Exhaustive oxidation of a nickel dithiolate complex: some mechanistic insights en route to sulfate formation

2012 ◽  
Vol 41 (3) ◽  
pp. 804-816 ◽  
Author(s):  
Erik R. Hosler ◽  
Robert W. Herbst ◽  
Michael J. Maroney ◽  
Balwant S. Chohan
1986 ◽  
Vol 39 (5) ◽  
pp. 757 ◽  
Author(s):  
DN Furlong ◽  
D Wells ◽  
WHF Sasse

The photooxidation of ethylenediaminetetraacetic acid ( edta ) and related glycine derivatives, at Pt/TiO2/aqueous solution interfaces, has been monitored via the production of hydrogen and carbon dioxide. Yields are consistent with the exhaustive oxidation of methoxycarbonyl groups and the rate varied with the number and distribution of such groups. A photooxidation pathway is proposed which involves the oxidation of intermediate carbonium ions. Plausible molecular intermediates, such as formic acid and formaldehyde in the case of edta , have been shown in separate experiments to be photooxidized according to the proposed pathway. The maximum rate of oxidation for each donor depends on its oxidation potential and its tendency to adsorb on TiO2 surfaces. Desorption due to pH increase, as well as consumption of the donor, causes the rate to decline rapidly with illumination time. Acetic and malonic acids gave some hydrogen but underwent mainly (> c. 80%) photo-Kolbe decarboxylation to yield carbon dioxide and methane. By contrast the oxidation of oxomalonic, pyruvic and lactic acids proceeded mainly via a H2 producing pathway similar to that established for edta. The oxidation of pyruvic and lactic acids ceased at a yield of one mole of CO2 per mole of acid.


1989 ◽  
Vol 151 (3) ◽  
pp. 232-237 ◽  
Author(s):  
Michael Kr�mer ◽  
Heribert Cypionka

2012 ◽  
Vol 58 ◽  
pp. 23-34 ◽  
Author(s):  
C.H. Song ◽  
J.E. Nam ◽  
K.M. Han ◽  
M.K. Lee ◽  
J.H. Woo ◽  
...  

2017 ◽  
Author(s):  
Zechen Yu ◽  
Myoseon Jang ◽  
Jiyeon Park

Abstract. The photocatalytic ability of airborne mineral dust particles is known to heterogeneously promote SO2 oxidation, but prediction of this phenomenon is not fully taken into account by current models. In this study, the Atmospheric Mineral Aerosol Reaction (AMAR) model was developed to capture the influence of air-suspended mineral dust particles on sulfate formation in various environments. In the model, SO2 oxidation proceeds in three phases including the gas phase, the inorganic-salted aqueous phase (non-dust phase), and the dust phase. Dust chemistry is described as the adsorption-desorption kinetics (gas-particle partitioning) of SO2 and NOx. The reaction of adsorbed SO2 on dust particles occurs via two major paths: autoxidation of SO2 in open air and photocatalytic mechanisms under UV light. The kinetic mechanism of autoxidation was first leveraged using controlled indoor chamber data in the presence of Arizona Test Dust (ATD) particles without UV light, and then extended to photochemistry. With UV light, SO2 photooxidation was promoted by surface oxidants (OH radicals) that are generated via the photocatalysis of semiconducting metal oxides (electron–hole theory) of ATD particles. This photocatalytic rate constant was derived from the integration of the combinational product of the dust absorbance spectrum and wave-dependent actinic flux for the full range of wavelengths of the light source. The predicted concentrations of sulfate and nitrate using the AMAR model agreed well with outdoor chamber data that were produced under natural sunlight. For seven consecutive hours of photooxidation of SO2 in an outdoor chamber, dust chemistry at the low NOx level was attributed to 70 % of total sulfate (60 ppb SO2, 290 μg m−3 ATD, and NOx less than 5 ppb). At high NOx (> 50 ppb of NOx with low hydrocarbons), sulfate formation was also greatly promoted by dust chemistry, but it was significantly suppressed by the competition between NO2 and SO2 that both consume the dust-surface oxidants (OH radicals or ozone). The AMAR model, derived in this study with ATD particles, will provide a platform for predicting sulfate formation in the presence of authentic dust particles (e.g. Gobi and Saharan dust).


2017 ◽  
Vol 737 ◽  
pp. 517-521 ◽  
Author(s):  
Victoriya Petropavlovskaya ◽  
Аleksandr Buryanov ◽  
Тatyana Novichenkova ◽  
Kirill Petropavlovskii

In this article the self-hardening structure of stone based on calcium sulfate formation is described. Increase of strength of gypsum is possible by additional reinforcing of a stone ettringite crystals. The form and character of the formed crystals is defined by size рН. Dependence рН from the maintenance of additives was investigated in work. The limiting factor of formation of crystals of an ettringite of a necessary look is the maintenance of an additive. In work gypsum composites with the improved physical-mechanical properties on the basis of the modifying complex are received and investigated.


2013 ◽  
Vol 75 ◽  
pp. 233-240 ◽  
Author(s):  
Andrea L. Clements ◽  
Birnur Buzcu-Guven ◽  
Matthew P. Fraser ◽  
Pranav Kulkarni ◽  
Shankararaman Chellam

Sign in / Sign up

Export Citation Format

Share Document