Hot-wire thermal stress cleaving process of glass with micro crack-free edges

2019 ◽  
Vol 35 (5) ◽  
pp. 491-497
Author(s):  
Kun Wang ◽  
Wenhao Li ◽  
Zhanshan Wang
Keyword(s):  
Hot Wire ◽  
2018 ◽  
Vol 774 ◽  
pp. 405-409
Author(s):  
Yukio Miyashita ◽  
Yohei Kurabe ◽  
Taro Hiromoto ◽  
Yuchi Otsuka

A thick glass plate was cut by using hot wire. Crack growing was stopped when wire temperature was low. Ligament length decreased with increase in temperature of hot wire and full-cutting was achieved at the temperature of 650°C. The center region in the thickness direction seemed to propagate earlier compared to surfaces regions when the crack propagation was stopped. Finite element thermal stress analysis was carried out. According to distribution of thermal stress inside a glass plate, higher stress was generated in the bottom region at the beginning of the process but occurred in the center region in the later stage as matching with the experimental result.


2002 ◽  
Vol 715 ◽  
Author(s):  
Keda Wang ◽  
Haoyue Zhang ◽  
Jian Zhang ◽  
Jessica M. Owens ◽  
Jennifer Weinberg-Wolf ◽  
...  

Abstracta-Si:H films were prepared by hot wire chemical vapor deposition. One group was deposited at a substrate temperature of Ts=250°C with varied hydrogen-dilution ratio, 0<R<10; the other group was deposited with fixed R=3 but a varied Ts from 150 to 550°C. IR, Raman and PL spectra were studied. The Raman results indicate that there is a threshold value for the microstructure transition from a- to μc-Si. The threshold is found to be R ≈ 2 at Ts = 250°C and Ts ≈ 200°C at R=3. The IR absorption of Si-H at 640 cm-1 was used to calculate the hydrogen content, CH. CH decreased monotonically when either R or Ts increased. The Si-H stretching mode contains two peaks at 2000 and 2090 cm-1. The ratio of the integral absorption peaks I2090/(I2090+I2090) showed a sudden increase at the threshold of microcrystallinity. At the same threshold, the PL features also indicate a sudden change from a- to μc-Si., i.e. the low energy PL band becomes dominant and the PL total intensity decreases. We attribute the above IR and PL changes to the contribution of microcrystallinity, especially the c-Si gain-boundaries.


Sign in / Sign up

Export Citation Format

Share Document