Higher eigenstates in boundary-layer stability theory

1976 ◽  
Vol 77 (1) ◽  
pp. 81-104 ◽  
Author(s):  
D. Corner ◽  
D. J. R. Houston ◽  
M. A. S. Ross
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Stability Theory ◽  
Free Stream ◽  
Angular Frequency ◽  
Boundary Layer Stability ◽  
Fundamental State ◽  
Blasius Boundary Layer ◽  
The Stability ◽  
Sommerfeld Equation

Using the Orr-Sommerfeld equation with the wavenumber as the eigenvalue, a search for higher eigenstates in the stability theory of the Blasius boundary layer has revealed the existence of a number of viscous states in addition to the long established fundamental state. The viscous states are discrete, belong to two series, and are all heavily damped in space. Within the limits of the investigation the number of viscous states existing in the layer increases as the Reynolds number and the angular frequency of the perturbation increase. It is suggested that the viscous eigenstates may be responsible for the excitation of some boundary-layer disturbances by disturbances in the free stream.

Estimating amplitude ratios in boundary layer stability theory: a comparison between two approaches

2001 ◽  
Vol 439 ◽  
pp. 403-412 ◽  
Author(s):  
RAMA GOVINDARAJAN ◽  
R. NARASIMHA
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Small Difference ◽  
Detailed Comparison ◽  
The Other ◽  
Boundary Layer Stability ◽  
Mean Flow ◽  
Amplitude Ratios ◽  
The Stability ◽  
Local Reynolds Number

We first demonstrate that, if the contributions of higher-order mean flow are ignored, the parabolized stability equations (Bertolotti et al. 1992) and the ‘full’ non-parallel equation of Govindarajan & Narasimha (1995, hereafter GN95) are both equivalent to order R−1 in the local Reynolds number R to Gaster's (1974) equation for the stability of spatially developing boundary layers. It is therefore of some concern that a detailed comparison between Gaster (1974) and GN95 reveals a small difference in the computed amplitude ratios. Although this difference is not significant in practical terms in Blasius flow, it is traced here to the approximation, in Gaster's method, of neglecting the change in eigenfunction shape due to flow non-parallelism. This approximation is not justified in the critical and the wall layers, where the neglected term is respectively O(R−2/3) and O(R−1) compared to the largest term. The excellent agreement of GN95 with exact numerical simulations, on the other hand, suggests that the effect of change in eigenfunction is accurately taken into account in that paper.

The Stability of Water Flow Over Heated and Cooled Flat Plates

1968 ◽  
Vol 90 (1) ◽  
pp. 109-114 ◽  
Author(s):  
Ahmed R. Wazzan ◽  
T. Okamura ◽  
A. M. O. Smith
Keyword(s):  
Reynolds Number ◽  
Critical Reynolds Number ◽  
Free Stream ◽  
Reynolds Numbers ◽  
Stream Temperature ◽  
Heated Wall ◽  
Flat Plates ◽  
Critical Reynolds Numbers ◽  
The Stability ◽  
Sommerfeld Equation

The theory of two-dimensional instability of laminar flow of water over solid surfaces is extended to include the effects of heat transfer. The equation that governs the stability of these flows to Tollmien-Schlichting disturbances is the Orr-Sommerfeld equation “modified” to include the effect of viscosity variation with temperature. Numerical solutions to this equation at high Reynolds numbers are obtained using a new method of integration. The method makes use of the Gram-Schmidt orthogonalization technique to obtain linearly independent solutions upon numerically integrating the “modified Orr-Sommerfeld” equation using single precision arithmetic. The method leads to satisfactory answers for Reynolds numbers as high as Rδ* = 100,000. The analysis is applied to the case of flow over both heated and cooled flat plates. The results indicate that heating and cooling of the wall have a large influence on the stability of boundary-layer flow in water. At a free-stream temperature of 60 deg F and wall temperatures of 60, 90, 120, 135, 150, 200, and 300deg F, the critical Reynolds numbers Rδ* are 520, 7200, 15200, 15600, 14800, 10250, and 4600, respectively. At a free-stream temperature of 200F and wall temperature of 60 deg F (cooled case), the critical Reynolds number is 151. Therefore, it is evident that a heated wall has a stabilizing effect, whereas a cooled wall has a destabilizing effect. These stability calculations show that heating increases the critical Reynolds number to a maximum value (Rδ* max = 15,700 at a temperature of TW = 130 deg F) but that further heating decreases the critical Reynolds number. In order to determine the influence of the viscosity derivatives upon the results, the critical Reynolds number for the heated case of T∞ = 40 and TW = 130 deg F was determined using (a) the Orr-Sommerfeld equation and (b) the present governing equation. The resulting critical Reynolds numbers are Rδ* = 140,000 and 16,200, respectively. Therefore, it is concluded that the terms pertaining to the first and second derivatives of the viscosity have a considerable destabilizing influence.

