scholarly journals Modification of Wood with Monoethanolamino-borate by The Data of X-Ray Photoelectron Spectroscopy

2018 ◽  
Vol 196 ◽  
pp. 04005
Author(s):  
Irina Stepina ◽  
Irina Kotlyarova
Keyword(s):  
Particle Size ◽  
Photoelectron Spectroscopy ◽  
Model Compound ◽  
Hydrolytic Stability ◽  
Photoelectron Spectra ◽  
Wood Cellulose ◽  
Rapid Loss ◽  
X Ray ◽  
Wood Protection ◽  
Cellulose Materials

The difficulty of wood protection from biocorrosion and fire is due to the fact that modifiers in use are washed out from the surface of the substrate under the influence of environmental factors. This results in a rapid loss of the protective effect and other practically important wood characteristics caused by the modification. To solve this problem is the aim of our work. Here, monoethanolaminoborate is used as a modifier, where electron-donating nitrogen atom provides a coordination number equal to four to a boron atom, which determines the hydrolytic stability of the compounds formed. Alpha-cellulose ground mechanically to a particle size of 1 mm at most was used as a model compound for the modification. X-ray photoelectron spectra were recorded on the XSAM-800 spectrometer (Kratos, UK). Prolonged extraction of the modified samples preceded the registration of the photoelectron spectra to exclude the fixation of the modifier molecules unreacted with cellulose. As a result of the experiment, boron and nitrogen atoms were found in the modified substrate, which indicated the hydrolytic stability of the bonds formed between the modifier molecules and the substrate. Therefore monoethanolaminoborate can be considered as a non-extractable modifier for wood-cellulose materials.

scholarly journals Impact of high temperatures on aluminoceladonite studied by Mössbauer, Raman, X-ray diffraction and X-ray photoelectron spectroscopy

2021 ◽  
Author(s):  
Mariola Kądziołka-Gaweł ◽  
Maria Czaja ◽  
Mateusz Dulski ◽  
Tomasz Krzykawski ◽  
Magdalena Szubka
Keyword(s):  
Photoelectron Spectroscopy ◽  
Integral Intensity ◽  
Photoelectron Spectra ◽  
X Ray Diffraction ◽  
Structural Reorganization ◽  
Oh Groups ◽  
X Ray ◽  
Al Content ◽  
Integral Intensity Ratio ◽  
Higher Temperature

AbstractMössbauer, Raman, X-ray diffraction and X-ray photoelectron spectroscopies were used to examine the effects of temperature on the structure of two aluminoceladonite samples. The process of oxidation of Fe2+ to Fe3+ ions started at about 350 °C for the sample richer in Al and at 300 °C for the sample somewhat lower Al-content. Mössbauer results show that this process may be associated with dehydroxylation or even initiate it. The first stage of dehydroxylation takes place at a temperature > 350 °C when the adjacent OH groups are replaced with a single residual oxygen atom. Up to ~500 °C, Fe ions do not migrate from cis-octahedra to trans-octahedra sites, but the coordination number of polyhedra changes from six to five. This temperature can be treated as the second stage of dehydroxylation. The temperature dependence on the integral intensity ratio between bands centered at ~590 and 705 cm−1 (I590/I705) clearly reflects the temperature at which six-coordinated polyhedra are transformed into five-coordinated polyhedra. X-ray photoelectron spectra obtained in the region of the Si2p, Al2p, Fe2p, K2p and O1s core levels, highlighted a route to identify the position of Si, Al, K and Fe cations in a structure of layered silicates with temperature. All the measurements show that the sample with a higher aluminum content and a lower iron content in octahedral sites starts to undergo a structural reorganization at a relatively higher temperature than the less aluminum-rich sample does. This suggests that iron may perform an important role in the initiation of the dehydroxylation of aluminoceladonites.

scholarly journals Synthesis of Magnetic Ferrocene-Containing Polymer with Photothermal Effects for Rapid Degradation of Methylene Blue

Polymers ◽  
2021 ◽  
Vol 13 (4) ◽  
pp. 558
Author(s):  
Wenhui Zhu ◽  
Caiyun Zhang ◽  
Yali Chen ◽  
Qiliang Deng
Keyword(s):  
Methylene Blue ◽  
Photoelectron Spectroscopy ◽  
Room Temperature ◽  
Degradation Rate ◽  
Model Compound ◽  
Vibrating Sample Magnetometer ◽  
Simulated Sunlight ◽  
X Ray Diffraction ◽  
X Ray ◽  
Ft Ir

