A comparison of disinfection by-products formation during sequential or simultaneous disinfection of surface waters with chlorine dioxide and chlor(am)ine

2013 ◽  
Vol 34 (9) ◽  
pp. 1191-1198 ◽  
Author(s):  
Yanwei Shi ◽  
Wencui Ling ◽  
Zhimin Qiang
2002 ◽  
Vol 2 (3) ◽  
pp. 219-226
Author(s):  
N. Narkis ◽  
A. Katz-Stoller

The initial pre-disinfection was one of the stages that most contributed to the formation of a large number of halogenated disinfection by-products (DBPs). The threat and awareness to the formation of chlorine disinfection by-products, refrained from using pre-disinfection with chlorine in the treatment of contaminated raw waters, to be used as drinking water. The main purpose of this research was to study whether chlorine dioxide can be used for pre-disinfection in the treatment of highly polluted wastewaters and surface waters. Chlorine dioxide was found suitable, as a replacement for chlorine, for disinfection of water containing natural organic substances, effluents’ organic materials and ammonium ions, due to its advantages, and especially because it is an effective disinfectant for killing pathogenic microorganisms and destroying viruses. Chlorine dioxide does not form THMs and barely creates chloroorganic compounds. However, the main disadvantage of the chlorine dioxide is the creation of undesirable chlorite and chlorate ions, which are suspected of being toxic. This research showed that the undesirable chlorite ions can be removed completely by adding Fe+2, which reduces ClO2- to the harmless Cl-, and is oxidized to Fe+3, to form the ferric polyhydroxo complexes, that can be used as the flocculant, in the next flocculation step, for the achievement of safer drinking water.


2020 ◽  
Vol 16 (4) ◽  
pp. 455-461
Author(s):  
Gabriela M. Baia ◽  
Otniel Freitas-Silva ◽  
Murillo F. Junior

Fruits and vegetables are foods that come into contact with various types of microorganisms from planting to their consumption. A lack or poor sanitation of these products after harvest can cause high losses due to deterioration and/ or pathogenic microorganisms. There are practically no post-harvest fungicides or bactericides with a broad spectrum of action that have no toxic residual effects and are safe. However, to minimize such problems, the use of sanitizers is an efficient device against these microorganisms. Chlorine is the most prevalent sanitizing agent because of its broad spectrum, low cost and well-established practices. However, the inevitable formation of disinfection by-products, such as trihalomethanes (THMs) and haloacetic acids (HAAs), is considered one of the main threats to food safety. Alternative sanitizers, such as chlorine dioxide (ClO2) and ozone, are becoming popular as a substitute for traditional post-harvest treatments. Thus, this review addresses the use of chlorine, chlorine dioxide and ozone emphasizing aspects, such as usage, safe application, spectrum of action and legislation. In order to ensure the quality and safety of final products, the adoption of well-prepared sanitation and sanitation programs for post-harvest fruits and vegetables is essential.


2005 ◽  
Vol 79 (1-2) ◽  
pp. 165-170 ◽  
Author(s):  
E. Veschetti ◽  
B. Cittadini ◽  
D. Maresca ◽  
G. Citti ◽  
M. Ottaviani
Keyword(s):  

2008 ◽  
Vol 43 (1) ◽  
pp. 11-22 ◽  
Author(s):  
Rocio Aranda Rodriguez ◽  
Boniface Koudjonou ◽  
Brian Jay ◽  
Guy L. LeBel ◽  
Frank M. Benoit