scholarly journals Stability of highly cooled hypervelocity boundary layers

2015 ◽  
Vol 778 ◽  
pp. 586-620 ◽  
Author(s):  
N. P. Bitter ◽  
J. E. Shepherd
Keyword(s):  
Boundary Layer ◽  
Boundary Layers ◽  
Wall Temperature ◽  
Free Stream ◽  
Boundary Layer Stability ◽  
High Enthalpy ◽  
Wide Range ◽  
Second Mode ◽  
High Mach ◽  
The Stability

The influence of high levels of wall cooling on the stability of hypervelocity boundary layers is investigated. Such conditions are relevant to experiments in high-enthalpy impulse facilities, where the wall temperature is much smaller than the free-stream temperature, as well as to some real flight scenarios. Some effects of wall cooling are well known, for instance, the stabilization of the first mode and destabilization of the second mode. In this paper, several new instability phenomena are investigated that arise only for high Mach numbers and high levels of wall cooling. In particular, certain unstable modes can travel supersonically with respect to the free stream, which changes the nature of the dispersion curve and leads to instability over a much wider band of frequencies. The cause of this phenomenon, the range of parameters for which it occurs and its implications for boundary layer stability are examined. Additionally, growth rates are systematically reported for a wide range of conditions relevant to high-enthalpy impulse facilities, and the stability trends in terms of Mach number and wall temperature are mapped out. Thermal non-equilibrium is included in the analysis and its influence on the stability characteristics of flows in impulse facilities is assessed.

On the instability of flow in a streamwise corner

1993 ◽  
Vol 441 (1911) ◽  
pp. 201-210 ◽  
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Outer Boundary ◽  
Cross Flow ◽  
Downstream Distance ◽  
Blasius Boundary Layer ◽  
Flow Approximation ◽  
Wave Angle ◽  
The Stability ◽  
Spanwise Location

The linear stability of an incompressible laminar flow in the blending boundary layer between the boundary layer in a 90° streamwise corner and a Blasius boundary layer well away from the corner is examined using a locally parallel flow approximation. It is shown that the magnitude of the cross flow in the boundary layer is too small to be a significant factor in the observed early transition in the blending layer. However, the influence of the outer boundary conditions associated with oblique modes of disturbances which are anti-symmetric about the bisector plane are shown to have a profound effect on the stability of the flow. As a result, the square root of the critical streamwise Reynolds number R er , associated with a spanwise location is significantly reduced as the corner is approached, being R er = 54 approximately for spanwise distance of z * = 6 x * R -1 from the corner compared with R er = 322 approximately for z * = 20 x * R -1 , where x * measures downstream distance from the leading edges and R 2 is the streamwise Reynolds number. At R = 600, the growth rate of the most amplified mode of disturbance at the former location is over six times greater than that at the latter; the corresponding wave angle at the two locations is respectively 44° and 5°, approximately.

Influence of viscosity temperature dependence on the spectral characteristics of the thermoviscous liquids flow stability equation

2019 ◽  
Vol 14 (1) ◽  
pp. 52-58 ◽  
Author(s):  
A.D. Nizamova ◽  
V.N. Kireev ◽  
S.F. Urmancheev
Keyword(s):  
Reynolds Number ◽  
Spectral Characteristics ◽  
Wave Number ◽  
Critical Parameters ◽  
Fluid Viscosity ◽  
Flat Channel ◽  
Stability Equation ◽  
The Stability ◽  
Thermoviscous Fluid ◽  
Sommerfeld Equation

The flow of a viscous model fluid in a flat channel with a non-uniform temperature field is considered. The problem of the stability of a thermoviscous fluid is solved on the basis of the derived generalized Orr-Sommerfeld equation by the spectral decomposition method in Chebyshev polynomials. The effect of taking into account the linear and exponential dependences of the fluid viscosity on temperature on the spectral characteristics of the hydrodynamic stability equation for an incompressible fluid in a flat channel with given different wall temperatures is investigated. Analytically obtained profiles of the flow rate of a thermovisible fluid. The spectral pictures of the eigenvalues of the generalized Orr-Sommerfeld equation are constructed. It is shown that the structure of the spectra largely depends on the properties of the liquid, which are determined by the viscosity functional dependence index. It has been established that for small values of the thermoviscosity parameter the spectrum compares the spectrum for isothermal fluid flow, however, as it increases, the number of eigenvalues and their density increase, that is, there are more points at which the problem has a nontrivial solution. The stability of the flow of a thermoviscous fluid depends on the presence of an eigenvalue with a positive imaginary part among the entire set of eigenvalues found with fixed Reynolds number and wavenumber parameters. It is shown that with a fixed Reynolds number and a wave number with an increase in the thermoviscosity parameter, the flow becomes unstable. The spectral characteristics determine the structure of the eigenfunctions and the critical parameters of the flow of a thermally viscous fluid. The eigenfunctions constructed in the subsequent works show the behavior of transverse-velocity perturbations, their possible growth or decay over time.

