Effects of alternating current imposition and alkaline earth elements on modification of primary Mg2Si crystals in hypereutectic Mg-Si alloy

2009 ◽  
Vol 19 (5) ◽  
pp. 1051-1056 ◽  
Author(s):  
Jun DU ◽  
K. IWAI ◽  
Wen-fang LI ◽  
Ji-hua PENG
2008 ◽  
Vol 14 (36) ◽  
pp. 11292-11295 ◽  
Author(s):  
Mark R. Crimmin ◽  
Anthony G. M. Barrett ◽  
Michael S. Hill ◽  
Dugald J. MacDougall ◽  
Mary F. Mahon ◽  
...  

2016 ◽  
Vol 858 ◽  
pp. 671-676 ◽  
Author(s):  
Daniel J. Lichtenwalner ◽  
Vipindas Pala ◽  
Brett A. Hull ◽  
Scott Allen ◽  
John W. Palmour

Alkaline earth elements Sr and Ba provide SiO2/SiC interface conditions suitable for obtaining high channel mobility metal-oxide-semiconductor field-effect-transistors (MOSFETs) on the Si-face (0001) of 4H-SiC, without the standard nitric oxide (NO) anneal. The alkaline earth elements Sr and Ba located at/near the SiO2/SiC interface result in field-effect mobility (μFE) values as high as 65 and 110 cm2/V.s, respectively, on 5×1015 cm-3 Al-doped p-type SiC. As the SiC doping increases, peak mobility decreases as expected, but the peak mobility remains higher for Ba interface layer (Ba IL) devices compared to NO annealed devices. The Ba IL MOSFET field-effect mobility decreases as the temperature is increased to 150 °C, as expected when mobility is phonon-scattering-limited, not interface-trap-limited. This is in agreement with measurements of the interface state density (DIT) using the high-low C-V technique, indicating that the Ba IL results in lower DIT than that of samples with nitric oxide passivation. Vertical power MOSFET (DMOSFET) devices (1200V, 15A) fabricated with the Ba IL have a 15% lower on-resistance compared to devices with NO passivation. The DMOSFET devices with a Ba IL maintain a stable threshold voltage under NBTI stress conditions of-15V gate bias stress, at 150 °C for 100hrs, indicating no mobile ions. Secondary-ion mass-spectrometry (SIMS) analysis confirms that the Sr and Ba remain predominantly at the SiO2/SiC interface, even after high temperature oxide annealing, consistent with the observed high channel mobility after these anneals. The alkaline earth elements result in enhanced SiC oxidation rate, and the resulting gate oxide breakdown strength is slightly reduced compared to NO annealed thermal oxides on SiC.


MRS Advances ◽  
2020 ◽  
Vol 5 (3-4) ◽  
pp. 131-140
Author(s):  
Colleen Mann ◽  
Jeremy R. Eskelsen ◽  
Donovan N. Leonard ◽  
Eric Pierce ◽  
Claire L Corkhill

AbstractIt is pertinent to the safety case for geological disposal in the UK that the behaviour of vitrified wastes in proximity to cementitious materials is understood. In this study, vitrified simulant intermediate level nuclear waste (ILW) was subject to dissolution in a synthetic cement water solution to simulate disposal conditions. Results show that the presence of alkali / alkaline earth elements in the cementitious solution can be favourable, at least in the short-term, leading to lower dissolution rates associated with incorporation of these elements into the altered layer of the glass.


Water ◽  
2018 ◽  
Vol 10 (12) ◽  
pp. 1829 ◽  
Author(s):  
Hassan Jebreen ◽  
Andre Banning ◽  
Stefan Wohnlich ◽  
Andrea Niedermayr ◽  
Marwan Ghanem ◽  
...  

This work reports, for the first time, the mineralogical and geochemical characteristics of karst aquifers in the Central West Bank (CWB) catchment in Palestine. It provides an integrated study approach by correlating the geochemistry of the lithology and hydrochemical data of groundwater samples. Mineralogical analysis showed that all of the samples were dominantly composed of either calcite CaCO3 (5–100 wt. %) or dolomite CaMg(CO3)2 (4–100 wt. %), with minor amounts of quartz and feldspar, which is supported by the inorganic carbon content (9–13 wt. %) and hydrochemical composition of the spring water samples. The whole-rock geochemical data indicated that the samples have low contents of trace elements and transition metals. In contrast, the concentrations of alkaline earth elements (Mg, Ca, Sr, Ba) and Mn were high in the rock and groundwater samples. Generally, the trace elements of rock samples with concentrations >10 ppm included Sr (17–330 ppm), Mn (17–367 ppm), Ba (2–32 ppm), W (5–37 ppm), Cr (3–23 ppm), Zn (1.7–28 ppm), V (4–23 ppm), and Zr (1–22 ppm), while the concentrations of all the other trace elements was below 10 ppm. Ionic ratios and hierarchical cluster analysis (HCA) suggested that the chemical evolution of groundwater was mainly related to the geogenic (rock–water) interaction in the study area. This is clear in the alkaline earth elements (Mg, Ca, Sr, Ba) ratios, especially regarding the Sr values. The calcite rock samples had higher Sr (mean 160 ppm, n = 11) than those of the dolomite rocks (mean 76 ppm, n = 9).


Sign in / Sign up

Export Citation Format

Share Document