Photothermal materials are attracting more and more attention. In this research, we synthesized a ferrocene-containing polymer with magnetism and photothermal properties. The resulting polymer was characterized by Fourier-transform infrared (FT-IR), vibrating sample magnetometer (VSM), scanning electron microscope (SEM), energy dispersive X-ray spectroscopy (EDS), X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), and thermogravimetric analysis (TGA). Its photo-thermocatalytic activity was investigated by choosing methylene blue (MB) as a model compound. The degradation percent of MB under an irradiated 808 nm laser reaches 99.5% within 15 min, and the degradation rate is 0.5517 min−1, which is 145 times more than that of room temperature degradation. Under irradiation with simulated sunlight, the degradation rate is 0.0092 min−1, which is approximately 2.5 times more than that of room temperature degradation. The present study may open up a feasible route to degrade organic pollutants.

scholarly journals Characterization of Ti/SnO2 Interface by X-ray Photoelectron Spectroscopy

Nanomaterials ◽  
2022 ◽  
Vol 12 (2) ◽  
pp. 202
Author(s):  
Miranda Martinez ◽  
Anil R. Chourasia
Keyword(s):  
Photoelectron Spectroscopy ◽  
Room Temperature ◽  
Chemical Interaction ◽  
Photoelectron Spectra ◽  
X Ray ◽  
Increasing Trend ◽  
Substrate Temperatures ◽  
Beam Technique

The Ti/SnO2 interface has been investigated in situ via the technique of x-ray photoelectron spectroscopy. Thin films (in the range from 0.3 to 1.1 nm) of titanium were deposited on SnO2 substrates via the e-beam technique. The deposition was carried out at two different substrate temperatures, namely room temperature and 200 °C. The photoelectron spectra of tin and titanium in the samples were found to exhibit significant differences upon comparison with the corresponding elemental and the oxide spectra. These changes result from chemical interaction between SnO2 and the titanium overlayer at the interface. The SnO2 was observed to be reduced to elemental tin while the titanium overlayer was observed to become oxidized. Complete reduction of SnO2 to elemental tin did not occur even for the lowest thickness of the titanium overlayer. The interfaces in both the types of the samples were observed to consist of elemental Sn, SnO2, elemental titanium, TiO2, and Ti-suboxide. The relative percentages of the constituents at the interface have been estimated by curve fitting the spectral data with the corresponding elemental and the oxide spectra. In the 200 °C samples, thermal diffusion of the titanium overlayer was observed. This resulted in the complete oxidation of the titanium overlayer to TiO2 upto a thickness of 0.9 nm of the overlayer. Elemental titanium resulting from the unreacted overlayer was observed to be more in the room temperature samples. The room temperature samples showed variation around 20% for the Ti-suboxide while an increasing trend was observed in the 200 °C samples.

X-Ray photoelectron spectroscopy of monosubstituted perfluorobenzenes

1977 ◽  
Vol 55 (8) ◽  
pp. 1279-1284 ◽  
Author(s):  
Barry C. Trudell ◽  
S. James W. Price
Keyword(s):  
Gas Phase ◽  
Photoelectron Spectroscopy ◽  
Binding Energies ◽  
Photoelectron Spectra ◽  
Atomic Charges ◽  
X Ray ◽  
Sophisticated Analysis ◽  
Charge Calculations

The gas phase X-ray photoelectron spectra, XPS, were observed for the series C6F5X (X = F, Cl, I, Br, H). Binding energies were determined from the spectra using the ESCAPLOT Program. Charge calculations were carried out using Equalization of Electronegativity, CNDO/2, and ACHARGE approaches on each molecule. The more sophisticated analysis leads to the following equation correlating the (C 1s) binding energies and the atomic charges qi[Formula: see text]