Stability of Flat Plate Boundary Layer Over Compliant Coating with Increased Rigidity

2011 ◽  
Vol 6 (4) ◽  
pp. 25-41
Author(s):  
Andrey Boiko ◽  
Viktor Kulik ◽  
V. Filimonov
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Viscoelastic Properties ◽  
Loss Factor ◽  
Plate Boundary ◽  
Single Layer ◽  
Interface Conditions ◽  
Compliant Coating ◽  
Blasius Boundary Layer ◽  
Flat Plate Boundary Layer

In the paper the results of hydrodynamic stability computations for Blasius boundary layer over single-layer compliant coatings in the framework of complete (in respect to interface conditions) linear quasi-parallel approach are presented. Data on viscoelastic properties (elastic modulus and loss factor) of the coatings as functions of frequency obtained in a series of special experiments were used. A range of the coating parameters, which provide a compromise between their rigidity and intensity of interaction with the flow, was determined. Based on en -method, estimations of the transition Reynolds number were done

Free-stream coherent structures in parallel boundary-layer flows

2014 ◽  
Vol 752 ◽  
pp. 602-625 ◽  
Author(s):  
Kengo Deguchi ◽  
Philip Hall
Keyword(s):  
Boundary Layer ◽  
Reynolds Number ◽  
Coherent Structures ◽  
Free Stream ◽  
Stokes Equations ◽  
Navier Stokes ◽  
Homotopy Continuation ◽  
Boundary Layer Flows ◽  
Navier Stokes Equations ◽  
High Reynolds

AbstractOur concern in this paper is with high-Reynolds-number nonlinear equilibrium solutions of the Navier–Stokes equations for boundary-layer flows. Here we consider the asymptotic suction boundary layer (ASBL) which we take as a prototype parallel boundary layer. Solutions of the equations of motion are obtained using a homotopy continuation from two known types of solutions for plane Couette flow. At high Reynolds numbers, it is shown that the first type of solution takes the form of a vortex–wave interaction (VWI) state, see Hall & Smith (J. Fluid Mech., vol. 227, 1991, pp. 641–666), and is located in the main part of the boundary layer. On the other hand, here the second type is found to support an equilibrium solution of the unit-Reynolds-number Navier–Stokes equations in a layer located a distance of $\def \xmlpi #1{}\def \mathsfbi #1{\boldsymbol {\mathsf {#1}}}\let \le =\leqslant \let \leq =\leqslant \let \ge =\geqslant \let \geq =\geqslant \def \Pr {\mathit {Pr}}\def \Fr {\mathit {Fr}}\def \Rey {\mathit {Re}}O(\ln \mathit{Re})$ from the wall. Here $\mathit{Re}$ is the Reynolds number based on the free-stream speed and the unperturbed boundary-layer thickness. The streaky field produced by the interaction grows exponentially below the layer and takes its maximum size within the unperturbed boundary layer. The results suggest the possibility of two distinct types of streaky coherent structures existing, possibly simultaneously, in disturbed boundary layers.

Influence The Direction Of Blowing Gas Through A Porous Surface On The Stability Of The Supersonic Boundary Layer

2015 ◽  
Vol 10 (2) ◽  
pp. 18-26
Author(s):  
Sergey Gaponov ◽  
Aleksandr Semenov
Keyword(s):  
Boundary Layer ◽  
Classical Method ◽  
Supersonic Boundary Layer ◽  
Porous Surface ◽  
Boundary Layer Stability ◽  
Injection Angle ◽  
Plane Plate ◽  
The Stability ◽  
Gas Blowing ◽  
Elementary Waves

In the paper the influence of the gas blowing direction through a porous surface on the supersonic boundary layer stability is investigated theoretically, using the classical method of elementary waves and the evolutionary method at Mach number M = 2. It was found that with decreasing of the gas injection angle to the plane plate the boundary layer stability was improved and the tangential blowing effect on the boundary layer stability is little in a comparison with the case of a boundary layer without mass exchange.

Sign in / Sign up

Export Citation Format

Share Document