Design and flight test of active flutter suppression on the X-56A multi-utility technology test-bed aircraft

2016 ◽  
Vol 120 (1228) ◽  
pp. 893-909 ◽  
Author(s):  
E. L. Burnett ◽  
J. A. Beranek ◽  
B. T. Holm-Hansen ◽  
C. J. Atkinson ◽  
P. M. Flick
Keyword(s):  
Flight Control ◽  
Flight Test ◽  
Test Bed ◽  
Control Laws ◽  
Control Approach ◽  
Mode Control ◽  
Flying Qualities ◽  
Technical Challenges ◽  
Long Endurance ◽  
Aircraft Configurations

ABSTRACTEfforts to develop the next generation of aircraft with ever-increasing levels of performance – higher, farther, faster, cheaper – face great technical challenges. One of these technical challenges is to reduce structural weight of the aircraft. Another is to look to aircraft configurations that have been unrealizable to date. Both of these paths can lead to a rigid flex coupling phenomenon that can result in anything from poor flying qualities to the loss of an aircraft due to flutter. This has led to a need to develop an integrated flight and aeroelastic control capability where structural dynamics are included in the synthesis of flight control laws. Studies have indicated that the application of an integrated flight and aeroelastic control approach to a SensorCraft high-altitude long-endurance vehicle would provide substantial performance improvement(1,2). Better flying qualities and an expanded flight envelope through multi-flutter mode control are two areas of improvement afforded by integrated flight and aeroelastic control. By itself, multi-flutter mode control transforms the flutter barrier from a point of catastrophic structural failure to a benign region of flight. This paper discusses the history and issues associated with the development of such an integrated flight and aeroelastic control system for the X-56A aircraft.

Automatic Flight Control of Unmanned Helicopter Based on Nonlinear Model

2012 ◽  
Vol 472-475 ◽  
pp. 1492-1499
Author(s):  
Run Xia Guo
Keyword(s):  
Nonlinear Model ◽  
Flight Control ◽  
Attitude Control ◽  
Lyapunov Stability Theory ◽  
Test Results ◽  
Unmanned Helicopter ◽  
Control Laws ◽  
Control Approach ◽  
State Dependent ◽  
Compensation Technique

The Unmanned helicopter (UMH) movement was divided into two parts, namely, attitude and trajectory motion. And then a two-timescale nonlinear model was established. The paper improved and expanded state dependent riccati equation (SDRE) control approach, deriving analytical conditions for achieving global asymptotic stability with lyapunov stability theory. Proof was given. By combining improved SDRE control with nonlinear feed-forward compensation technique, the full envelop flight attitude control laws could be designed. On the basis of attitude control, trajectory controller was developed. Actual flight tests were carried out. Test results show that the control strategy is highly effective.

scholarly journals Sliding Mode Control for Mass Moment Aerospace Vehicles Using Dynamic Inversion Approach

2013 ◽  
Vol 2013 ◽  
pp. 1-11 ◽  
Author(s):  
Xiao-Yu Zhang ◽  
Yu-Xin Zhao ◽  
De-Xin Xu ◽  
Kun-Peng He
Keyword(s):  
Sliding Mode Control ◽  
Flight Control ◽  
Sliding Mode ◽  
Moving Mass ◽  
Aerodynamic Parameter ◽  
Aerospace Vehicles ◽  
Variable Structure Systems ◽  
Control Approach ◽  
Mode Control ◽  
Mass Moment

The moving mass actuation technique offers significant advantages over conventional aerodynamic control surfaces and reaction control systems, because the actuators are contained entirely within the airframe geometrical envelope. Modeling, control, and simulation of Mass Moment Aerospace Vehicles (MMAV) utilizing moving mass actuators are discussed. Dynamics of the MMAV are separated into two parts on the basis of the two time-scale separation theory: the dynamics of fast state and the dynamics of slow state. And then, in order to restrain the system chattering and keep the track performance of the system by considering aerodynamic parameter perturbation, the flight control system is designed for the two subsystems, respectively, utilizing fuzzy sliding mode control approach. The simulation results describe the effectiveness of the proposed autopilot design approach. Meanwhile, the chattering phenomenon that frequently appears in the conventional variable structure systems is also eliminated without deteriorating the system robustness.

Design of Dynamic Inversion and Explicit Model Following Flight Control Laws for Quadrotor UAS

2020 ◽  
Vol 65 (3) ◽  
pp. 1-16
Author(s):  
Umberto Saetti ◽  
Joseph F. Horn ◽  
Sagar Lakhmani ◽  
Constantino Lagoa ◽  
Tom F. Berger
Keyword(s):  
Flight Control ◽  
Flight Test ◽  
Parametric Model ◽  
Unmanned Aerial Systems ◽  
Model Parameters ◽  
Dynamic Inversion ◽  
Explicit Model ◽  
Control Laws ◽  
Model Following ◽  
Novel Approach

The objectives of this paper are to advance dynamic inversion (DI) and explicit model following (EMF) flight control laws for quadrotor unmanned aerial systems (UAS) and to develop an efficient strategy to compute the stability and performance robustness statistics of such control laws given parametric model uncertainty. For this purpose, a parametric model of a quadrotor is identified from flight-test data. The identified model is validated both in frequency and time domains. Next, DI and EMF flight control laws are designed for both inner attitude and outer velocity loops. Finally, a novel approach based on an unscented transform is used to evaluate the statistics of the controller's performance based on the statistics of the uncertain model parameters.

