scholarly journals Energy deposit by electron excitation in CnN+ projectiles (n=1-3) colliding at in termediate velocity with He atoms : semi-empirical estimates and calculations

2020 ◽  
Vol 1412 ◽  
pp. 142026
Author(s):  
T Mahajan ◽  
K Béroff ◽  
B Pons ◽  
C Illescas ◽  
M Chabot ◽  
...  
Keyword(s):  
Electron Excitation ◽  
Energy Deposit ◽  
Empirical Estimates ◽  
Semi Empirical

Article

1998 ◽  
Vol 76 (9) ◽  
pp. 679-698 ◽  
Author(s):  
GWF Drake ◽  
W C Martin
Keyword(s):  
High Precision ◽  
Scaling Law ◽  
Precision Measurements ◽  
Ionization Energies ◽  
Transition Energies ◽  
Empirical Estimates ◽  
Comprehensive Listing ◽  
Semi Empirical ◽  
S States ◽  
Asymptotic Scaling

Ionization energies for several of the lower lying S- and P-states of helium are deduced from a combination of theory and a variety of high-precision measurements of transition energies. High-precision variational methods are reviewed and used to subtract the nonrelativistic energy and lowest order α2 au relativistic corrections from the ionization energies. The remaining quantum electrodynamic (QED) shift of order α3 au and higher is calculated in an extended Kabir–Salpeter formalism and compared with experiment. The comparison verifies the usefulness of the Kabir–Salpeter formalism for terms at least up to order α4 au, and it verifies an asymptotic 1/n3 scaling law for the two-electron corrections to the Bethe logarithm. The asymptotic scaling law is used to obtain improved semi-empirical estimates for the ionization energies of the higher lying 1sns 1S and 3S states up to n = 10. A revised comprehensive listing is given for the ionization energies of all states of helium up to n = 10 and angular momentum L = 7, together with quantum defect extrapolations for the S-states. PACS Nos.: 31.15.Pf, 31.30.Jv, and 32.10.Hq

Influence of X-Ray Induced Fluorescence on Energy Dispersive X-Ray Analysis of Thin Foils

1977 ◽  
Vol 35 ◽  
pp. 328-329
Author(s):  
E. A. Kenik ◽  
J. Bentley
Keyword(s):  
Thin Foil ◽  
Electron Excitation ◽  
Simple Approach ◽  
Foil Thickness ◽  
X Rays ◽  
X Ray ◽  
Hole Spectrum ◽  
Illumination System ◽  
Thin Foils ◽  
Intensity Ratios

Cliff and Lorimer (1) have proposed a simple approach to thin foil x-ray analy sis based on the ratio of x-ray peak intensities. However, there are several experimental pitfalls which must be recognized in obtaining the desired x-ray intensities. Undesirable x-ray induced fluorescence of the specimen can result from various mechanisms and leads to x-ray intensities not characteristic of electron excitation and further results in incorrect intensity ratios.In measuring the x-ray intensity ratio for NiAl as a function of foil thickness, Zaluzec and Fraser (2) found the ratio was not constant for thicknesses where absorption could be neglected. They demonstrated that this effect originated from x-ray induced fluorescence by blocking the beam with lead foil. The primary x-rays arise in the illumination system and result in varying intensity ratios and a finite x-ray spectrum even when the specimen is not intercepting the electron beam, an ‘in-hole’ spectrum. We have developed a second technique for detecting x-ray induced fluorescence based on the magnitude of the ‘in-hole’ spectrum with different filament emission currents and condenser apertures.

