Influence of Filter Cell Configuration and Process Parameters on the Electro-Osmotic Dewatering of Sewage Sludge

2012 ◽  
Vol 47 (1) ◽  
pp. 11-21 ◽  
Author(s):  
M. Citeau ◽  
O. Larue ◽  
E. Vorobiev
2019 ◽  
Vol 7 (6) ◽  
pp. 5856-5866 ◽  
Author(s):  
Maxime Blatter ◽  
Marion Vermeille ◽  
Clément Furrer ◽  
Géraldine Pouget ◽  
Fabian Fischer

1993 ◽  
Vol 27 (11) ◽  
pp. 1641-1651 ◽  
Author(s):  
T.R. Sreekrishnan ◽  
R.D. Tyagi ◽  
J.F. Blais ◽  
P.G.C. Campbell

Materials ◽  
2020 ◽  
Vol 13 (16) ◽  
pp. 3544
Author(s):  
Andrzej Białowiec ◽  
Jakub Pulka ◽  
Marzena Styczyńska ◽  
Jacek A. Koziel ◽  
Joanna Kalka ◽  
...  

Improved technologies are needed for sustainable management of sewage sludge (SS). The torrefaction (also known as biomass “roasting”) is considered a pretreatment of SS before use in agriculture. However, it is not known whether the torrefaction has the potential to decrease heavy metals’ (HMs) leachability and the SS toxicity. Thus, the aim of the study was to evaluate the influences of the SS torrefaction parameters (temperature and process time) on HM contents in biochar, HM leachability, and biochar toxicity, and compare them with raw SS. The experiments were designed in 18 combinations (six temperatures, 200, 220, 240, 260, 280, and 300 °C; and three process times—20, 40, 60 min). Standard tests were used to determine HMs content, leachability, and toxicity. Results indicated that the torrefaction did not increase (p < 0.05) the HM content in comparison to the raw SS. The leachability of Zn, Ni, Cu, Cr, and Mn from SS biochars was similar to raw SS. However, the degree of leachability varied significantly (p < 0.05) from as low as 0.1% for Cu to high as 16.7% for Cd. The leachability of Cd (<16.7%) and Pb (<11.9%) from biochars was higher than from raw SS (<6.1% and <2.4%, respectively). The leachability of Cd from SS biochar, in five torrefaction combinations, was higher than the threshold value for hazardous waste. It is recommended that site-specific decisions are made for torrefaction of SS with respect to its HM content, as the resulting biochar could be considered as hazardous waste, depending on the feedstock. Moreover, the biochar produced under the whole range of temperatures during 20 min retention time significantly (p < 0.05) increased the Daphnia magna Straus mobility inhibition by up to 100% in comparison to the biochar obtained during 40 and 60 min torrefaction. Taking into account the increased leachability of specific HMs and D. magna Straus mobility inhibition, biochar should be considered a potentially hazardous material. Future research should focus on biochar dosage as a fertilizer in relation to its toxicity. Additional research is warranted to focus on the optimization of SS torrefaction process parameters affecting the toxicity.


Author(s):  
Joon Hwang ◽  
Woo-Jung Kang

This paper presents the experimental analysis of sewage sludge drying process using Taguchi method to know the characteristics and optimize drying process parameters. There have been attempt to perform the sewage sludge disposal such as simple reclaiming, dumping in the sea, incineration. Currently, these methods are restricted by national or international government regulations. The drying process is adopted as effective method for sewage sludge treatment, however sewage sludge makes difficult to treat with large volume at the real drying process plant because of its own complicated physical, chemical, and thermal properties. To treat the sewage sludge in view of environmental friendly and cost effective way, it is necessary to control the volume and weight of sewage sludge. It is not only reduces the delivery expenses and improve the re-usability, but also prevents several shift environmental pollution from nocuous sewage sludge. In this study, sewage sludge drying process parameter was modeled and evaluated with Taguchi method. From these research results the process parameters can be optimized to satisfy the desired qualities of particle diameter and moisture content of dried sewage sludge, and also provided to achieve the economic process operation.


2005 ◽  
Vol 52 (10-11) ◽  
pp. 211-218 ◽  
Author(s):  
G. Kolisch ◽  
M. Boehler ◽  
F.C. Arancibia ◽  
D. Pinnow ◽  
W. Krauss

In future, it will be necessary to incinerate an increasing proportion of the sludge produced by public wastewater treatment. In this context, equipment for more effective dewatering of sewage sludge is required. A hydraulic press system (Bucher HP) which has been used to date in the food industry could represent an alternative to the sludge dewatering systems currently used. The basic suitability of this press system was demonstrated in comprehensive industrial-scale trials at the Glarnerland STP (Switzerland). Dry solids contents of up to 43% were measured in the pressed sludge. Currently, the optimization of individual process parameters is being investigated in a pilot plant at the Schwelm STP operated by Wupperverband (Germany).


Energy ◽  
2019 ◽  
Vol 173 ◽  
pp. 140-150 ◽  
Author(s):  
Hua-jun Huang ◽  
Yan-chao Chang ◽  
Fa-ying Lai ◽  
Chun-fei Zhou ◽  
Zi-qian Pan ◽  
...  

2016 ◽  
Vol 214 ◽  
pp. 711-721 ◽  
Author(s):  
Seung Gu Shin ◽  
Taewoan Koo ◽  
Joonyeob Lee ◽  
Gyuseong Han ◽  
Kyungjin Cho ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document