scholarly journals Anomalous behavior of linear resistivity in the vanishing process along the intergrain ordering of weak-sintered ceramic superconductor YBa2Cu4O8

2011 ◽  
Vol 320 ◽  
pp. 012075
Author(s):  
M Hagiwara ◽  
A Fujii ◽  
T Shima ◽  
H Deguchi ◽  
T Shoho ◽  
...  
Keyword(s):  
Anomalous Behavior ◽  
Ceramic Superconductor ◽  
Sintered Ceramic

Anomalous behavior of linear resistivity arising in intergrain ordering process of weak-sintered ceramic system YBa2Cu4O8

2011 ◽  
Vol 471 (21-22) ◽  
pp. 693-697 ◽  
Author(s):  
M. Hagiwara ◽  
A. Fujii ◽  
T. Hayashi ◽  
T. Shima ◽  
H. Deguchi
Keyword(s):  
Anomalous Behavior ◽  
Ceramic System ◽  
Sintered Ceramic

Effects of compression during formation on the microstructure of composite hydroxylapatite/plaster implants for bone reconstruction

1988 ◽  
Vol 46 ◽  
pp. 750-751
Author(s):  
J. Hanker ◽  
K. Cowden ◽  
R. Noecker ◽  
P. Yates ◽  
N. Georgiade ◽  
...  
Keyword(s):  
Cosmetic Surgery ◽  
Glass Plate ◽  
Surgical Reconstruction ◽  
Equal Weight ◽  
Sintered Ceramic ◽  
Setting Times ◽  
Excess Water ◽  
Mixture Prior ◽  
Mechanical Strengths ◽  
Calcium Sulfate Hemihydrate

Composites of plaster of Paris (PP) and hydroxylapatite (HA) particles are being applied for the surgical reconstruction of craniofacial bone defects and for cosmetic surgery. Two types of HA particles are being employed, the dense sintered ceramic (DHA) and the porous, coralline hydroxylapatite (PHA) particles. Excess water is expressed out of the moistened HA/PP mixture prior to implantation and setting by pressing it in a non-tapered syringe against a glass plate. This results in implants with faster setting times and greater mechanical strengths. It was therefore of interest to compare samples of the compressed versus noncompressed mixtures to see whether or not any changes in their microstructure after setting could be related to these different properties.USG Medical Grade Calcium Sulfate Hemihydrate (which has the lowest mortar consistency of any known plaster) was mixed with an equal weight of Interpore 200 particles (a commercial form of PHA). After moistening with a minimum amount of water, disc-shaped noncompressed samples were made by filling small holes (0.339 in. diameter x 0.053 in. deep) in polypropylene molds with a microspatula.

Scanning electron microscopy of composite hydroxylapatite/plaster implants for bone reconstruction

1986 ◽  
Vol 44 ◽  
pp. 326-327
Author(s):  
J. S. Hanker ◽  
B. L. Giammara
Keyword(s):  
Tooth Extraction ◽  
Alveolar Ridge ◽  
Small Particles ◽  
Alveolar Ridge Augmentation ◽  
Sintered Ceramic ◽  
Ridge Augmentation ◽  
Fibrovascular Tissue ◽  
Infrabony Defects ◽  
Edentulous Patients ◽  
Scanning Electron

Nonresorbable sintered ceramic hydroxylapatite (HA) is widely employed for filling defects in jaw bone. The small particles used for alveolar ridge augmentation in edentulous patients or for infrabony defects due to periodontal disease tend to scatter when implanted using water or saline as the vehicle. Larger blocks of this material used for filling sockets after tooth extraction don't fit well. Studies in our laboratory where we compared bovine serum albumin, collagen and plaster of Paris as binders to prevent particle scatter during implantation suggested that plaster was most useful for this purpose. In addition to preventing scatter of the particles, plaster enables the formation of implants of any size and.shape either prior to or during surgery. Studies with the PATS reaction have indicated that plaster acts as a scaffold for the incorporation of HA particles into bone in areas where the implant contacts either host bone or periosteum. The shape and integrity of the implant is maintained by the plaster component until it is replaced over a period of days by fibrovascular tissue.

Characterization of microwave-sintered ceramic composites

1993 ◽  
Vol 51 ◽  
pp. 1136-1137
Author(s):  
X. Zhang ◽  
Y. Pan ◽  
T.T. Meek
Keyword(s):  
Matrix Material ◽  
Maximum Output Power ◽  
Ceramic Matrix Composite ◽  
Ceramic Composites ◽  
Processing Technique ◽  
Structure Characterization ◽  
Alumina Powder ◽  
Maximum Output ◽  
Sintered Ceramic

