ◽  
pp. 269-276
Author(s):  
Béla Fülesdi ◽  
Szabolcs Farkas ◽  
Zoltán Gyöngyösi ◽  
Péter Siró ◽  
Dániel Bereczki ◽  
...  

AbstractBackgroundWe tested the hypothesis whether there is a correlation between the echogenicity and calcium and water contents of carotid plaques.Patients and methodsNinety carotid befurcations from 45 deceased patients were removed during autopsy. Thirty-four plaques were categorized as homogenous echolucent (HEL), homogenous echogenic (HEG) and heterogenous (HE) plaques based on premortem B-mode image. Water content was expressed in % of wet weight. Ca was determined by proton-induced X-ray emission and expressed in ppm. Relative optical density of the B-mode images was analyzed offline using a computer program.ResultsHEL plaques had lower Ca content (medians and IQRs: 6,145 [4,465–6,536 ppm]) compared to HEG (74,100 [15,300–1,44,500−ppm]), P ≤ 0.001). HE plaques showed an intermediate calcium content (7,310 [4,840–9,920 ppm]) that was statistically not different from echolucent plaques. Water content of HEG plaques was statistically not different from HEL and HE (HEG:53.5 [35.5–64%], HEL: 73.5 [69.7–78.5%], HE: 70.6 [67.4–73.9%]). HEG plaques had the highest relative optical densities (196 [188–217%]). HEL and HE had similar relative optical densities (HEL: 176 [164–187%], HE: 164 [144–188%], respectively). A significant positive correlation was found between the Ca content and relative optical density of plaques.ConclusionsEchogenicity of carotid plaques increases along with their calcium content. Water content may be an important factor in differentiation of different plaques.


2007 ◽  
Vol 132 (1) ◽  
pp. 29-43 ◽  
Author(s):  
David C. Zlesak ◽  
Neil O. Anderson

Potted Easter lily (Lilium longiflorum Thunb.) ranks among the top five potted flowering plants in the United States in economic value. One clone (‘Nellie White’) dominates the North American market. It is grown by less than 10 bulb producers, each maintaining their own propagation stock and practicing intraclonal strain selection. Greenhouse forcers attest to forcing differences depending on the bulb grower. The objective of this study was to determine the extent and sources of morphological variability among bulb growers. Bulb lots were obtained in 2002 (S1) and 2003 (S2) (n = 11 and n = 12 lots respectively) with 12 or 15 bulbs/lot. Grower's identification was confidential but kept consistent across shipment years. Bulbs were obtained as the 20.3 to 22.9-cm circumference commercial class, and S1 and S2 shipments were control temperature forced over two forcing cycles (FC1, FC2). Data collection included initial bulb weight and circumference; days to stem emergence (SEM), visible flower bud (VFB), and anthesis (AN); plant and inflorescence height; number of stems, leaves, flowers, and ovules per first flower/stem reaching AN; percentage of ovules forming viable seeds; leaf length and width; major lily viruses (presence/absence, relative optical density); leaf length-to-width ratios; AN-SEM, AN-VFB, and VFB-SEM. Significant differences were found among bulb lots for every trait except AN-VFB. Variability among bulb lots can be attributed to variation in initial bulb size, previous forcing cycle environment, variable lily symptomless virus (LSV) titer, and underlying genetic/epigenetic differences. Bulb circumference had the highest standardized canonical coefficient for canonical variable one in S2-FC1 and was a significant covariate in analysis of covariance; larger bulbs tended to produce larger plants. Forcing over two cycles allowed for less phenotypic variability among bulb lots in FC2 because of a common FC1 environment. All lilies were positive for LSV and negative for four other viruses tested. Significant negative correlations in S2 between relative optical density and plant height (FC1), initial bulb weight (FC2), and initial bulb circumference (FC2) indicate an effect of relative LSV titer on plant morphology. The role of LSV titer and genetic/epigenetic intergrower variability in ‘Nellie White’ warrants further investigation. Likewise, a lack of breeder/producer companies and the corollary independent grower strain selection has significant genetic consequences and complicates identification of superior ‘Nellie White’ clones.


1994 ◽  
Vol 42 (9) ◽  
pp. 1295-1298 ◽  
Author(s):  
T J Eakin ◽  
D G Baskin ◽  
J F Breininger ◽  
W L Stahl

Probes labeled with 33P have potential for widespread use in in situ hybridization because they are better able to detect relatively scarce mRNAs compared with probes labeled with 35S, but the relatively short half-life of 33P is a disadvantage when it is used as a radioactivity standard for quantitative autoradiography. To determine if plastic sections containing 14C can be used as standards for quantitative autoradiography with 33P, we co-exposed 33P-labeled liver paste sections and 14C-plastic standards to Hyperfilm beta max. The autoradiographic response of Hyperfilm beta max to these isotopes was almost identical. Second-order polynomial equations obtained from analysis of film relative optical density and radioactivity permitted derivation of tissue-equivalent radioactivity from the film optical densities produced by the 14C standards for 1-14-day exposures. These results validate the use of plastic 14C standards for quantifying 33P used in contact film autoradiography.


Author(s):  
Z.L. Wang ◽  
J. Bentley ◽  
R.E. Clausing ◽  
L. Heatherly ◽  
L.L. Horton

It has been found that the abrasion of diamond-on-diamond depends on the crystal orientation. For a {100} face, the friction coefficient for sliding along <011> is much higher than that along <001>. For a {111} face, the abrasion along <11> is different from that in the reverse direction <>. To interpret these effects, a microcleavage mechanism was proposed in which the {100} and {111} surfaces were assumed to be composed of square-based pyramids and trigonal protrusions, respectively. Reflection electron microscopy (REM) has been applied to image the microstructures of these diamond surfaces.{111} surfaces of synthetic diamond:The synthetic diamonds used in this study were obtained from the De Beers Company. They are in the as-grown condition with grain sizes of 0.5-1 mm without chemical treatment or mechanical polishing. By selecting a strong reflected beam in the reflection high-energy electron diffraction (RHEED) pattern, the dark-field REM image of the surface is formed (Fig. 1).


Author(s):  
James R. Kremer ◽  
Paul S. Furcinitti ◽  
Eileen O’Toole ◽  
J. Richard McIntosh

Characteristics of electron microscope film emulsions, such as the speed, the modulation transfer function, and the exposure dependence of the noise power spectrum, have been studied for electron energies (80-100keV) used in conventional transmission microscopy. However, limited information is available for electron energies in the intermediate to high voltage range, 300-1000keV. Furthermore, emulsion characteristics, such as optical density versus exposure, for new or improved emulsions are usually only quoted by film manufacturers for 80keV electrons. The need for further film emulsion studies at higher voltages becomes apparent when searching for a film to record low dose images of radiation sensitive biological specimens in the frozen hydrated state. Here, we report the optical density, speed and relative resolution of a few of the more popular electron microscope films after exposure to 1MeV electrons.Three electron microscope films, Kodak S0-163, Kodak 4489, and Agfa Scientia 23D56 were tested with a JEOLJEM-1000 electron microscope operating at an accelerating voltage of 1000keV.


Sign in / Sign up

Export Citation Format

Share Document