959. Kinetics and mechanism of bromination of phenol with bromine and iodine bromide in glacial acetic acid and carbon tetrachloride

Author(s):  
Lourdu M. Yeddanapalli ◽  
N. S. Gnanapragasam
2003 ◽  
Vol 81 (2) ◽  
pp. 156-160 ◽  
Author(s):  
Tian Zhu ◽  
Hou-min Chang ◽  
John F Kadla

A new method for the preparation of peroxymonophosphoric acid (H3PO5) has been developed. It utilizes a biphasic solution to moderate the vigorous reaction between phosphorous pentoxide (P2O5) and hydrogen peroxide (H2O2). P2O5 is suspended in carbon tetrachloride (CCl4), and concentrated H2O2 is slowly added while being vigorously stirred at low temperature. Careful control of the reaction temperature through the slow addition of H2O2 is critical. Using typical preparation conditions (P2O5:H2O2 = 0.5:1, H2O2 70 wt %, 2°C, 120–180 min), ~70% of the H2O2 is effectively converted to H3PO5. Increasing the concentration of H2O2, as well as the mole ratio of P2O5:H2O2, leads to an even higher % conversion of H2O2 to H3PO5. The addition of glacial acetic acid to the P2O5:H2O2 suspension at the end of the 120–180 min reaction (P2O5:H2O2:CH3COOH = 0.5:1:0.3) leads to the formation of peracetic acid in addition to H3PO5, and to an overall increase in the conversion ratio of total peroxy acids based on H2O2 (>95%).Key words: peroxymonophosphoric acid, synthesis, stability, conversion ratio.


1969 ◽  
Vol 22 (6) ◽  
pp. 1193 ◽  
Author(s):  
J Rajaram ◽  
JC Kuriacose

The phenomenon of catalytic maximum has been investigated in the bromination of p-bromophenol (ArH) using iodine and anhydrous aluminium chloride as catalysts. The effective catalysts have been shown to be iodine bromide in acetic acid and carbon tetrachloride media, and AlCl3,Br2 in acetic acid. A correlation between the ratio of the reactants at the catalytic maximum, and the order in the effective catalyst has been deduced and experimentally verified.


2008 ◽  
Vol 59 (1) ◽  
pp. 41-44
Author(s):  
Maria-Daniela Sofei ◽  
Maria Ilici ◽  
Valentin Badea ◽  
Carol Csunderlik ◽  
Vasile-Nicolae Bercean

The synthesis of 1H-3-aryl-7-ethoxycarbonyl-6-methyl-pyrazolo[5,1-c][1,2,4]triazoles (2) was carried out by cyclization of 1H-5-arylidenehydrazino-4-ethoxycarbonyl-3-methyl-pyrazoles (1) in the presence of bromine using glacial acetic acid as solvent and sodium acetate as base. The new nine obtained compounds were characterized by IR and NMR spectroscopy and mass spectrometry.


1979 ◽  
Vol 44 (8) ◽  
pp. 2330-2337 ◽  
Author(s):  
Jindřiška Maternová ◽  
Anastas A. Andreev ◽  
Dimitrii M. Shopov ◽  
Karel Setínek

It was found spectroscopically that cobalt(II) acetate dissolved in glacial acetic acid forms the octahedral complex [Co(OAc)2(HOAc)4] which in the presence of bromide ions gives the octahedral [Co(OAc)Br(HOAc)4] and tetrahedral bromo(acetate)cobalt(II) complexes with the higher number of Br- ions. When attached to an organic polymer cobalt(II) ions are bonded in the form of octahedral [Co(H2O)6]2+ cations which form with acetic acid similar complexes as in homogeneous phase and are able to coordinate one bromide ion. Drying the copolymer possessing octahedral hexaaquocobalt(II) cations leads to tetrahedral aquocomplexes which are solvated by gaseous acetic acid and converted into the acetate complexes with the liquid acid. The latter contain the acid in the inner coordination sphere and have tetrahedral symmetry.


Author(s):  
Prabal Boral ◽  
Atul K. Varma ◽  
Sudip Maity

AbstractFour coal samples from Jharia basin, India are treated with nitric acid in glacial acetic acid and aqueous media to find out the chemical, petrographic and spatial structure of the organic mass by X-ray diffraction (XRD) and Fourier Transform Infrared Spectroscopy (FTIR) techniques. X-ray parameters of coal like interlayer spacing (d002), crystallite size (Lc), aroamticity (fa), average number of aromatic layers (Nc), and coal rank (I26/I20) have been determined using profile-fitting software. Considerable variation is observed in treated coals in comparison to the demineralized coals. The d002 values of treated coals have increased in both the media showing increase in disordering of organic moieties. A linear relationship has been observed between d002 values with the volatile matter of the coals. Similarly, the d002 values show linear relationship with Cdmf contents for demineralized as well as for the treated coals in both the media. The Lc and Nc values have decreased in treated coals corresponding to demineralized coals. The present study shows that nitration in both the media is capable of removing the aliphatic side chains from the coals and aromaticity (fa) increases with increase in rank and shows a linear relationship with the vitrinite reflectance. The corresponding I26/I20 values are least for treated coals in glacial acetic acid medium followed by raw and then to treated coals in aqueous medium. FTIR studies show that coal arenes of the raw coals are converted into nitro-arenes in structurally modified coals (SMCs) in both the media, the corresponding bands at 1550–1490 and 1355–1315 cm−1 respectively. FTIR study confirms that nitration is the predominant phenomenon, though, oxidation and nitration phenomena takes place simultaneously during treatment with nitric acid to form SMCs. In comparison to raw coals, the SMCs show higher aromaticity and may be easily converted to coal derived products like activated carbon and specialty carbon materials.


Author(s):  
Xue Yang ◽  
Yongling Liu ◽  
Tao Chen ◽  
Nana Wang ◽  
Hongmei Li ◽  
...  

Abstract Separation of natural compounds directly from the crude extract is a challenging work for traditional column chromatography. In the present study, an efficient method for separation of three main compounds from the crude extract of Dracocephalum tanguticum has been successfully established by high-speed counter-current chromatography (HSCCC). The crude extract was directly introduced into HSCCC by using dimethyl sulfoxide as cosolvent. Ethyl acetate/n-butyl alcohol/0.3% glacial acetic acid (4: 1: 5, v/v) system was used and three target compounds with purity higher than 80% were obtained. Preparative HPLC was used for further purification and three target compounds with purity higher than 98% were obtained. The compounds were identified as chlorogenic acid, pedaliin and pedaliin-6″-acetate.


1972 ◽  
Vol 94 (4) ◽  
pp. 1247-1249 ◽  
Author(s):  
R. S. Schwartz ◽  
H. Yokokawa ◽  
E. W. Graham

Sign in / Sign up

Export Citation Format

Share Document