ZnFe2O4 Modified by Fe(NO3)3 for the Synthesis of Ionic Ferrofluids

2010 ◽  
Vol 177 ◽  
pp. 32-36 ◽  
Author(s):  
An Rong Wang ◽  
Jian Li ◽  
Qing Mei Zhang ◽  
Hua Miao
Keyword(s):  
Particle Size ◽  
Magnetic Properties ◽  
Electron Microscope ◽  
Transmission Electron Microscope ◽  
Photoelectron Spectroscopy ◽  
Vibrating Sample Magnetometer ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Znfe2o4 Nanoparticles

Weak magnetic ZnFe2O4 nanoparticles were prepared by coprecipitation and treated with different concentrations of Fe(NO3)3 solution. Untreated and treated particles were studied using a vibrating sample magnetometer, transmission electron microscope, by X-ray diffraction, X-ray energy dispersive spectroscopy and X photoelectron spectroscopy. The results showed that, after treatment, the ZnFe2O4/γ-Fe2O3 forms disphase nanoparticles, with enlarged size, enhanced magnetic properties and with a surface parceled with Fe(NO3)3. The size of the particles and their magnetic properties are related to the concentration of the treatment solution. The particle size and magnetic properties could be controlled by controlling the concentration of treating solution, therefore nanoparticles can be more widely used.

Analytical measurement of microstickies on fibers by model surfaces

2014 ◽  
Vol 29 (2) ◽  
pp. 232-239 ◽  
Author(s):  
Xiaotang Du ◽  
Jeffery S. Hsieh
Keyword(s):  
Photoelectron Spectroscopy ◽  
Polyvinyl Acetate ◽  
Model Compound ◽  
International Association ◽  
Model Surface ◽  
Water Contact ◽  
X Ray ◽  
New Methods ◽  
Hydrophilic Nature ◽  
Model Surfaces

Abstract A silicon wafer coated with cellulose was prepared to measure the deposition of stickies on fibers and polyvinyl acetate (PVAc) suspension is prepared as the model compound. In addition, two methods, shear force and aeration, were used to induce the agglomeration and deposition of microstickies. The model surface was characterized by X-ray photoelectron spectroscopy (XPS) and water contact angle. The results from new methods were also compared with old methods of High-density polyethylene (HDPE) deposition and INGEDE (International Association of the Deinking Industry) Method 4. Although these methods have been used to predict the deposition of stickies onto the drying felt or other equipment, the deposition of stickies onto fibers can differ significantly due to the hydrophilic nature of the fibers. This is the first measurement method that could help to predict the deposition of stickies onto paper products, which has been shown to cause detrimental effects.

X-Ray Photoelectron Spectroscopic Studies of Palladium Dispersed on Carbon Surfaces Modified by Ion Beams and Plasmatic Oxidation

1995 ◽  
Vol 60 (3) ◽  
pp. 383-392 ◽  
Author(s):  
Zdeněk Bastl
Keyword(s):  
Binding Energy ◽  
Photoelectron Spectroscopy ◽  
Surface Coverage ◽  
Spectroscopic Studies ◽  
Core Level ◽  
Graphite Surface ◽  
Photoelectron Spectra ◽  
Surface Layers ◽  
X Ray ◽  
Core Level Binding Energy

The effects of ion bombardment and r.f. plasma oxidation of graphite surfaces on subsequent growth and electronic properties of vacuum deposited palladium clusters have been investigated by methods of X-ray photoelectron spectroscopy (XPS) and Auger electron spectroscopy with X-ray excitation (XAES). Due to the significantly increased density of surface defects on which the nucleation process occurs the bulk value of the Pd 3d core level binding energy is achieved at higher surface coverage by palladium on bombarded surfaces than on ordered graphite. Angle resolved photoelectron spectra of oxidized graphite surfaces reveal significant embedding of oxygen in graphite surface layers. The C 1s and O 1s photoelectron spectra are consistent with presence of two major oxygen species involving C-O and C=O type linkages which are not homogeneously distributed within the graphite surface layers. Two effects were observed on oxidized surfaces: an increase of palladium dispersion and interaction of the metal clusters with surface oxygen groups. Using the simple interpretation of the modified Auger parameter the relaxation and chemical shift contributions to the measured Pd core level shifts are estimated. In the region of low surface coverage by palladium the effect of palladium-oxygen interaction on Pd core level binding energy exceeds the effects of increased dispersity.

Sign in / Sign up

Export Citation Format

Share Document