The importance of a variable fibre packing density in modelling the tensile behaviour of single filament yarns

2020 ◽  
pp. 1-9
Author(s):  
Aurélien Sibellas ◽  
Morgan Rusinowicz ◽  
Jérôme Adrien ◽  
Damien Durville ◽  
Eric Maire
Keyword(s):  
Packing Density ◽  
Tensile Behaviour ◽  
Single Filament ◽  
Fibre Packing

Anchorfibers and the Topography of Junctional SR

1977 ◽  
Vol 35 ◽  
pp. 582-583
Author(s):  
James Junker ◽  
Joachim R. Sommer
Keyword(s):  
Sarcoplasmic Reticulum ◽  
Cardiac Muscle ◽  
Single Filament ◽  
Relaxation Cycle ◽  
10 Nm Filaments ◽  
Junctional Sarcoplasmic Reticulum

Junctional sarcoplasmic reticulum (JSR) in all its forms (extended JSR, JSR of couplings, corbular SR) in both skeletal and cardiac muscle is always located at the Z - I regions of the sarcomeres. The Z tubule is a tubule of the free SR (non-specialized SR) which is consistently located at the Z lines in cardiac muscle (1). Short connections between JSR and Z lines have been described (2), and bundles of filaments at Z lines have been seen in skeletal (3) and cardiac (4) muscle. In opossum cardiac muscle, we have seen bundles of 10 nm filaments stretching across interfibrillary spaces and adjacent myofibrils with extensions to the plasma- lemma in longitudinal (Fig. 1) and transverse (Fig. 2) sections. Only an occasional single filament is seen elsewhere along a sarcomere. We propose that these filaments represent anchor fibers that maintain the observed invariant topography of the free SR and JSR throughout the contraction-relaxation cycle.

The 3-Dimensional Molecular Structure of the Actin Filament Revisited

1985 ◽  
Vol 43 ◽  
pp. 480-481
Author(s):  
U. Aebi ◽  
R. Millonig ◽  
H. Salvo
Keyword(s):  
Actin Filament ◽  
Supramolecular Assembly ◽  
Specimen Preparation ◽  
X Ray Diffraction ◽  
Single Filament ◽  
X Ray ◽  
3 Dimensional ◽  
Filament Diameter ◽  
Preparation Conditions ◽  
Apparent Diameter

To date, most 3-D reconstructions of undecorated actin filaments have been obtained from actin filament paracrystal data (for refs, see 1,2). However, due to the fact that (a) the paracrystals may be several filament layers thick, and (b) adjacent filaments may sustantially interdigitate, these reconstructions may be subject to significant artifacts. None of these reconstructions has permitted unambiguous tracing or orientation of the actin subunits within the filament. Furthermore, measured values for the maximal filament diameter both determined by EM and by X-ray diffraction analysis, vary between 6 and 10 nm. Obviously, the apparent diameter of the actin filament revealed in the EM will critically depend on specimen preparation, since it is a rather flexible supramolecular assembly which can easily be bent or distorted. To resolve some of these ambiguities, we have explored specimen preparation conditions which may preserve single filaments sufficiently straight and helically ordered to be suitable for single filament 3-D reconstructions, possibly revealing molecular detail.

Low-Dielectric-Constant Materials for ULSI Interlayer-Dielectric Applications

MRS Bulletin ◽  
1997 ◽  
Vol 22 (10) ◽  
pp. 19-27 ◽  
Author(s):  
Wei William Lee ◽  
Paul S. Ho
Keyword(s):  
Packing Density ◽  
Propagation Delay ◽  
Single Chip ◽  
Crosstalk Noise ◽  
Metal Line ◽  
Total Delay ◽  
Interlayer Dielectric ◽  
Low Dielectric ◽  
Interconnect Delay ◽  
Interconnect Technology

Continuing improvement of microprocessor performance historically involves a decrease in the device size. This allows greater device speed, an increase in device packing density, and an increase in the number of functions that can reside on a single chip. However higher packing density requires a much larger increase in the number of interconnects. This has led to an increase in the number of wiring levels and a reduction in the wiring pitch (sum of the metal line width and the spacing between the metal lines) to increase the wiring density. The problem with this approach is that—as device dimensions shrink to less than 0.25 μm (transistor gate length)—propagation delay, crosstalk noise, and power dissipation due to resistance-capacitance (RC) coupling become significant due to increased wiring capacitance, especially interline capacitance between the metal lines on the same metal level. The smaller line dimensions increase the resistivity (R) of the metal lines, and the narrower interline spacing increases the capacitance (C) between the lines. Thus although the speed of the device will increase as the feature size decreases, the interconnect delay becomes the major fraction of the total delay and limits improvement in device performance.To address these problems, new materials for use as metal lines and interlayer dielectrics (ILD) as well as alternative architectures have been proposed to replace the current Al(Cu) and SiO2 interconnect technology.

Long-term changes in fish pond management as ‘an unplanned ecosystem experiment’: importance of zooplankton structure, nutrients and light for species composition of cyanobacterial blooms

1995 ◽  
Vol 32 (4) ◽  
pp. 187-196 ◽  
Author(s):  
L. Pechar
Keyword(s):  
Species Composition ◽  
Fishery Management ◽  
Grazing Pressure ◽  
Organic Fertilizers ◽  
Cyanobacterial Blooms ◽  
Fish Stock ◽  
Fish Ponds ◽  
Single Filament ◽  
The 1950S ◽  
Water Blooms

The study presents data on the species composition of cyanobacterial water blooms in Czech fish ponds from the 1950s to the 1990s. Since the 1950s, a shift from large-colonial Aphanizomenon flos-aquae var. flos-aquae through Microcystis aeruginosa and small-colonial species of Anabaena to single-filament species (Planktohrix agardhii, Limnothrix redekei, Aphanizomenon gracile) or single-cell forms (Microcystis ichtyoblabe), has been observed. The changes in the species composition of the water blooms are closely related to changes in fishery management (increase in fish stock, increase in application of organic fertilizers). At present the high predation of fish upon zooplankton results in elimination of large colonial blooms of A. flos-aquae associated with large filtering zooplankton (Daphnia). Low grazing pressure of zooplankton, low light conditions and low N:P ratios are suitable conditions for mass development of the small species of cyanobacteria. High pH is not necessary to achieve cyanobacteria dominance.

Sign in / Sign up

Export Citation Format

Share Document