Preliminary parameters design for a long endurance unmanned helicopter with low rotor-disc loading

2020 ◽  
pp. 095441002097389
Author(s):  
Hong Zhao ◽  
Jian-Bo Li ◽  
Yuan Wang ◽  
Zhi-Gang Wang
Keyword(s):  
Flight Control ◽  
Evaluation Model ◽  
Load Ratio ◽  
Collaborative Optimization ◽  
Flight Performance ◽  
Unmanned Helicopter ◽  
Handling Qualities ◽  
Flying Qualities ◽  
Long Endurance ◽  
Quality Evaluation Model

This paper investigates the design of a long-endurance unmanned helicopter (LEUH) with low rotor disc loading (LRDL) and low rotor speed (LRS). Due to the flaws in flying qualities caused by the LRDL and the LRS, this paper establishes a flying quality evaluation model in which handling qualities (FQs) and flight control (FC) are introduced into the distributed multi-objective collaborative optimization (DMOCO) of the helicopters. The comprehensive design optimization on preliminary parameters of the LEUH in wind shear is also carried out. Numerical simulation results show that the LRDL and the LRS technologies are successfully applied to LEUH, with the FQs and the flight performance considered. Compared with A160 LEUH, the payload load ratio is significantly improved.

Stalling transport aircraft

2013 ◽  
Vol 117 (1198) ◽  
pp. 1183-1206 ◽  
Author(s):  
P. J. Bolds-Moorehead ◽  
V. G. Chaney ◽  
T. Lutz ◽  
S. Vaux
Keyword(s):  
Wind Tunnel ◽  
Flight Control ◽  
Flight Test ◽  
High Angle ◽  
Flight Testing ◽  
Control Laws ◽  
Transport Aircraft ◽  
Wind Tunnel Data ◽  
Predictive Validation ◽  
Flight Deck

Abstract Airbus and Boeing are cooperatively presenting this topic dealing with transport aircraft stalls. The paper will begin by defining a stall, followed by a review of requirements, predictive validation and flight testing. There are various ways of designing modern jet transports for the stall regime such as aerodynamic approaches, flight deck indications, and augmentation control laws to deal with the high angle-of-attack (α) arena. The goal of augmented control laws for high α is common – no full aerodynamic stall or loss of climb performance should occur in the operational flight envelope, in Normal flight control modes. The validation techniques employed in preparation for a flight test campaign will follow. These include flight characteristic predictions based on wind-tunnel data as well as pilot-in-the-loop simulation rehearsals. The preparation for flight testing will be reviewed from both the engineer and pilot viewpoints. This will be followed by a review of various flight testing that has been conducted. The paper will close with a brief foray into what the future of transport stalls could be – perhaps protection features in degraded flight control modes? What are the benefits as well as drawbacks to increased augmentation for high α?

scholarly journals Historical Overview of Research in Reconfigurable Flight Control

2005 ◽  
Vol 219 (4) ◽  
pp. 263-275 ◽  
Author(s):  
M Steinberg
Keyword(s):  
Intelligent Control ◽  
Flight Control ◽  
Flight Test ◽  
Historical Overview ◽  
Reconfigurable Control ◽  
Control Laws ◽  
Loop Control ◽  
Software Algorithms ◽  
Lifting Surfaces ◽  
Initial Research

This article presents a historical overview of research in reconfigurable flight control. For the purpose of this article, the term ‘reconfigurable flight control’ is used to refer to software algorithms designed specifically to compensate for failures or damage of flight control effectors or lifting surfaces, using the remaining effectors to generate compensating forces and moments. This article will discuss initial research and flight testing of approaches based on explicit fault detection, isolation, and estimation, as well as later approaches based on continuously adaptive and intelligent control algorithms. In addition, approaches for trajectory reshaping of an impaired aircraft with reconfigurable inner loop control laws will be briefly discussed. Finally, there will be some discussion on current implementations of reconfigurable control to improve safety on production and flight test aircraft and remaining challenges to enable broader use of the technology, such as the difficulties of flight certification of these types of approaches.

scholarly journals Inflight investigation of the effects of rotor state measurement and feedback on variable stability helicopters

2021 ◽  
Author(s):  
Marc David Alexander
Keyword(s):  
Flight Control ◽  
National Research Council ◽  
Likelihood Estimation ◽  
Flight Test ◽  
Flight Simulation ◽  
Tracking Accuracy ◽  
Response Dynamics ◽  
Control Laws ◽  
Systems Research ◽  
Model Following Control

This thesis describes a flight test evaluation of flight control laws applying rotor state measurements and feedback on the National Research Council Bell 412 Advanced Systems Research Aircraft (ASRA) and Bell 205A Airborne Simulator (AS). Parameter estimation of a higher-order mathematical model of the ASRA rotor dynamics was achieved by Maximum Likelihood Estimation (MLE) employing coupled rotor-body equations parameterized by explicit rotor and fuselage state measurements. Root Locus (RLM), Classical Multivariable (CMC), Eigenstructure Assignment (EAC), and Model Following control algorithms were implemented in Matlab/Simulink simulation for analysis of coupled rotor-body dynamics. Rotorcraft performance specifications were based on compliance with ADS-33E-PRF and Cooper Harper military handling qualities. Evaluated in desk-top and in-flight simulation, rotor state feedback of longitudinal and lateral disc tilt dynamics by modern multivariable control significantly improves inter-axis decoupling, disturbance rejection characteristics, rotor response dynamics, command tracking accuracy, and rigid-body bandwidth performance.

Sign in / Sign up

Export Citation Format

Share Document