Scattering-angle dependence of signal/background ratio of inner-shell electron excitation loss in EELS

1983 ◽  
Vol 41 ◽  
pp. 390-391
Author(s):  
T. Oikawa ◽  
M. Inoue ◽  
T. Honda ◽  
Y. Kokubo
Keyword(s):  
Energy Loss ◽  
Electron Excitation ◽  
Heavy Elements ◽  
Background Intensity ◽  
Light Elements ◽  
Energy Analyzer ◽  
High Background ◽  
Scattering Angle ◽  
Angle Dependence ◽  
Shell Electron

EELS allows us to make analysis of light elements such as hydrogen to heavy elements of microareas on the specimen. In energy loss spectra, however, elemental signals ride on a high background; therefore, the signal/background (S/B) ratio is very low in EELS. A technique which collects the center beam axial-symmetrically in the scattering angle is generally used to obtain high total intensity. However, the technique collects high background intensity together with elemental signals; therefore, the technique does not improve the S/B ratio. This report presents the experimental results of the S/B ratio measured as a function of the scattering angle and shows the possibility of the S/B ratio being improved in the high scattering angle range.Energy loss spectra have been measured using a JEM-200CX TEM with an energy analyzer ASEA3 at 200 kV.Fig.l shows a typical K-shell electron excitation edge riding on background in an energy loss spectrum.

Electron Scattering in Solids

1990 ◽  
Vol 48 (2) ◽  
pp. 4-5
Author(s):  
Ryuichi Shimizu ◽  
Ze-Jun Ding
Keyword(s):  
Monte Carlo Simulation ◽  
Monte Carlo ◽  
Angular Distribution ◽  
Elastic Scattering ◽  
Electron Scattering ◽  
Cross Sections ◽  
Expansion Method ◽  
Electron Excitation ◽  
Partial Wave Expansion ◽  
Backscattered Electrons

Monte Carlo simulation has been becoming most powerful tool to describe the electron scattering in solids, leading to more comprehensive understanding of the complicated mechanism of generation of various types of signals for microbeam analysis.The present paper proposes a practical model for the Monte Carlo simulation of scattering processes of a penetrating electron and the generation of the slow secondaries in solids. The model is based on the combined use of Gryzinski’s inner-shell electron excitation function and the dielectric function for taking into account the valence electron contribution in inelastic scattering processes, while the cross-sections derived by partial wave expansion method are used for describing elastic scattering processes. An improvement of the use of this elastic scattering cross-section can be seen in the success to describe the anisotropy of angular distribution of elastically backscattered electrons from Au in low energy region, shown in Fig.l. Fig.l(a) shows the elastic cross-sections of 600 eV electron for single Au-atom, clearly indicating that the angular distribution is no more smooth as expected from Rutherford scattering formula, but has the socalled lobes appearing at the large scattering angle.

EXELFS Studies of Carbon Fibers

1990 ◽  
Vol 48 (2) ◽  
pp. 72-73
Author(s):  
V. Serin ◽  
K. Hssein ◽  
G. Zanchi ◽  
J. Sévely
Keyword(s):  
Carbon Fibers ◽  
Energy Analysis ◽  
Electron Excitation ◽  
Complex Structures ◽  
High Modulus ◽  
Promising Technique ◽  
X Ray ◽  
Fine Structures ◽  
X Ray Absorption

The present developments of electron energy analysis in the microscopes by E.E.L.S. allow an accurate recording of the spectra and of their different complex structures associated with the inner shell electron excitation by the incident electrons (1). Among these structures, the Extended Energy Loss Fine Structures (EXELFS) are of particular interest. They are equivalent to the well known EXAFS oscillations in X-ray absorption spectroscopy. Due to the EELS characteristic, the Fourier analysis of EXELFS oscillations appears as a promising technique for the characterization of composite materials, the major constituents of which are low Z elements. Using EXELFS, we have developed a microstructural study of carbon fibers. This analysis concerns the carbon K edge, which appears in the spectra at 285 eV. The purpose of the paper is to compare the local short range order, determined by this way in the case of Courtauld HTS and P100 ex-polyacrylonitrile carbon fibers, which are high tensile strength (HTS) and high modulus (HM) fibers respectively.

Sign in / Sign up

Export Citation Format

Share Document