Abstract A study was initiated to determine the presence of organic disinfection by-products (DBPs) in drinking water treated with chlorine dioxide (ClO2). One potential advantage for the use of ClO2 as a disinfectant is the reduced formation of organic DBPs. Generally, water treated with ClO2 produces chlorite and chlorate ions, but there is limited information regarding the presence of halogenated organic DBPs. Eight systems that use chlorine dioxide as part of the water disinfection process were investigated. All systems in this study applied chlorine as a primary or secondary disinfectant in addition to ClO2. To evaluate seasonal and spatial variations, water samples were collected during cold water (February to March 2003) and warm water (July to August 2003) months at five sites for each system: raw water (R, before treatment), treated water (T, after treatment but before distribution), and three points along the same distribution line (D1, D2, D3). Sampling and analysis were conducted according to established protocols. A suite of 27 organic DBPs including haloacetic acids (HAA), trihalomethanes (THM), haloacetonitriles (HAN), haloketones, haloacetaldehydes (HA), chloropicrin, and cyanogen chloride were examined. In addition, the concentration of oxyhalides (chlorite and chlorate ions) and auxiliary parameters were also determined. Chlorite was found in treated (T) and distributed (Dx) waters. The chlorite ion levels decreased along the distribution system (T > D1 > D2 > D3). At T sites, the levels ranged from 10 to 870 µg/L (winter), and from 300 to 1,600 µg/L (summer). Chlorite was not found in treated or distributed water in the one system that used ozone. Chlorate ion levels ranged from 20 to 310 µg/L (winter), and 80 to 318 µg/L (summer). Chlorate levels remained relatively constant throughout the distribution system. THM and eight HAA (HAA8) accounted for approximately 85% of the total DBPs (wt/wt) analyzed, followed by total HA (up to 7%) and HAN (3%). THM in distributed water were found at concentrations between 1.8 and 30.6 µg/L (winter), and 3.3 and 93.6 µg/L (summer). For HAA8, the levels ranged from 13 to 52 µg/L (winter), and 16 to 111 µg/L (summer). Chloral hydrate ranged from 0.2 to 5.2 µg/L (winter), and 0.4 to 12.2 µg/L (summer). The temporal and spatial variations observed in previous studies were confirmed in the current study as well.


1998 ◽  
Vol 37 (2) ◽  
pp. 91-96 ◽  
Author(s):  
Wido Schmidt ◽  
Beate Hambsch ◽  
Heike Petzoldt

The bacterial regrowth potential (BRP) and the by-products formation potential after the disinfection (DBP) are parameters recognized to be influenced by the origin of organic matter dissolved in water. A significant difference of the impact of humic compounds and algogenic organic matter (AOM), characteristic for raw waters from reservoirs, to both parameters can be assumed. In systematic laboratory experiments the influence of AOM on the BRP as well as DBP was examined. Different fractions of the AOM were chlorinated and treated with chlorine dioxide. In addition to that the influence of the ozonation was investigated. To assess the biodegradable fraction of the organic matter (BDOC) a large spectrum of by-products (aldehydes and keto-acids) was analyzed. The BRP in the water was determined by the measurement of the increase of biomass in the water samples. It could be proved, that the chlorination of intact algae cells containing waters may cause a significant increase of the biodegradability in the water if the residual chlorine is totally required. In the case of the disinfection of the AOM containing waters with chlorine dioxide the relative increase of the BRP was lower in comparison to the chlorinated waters. The preozonation of the algae containing waters indicates an additional increase of the BRP, but only by ozonation of the algae cells. The ozonation of the algae metabolites does not influence the BRP, but it causes a significant decrease of the THM-formation if chlorine is used for disinfection.


1989 ◽  
Vol 81 (8) ◽  
pp. 66-73 ◽  
Author(s):  
William H. Glaze ◽  
Minoru Koga ◽  
Devon Cancilla ◽  
Kaixiong Wang ◽  
Michael J. McGuire ◽  
...  
Keyword(s):  

2016 ◽  
Vol 2 (5) ◽  
pp. 838-847 ◽  
Author(s):  
Wenhui Gan ◽  
Huang Huang ◽  
Xin Yang ◽  
Ziru Peng ◽  
Guanghao Chen

On-site generation of ClO2often involves the production of Cl2as impurity and the changes of disinfection by-products formation by mixed disinfectant (ClO2/Cl2) was presented.


2000 ◽  
Vol 79 (1-2) ◽  
pp. 89-102 ◽  
Author(s):  
Chen-Yu Chang ◽  
Yung-Hsu Hsieh ◽  
Sheng-Sheng Hsu ◽  
Po-Yu Hu ◽  
Kuo-Hua Wang
Keyword(s):  

Sign in / Sign up

Export Citation Format

Share Document