Spectroelectrochemical Sensing Based on Multimode Selectivity Simultaneously Achievable in a Single Device. 9. Incorporation of Planar Waveguide Technology

2000 ◽  
Vol 72 (22) ◽  
pp. 5549-5555 ◽  
Author(s):  
Susan E. Ross ◽  
Carl J. Seliskar ◽  
William R. Heineman
Keyword(s):  
Planar Waveguide ◽  
Spectroelectrochemical Sensing

191. Planar Waveguide Interferometers for Vapor Phase Sensing

1999 ◽  
Author(s):  
C. Joseph ◽  
D. Campbell ◽  
J. Suggs ◽  
J. Moore ◽  
N. Hartman
Keyword(s):  
Vapor Phase ◽  
Planar Waveguide

Excitation mode-dependent terahertz radiation generation from a sub-wavelength Si-SiO2-LiNbO3-polymer-Si planar waveguide

2021 ◽  
pp. 1-1
Author(s):  
Brett N Carnio ◽  
Basem Shahriar ◽  
Eric Hopmann ◽  
Abdulhakem Y Elezzabi
Keyword(s):  
Terahertz Radiation ◽  
Planar Waveguide ◽  
Excitation Mode ◽  
Radiation Generation ◽  
Sub Wavelength

scholarly journals A Review on Improved Design Techniques for High Performance Planar Waveguide Slot Arrays

Electronics ◽  
2021 ◽  
Vol 10 (11) ◽  
pp. 1311
Author(s):  
Giovanni Andrea Casula ◽  
Giuseppe Mazzarella ◽  
Giorgio Montisci ◽  
Giacomo Muntoni
Keyword(s):  
Planar Waveguide ◽  
High Performance ◽  
Order Effects ◽  
Waveguide Slot ◽  
Waveguide Bends ◽  
Radar Systems ◽  
Slot Arrays ◽  
Planar Array ◽  
Improved Design ◽  
Design Techniques

Planar waveguide slot arrays (WSAs) have been used since 1940 and are currently used as performing antennas for high frequencies, especially in applications such as communication and RADAR systems. We present in this work a review of the most typical waveguide slot array configurations proposed in the literature, describing their main limitations and drawbacks along with possible effective countermeasures. Our attention has been focused mainly on the improved available design techniques to obtain high performance WSAs. In particular, the addressed topics have been reported in the following. Partially filled WSAs, or WSAs covered with single or multilayer dielectric slabs, are discussed. The most prominent second-order effects in the planar array feeding network are introduced and accurately modeled. The attention is focused on the T-junction feeding the array, on the effect of interaction between each slot coupler of the feeding network and the radiating slots nearest to this coupler, and on the waveguide bends. All these effects can critically increase the first sidelobes if compared to the ideal case, causing a sensible worsening in the performance of the array.

Fluorescence-based planar waveguide biosensors

1999 ◽  
Author(s):  
Gert L. Duveneck
Keyword(s):  
Planar Waveguide

scholarly journals Development of a Temperature-Controlled Optical Planar Waveguide Sensor with Lossy Mode Resonance for Refractive Index Measurement

Photonics ◽  
2021 ◽  
Vol 8 (6) ◽  
pp. 199
Author(s):  
Yu-Cheng Lin ◽  
Liang-Yü Chen
Keyword(s):  
Refractive Index ◽  
Optical Fiber ◽  
Temperature Control ◽  
Planar Waveguide ◽  
Metallic Oxide ◽  
Refractive Index Measurement ◽  
Index Measurement ◽  
Temperature Controlled ◽  
Optical Planar Waveguide ◽  
Active Temperature

The generation of lossy mode resonances (LMR) with a metallic oxide film deposited on an optical fiber has attracted the attention of many applications. However, an LMR-based optical fiber sensor is frangible, and therefore it does not allow control of the temperature and is not suited to mass production. This paper aims to develop a temperature-controlled lossy mode resonance (TC-LMR) sensor on an optical planar waveguide with an active temperature control function in which an ITO film is not only used as the LMR resonance but also to provide the heating function to achieve the benefits of compact size and active temperature control. A simple flat model about the heat transfer mechanism is proposed to determine the heating time constant for the applied voltages. The TC-LMR sensor is evaluated experimentally for refractive index measurement using a glycerol solution. The heating temperature functions relative to the controlled voltages for water and glycerol are obtained to verify the performance of the TC-LMR sensor. The TC-LMR sensor is a valuable sensing device that can be used in clinical testing and point of care for programming heating with precise temperature control.

Current-induced guiding and beam steering in active semiconductor planar waveguide

1999 ◽  
Vol 11 (7) ◽  
pp. 809-811 ◽  
Author(s):  
Xuesong Dong ◽  
P. LiKamWa ◽  
J. Loehr ◽  
R. Kaspi
Keyword(s):  
Planar Waveguide ◽  
Beam Steering

Polarization properties of a fiber-to-asymmetric planar waveguide coupler

1994 ◽  
Vol 12 (6) ◽  
pp. 983-988 ◽  
Author(s):  
K.P. Panajotov
Keyword(s):  
Planar Waveguide ◽  
Waveguide Coupler

Distributed coupling between a single-mode fiber and a planar waveguide

1994 ◽  
Vol 11 (5) ◽  
pp. 826 ◽  
Author(s):  
Krassimir P. Panajotov ◽  
Andrej Tz. Andreev
Keyword(s):  
Planar Waveguide ◽  
Single Mode ◽  
Single Mode Fiber

scholarly journals Nonclassical-light generation in a photonic-band-gap nonlinear planar waveguide

2004 ◽  
Vol 70 (4) ◽  
Author(s):  
Jan Peřina ◽  
Concita Sibilia ◽  
Daniela Tricca ◽  
Mario Bertolotti
Keyword(s):  
Band Gap ◽  
Planar Waveguide ◽  
Photonic Band Gap ◽  
Nonclassical Light ◽  
Light Generation ◽  
Photonic Band

Efficient multiline nanosecond pulse amplification in planar waveguide CO_2 amplifier for extreme UV laser-produced plasma source

2014 ◽  
Vol 39 (7) ◽  
pp. 1953 ◽  
Author(s):  
Krzysztof M. Nowak ◽  
Takeshi Ohta ◽  
Takashi Suganuma ◽  
Junichi Fujimoto ◽  
Hakaru Mizoguchi ◽  
...  
Keyword(s):  
Planar Waveguide ◽  
Plasma Source ◽  
Nanosecond Pulse ◽  
Uv Laser ◽  
Pulse Amplification ◽  
Laser Produced Plasma ◽  
Extreme Uv
Sign in / Sign up

Export Citation Format

Share Document