Electrical characterization and conductivity optimization of laser reduced graphene oxide on insulator using point-contact methods

RSC Advances ◽  
2016 ◽  
Vol 6 (52) ◽  
pp. 46231-46237 ◽  
Author(s):  
Carlos Marquez ◽  
Noel Rodriguez ◽  
Rafael Ruiz ◽  
Francisco Gamiz

The present work is focused on the electrical characterization of laser-assisted reduced graphene oxide by point-contact techniques and the optimization of its electrical conductivity.

2019 ◽  
Vol 966 ◽  
pp. 386-391
Author(s):  
Eka Suarso ◽  
Anna Zakiyatul Laila ◽  
Firsta Agung Setyawan ◽  
Mochamad Zainuri ◽  
Zaenal Arifin ◽  
...  

In this study an investigation has been conducted on the effect of reduced graphene oxide (rGO) coating on increasing the value of Lithium Ferro Phosphate (LFP) electrical conductivity. This coating process uses a variation of the mass ratio of LiFePO4/rGO by 90%:10%, 70%:20%, and 67%:33%. The LiFePO4 precursor was prepared using the sol-gel rute from the main commercial materials, namely Li2CO3 powder as a source of lithium ions, FeCl2.4H2O as a source of iron and NH4H2PO4 powder as a phosphate source. As for the coating used rGO extracted from coconut shell waste. The samples were calcined with temperature variations of 600°C, 650°C and 700°C in an argon environment for 10 hour. The phase purity and crystal structure of LiFePO4 were analyzed using XRD. The analysis of data from XRD was done using the the Match!, Rietica, and MAUD software. Based on the results of XRD analysis, LiFePO4 with high purity and good crystallinity was obtained when the sample was calcined at temperature of 700°C. The results of the MAUD analysis show that the best size of LiFePO4 crystal is 86,54 nm. LiFePO4/rGO nanocomposite was successfully synthesized by mechanical ultracentrifugation method. The characterization of the value of electrical conductivity, carried out using a four-point probe. The results show that the greater the percentage of rGO, the higher the value of electrical conductivity. The mass ratio of 67% LiFePO4 and 33% rGO shows an increment in good conductivity values, from the original order of 10-8 S/cm to the order of 10-4 S/cm.


2016 ◽  
Vol 39 (2) ◽  
pp. 543-550 ◽  
Author(s):  
TAPAS K GHOSH ◽  
SHIRSHENDU GOPE ◽  
DIPAK RANA ◽  
INDRANIL ROY ◽  
GUNJAN SARKAR ◽  
...  

Molecules ◽  
2019 ◽  
Vol 24 (23) ◽  
pp. 4247 ◽  
Author(s):  
Rita Petrucci ◽  
Isabella Chiarotto ◽  
Leonardo Mattiello ◽  
Daniele Passeri ◽  
Marco Rossi ◽  
...  

Natural methylxanthines, caffeine, theophylline and theobromine, are widespread biologically active alkaloids in human nutrition, found mainly in beverages (coffee, tea, cocoa, energy drinks, etc.). Their detection is thus of extreme importance, and many studies are devoted to this topic. During the last decade, graphene oxide (GO) and reduced graphene oxide (RGO) gained popularity as constituents of sensors (chemical, electrochemical and biosensors) for methylxanthines. The main advantages of GO and RGO with respect to graphene are the easiness and cheapness of synthesis, the notable higher solubility in polar solvents (water, among others), and the higher reactivity towards these targets (mainly due to – interactions); one of the main disadvantages is the lower electrical conductivity, especially when using them in electrochemical sensors. Nonetheless, their use in sensors is becoming more and more common, with the obtainment of very good results in terms of selectivity and sensitivity (up to 5.4 × 10−10 mol L−1 and 1.8 × 10−9 mol L−1 for caffeine and theophylline, respectively). Moreover, the ability of GO to protect DNA and RNA from enzymatic digestion renders it one of the best candidates for biosensors based on these nucleic acids. This is an up-to-date review of the use of GO and RGO in sensors.


2020 ◽  
Author(s):  
S. Veeresh ◽  
H. Ganesh ◽  
Y. S. Nagaraj ◽  
M. Vandana ◽  
S. P. Ashokkumar ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document