Industrial microwave heating technology has emerged as a new ceramic processing technique. The unique advantages of fast sintering, high density, and improved materials properties makes it superior in certain respects to other processing methods. This work presents the structure characterization of a microwave sintered ceramic matrix composite.Commercial α-alumina powder A-16 (Alcoa) is chosen as the matrix material, β-silicon carbide whiskers (Third Millennium Technologies, Inc.) are used as the reinforcing element. The green samples consisted of 90 vol% Al2O3 powder and 10 vol% ultrasonically-dispersed SiC whiskers. The powder mixture is blended together, and then uniaxially pressed into a cylindrical pellet under a pressure of 230 MPa, which yields a 52% green density. The sintering experiments are carried out using an industry microwave system (Gober, Model S6F) which generates microwave radiation at 2.45 GHz with a maximum output power of 6 kW. The composites are sintered at two different temperatures (1550°C and 1650°C) with various isothermal processing time intervals ranging from 10 to 20 min.

scholarly journals Challenges in Bridge Health Monitoring: A Review

Sensors ◽  
2021 ◽  
Vol 21 (13) ◽  
pp. 4336
Author(s):  
Piervincenzo Rizzo ◽  
Alireza Enshaeian
Keyword(s):  
United States ◽  
Health Monitoring ◽  
Highway Bridges ◽  
The United States ◽  
Anomalous Behavior ◽  
Existing Structures ◽  
Bridge Health Monitoring ◽  
Using Data ◽  
The Many ◽  
Major Factors

Bridge health monitoring is increasingly relevant for the maintenance of existing structures or new structures with innovative concepts that require validation of design predictions. In the United States there are more than 600,000 highway bridges. Nearly half of them (46.4%) are rated as fair while about 1 out of 13 (7.6%) is rated in poor condition. As such, the United States is one of those countries in which bridge health monitoring systems are installed in order to complement conventional periodic nondestructive inspections. This paper reviews the challenges associated with bridge health monitoring related to the detection of specific bridge characteristics that may be indicators of anomalous behavior. The methods used to detect loss of stiffness, time-dependent and temperature-dependent deformations, fatigue, corrosion, and scour are discussed. Owing to the extent of the existing scientific literature, this review focuses on systems installed in U.S. bridges over the last 20 years. These are all major factors that contribute to long-term degradation of bridges. Issues related to wireless sensor drifts are discussed as well. The scope of the paper is to help newcomers, practitioners, and researchers at navigating the many methodologies that have been proposed and developed in order to identify damage using data collected from sensors installed in real structures.

scholarly journals Electrochemical Biosensors for Cytokine Profiling: Recent Advancements and Possibilities in the Near Future

Biosensors ◽  
2021 ◽  
Vol 11 (3) ◽  
pp. 94
Author(s):  
Nirmita Dutta ◽  
Peter B. Lillehoj ◽  
Pedro Estrela ◽  
Gorachand Dutta
Keyword(s):  
Immune System ◽  
Cost Effective ◽  
Anomalous Behavior ◽  
Quantitative Detection ◽  
Electrochemical Biosensors ◽  
Aberrant Expression ◽  
Detection Techniques ◽  
Short Period ◽  
User Friendly ◽  
Cytokine Profiling

Cytokines are soluble proteins secreted by immune cells that act as molecular messengers relaying instructions and mediating various functions performed by the cellular counterparts of the immune system, by means of a synchronized cascade of signaling pathways. Aberrant expression of cytokines can be indicative of anomalous behavior of the immunoregulatory system, as seen in various illnesses and conditions, such as cancer, autoimmunity, neurodegeneration and other physiological disorders. Cancer and autoimmune diseases are particularly adept at developing mechanisms to escape and modulate the immune system checkpoints, reflected by an altered cytokine profile. Cytokine profiling can provide valuable information for diagnosing such diseases and monitoring their progression, as well as assessing the efficacy of immunotherapeutic regiments. Toward this goal, there has been immense interest in the development of ultrasensitive quantitative detection techniques for cytokines, which involves technologies from various scientific disciplines, such as immunology, electrochemistry, photometry, nanotechnology and electronics. This review focusses on one aspect of this collective effort: electrochemical biosensors. Among the various types of biosensors available, electrochemical biosensors are one of the most reliable, user-friendly, easy to manufacture, cost-effective and versatile technologies that can yield results within a short period of time, making it extremely promising for routine clinical testing.

Transvection and Silencing of the Scr Homeotic Gene of Drosophila melanogaster

Genetics ◽  
2002 ◽  
Vol 161 (2) ◽  
pp. 733-746
Author(s):  
Jeffrey W Southworth ◽  
James A Kennison
Keyword(s):  
Drosophila Melanogaster ◽  
Chromosomal Aberrations ◽  
Regulatory Element ◽  
Regulatory Elements ◽  
Anomalous Behavior ◽  
Polycomb Group ◽  
Homeotic Gene ◽  
Polycomb Group Proteins ◽  
Sex Combs Reduced ◽  
In Cis

Abstract The Sex combs reduced (Scr) gene specifies the identities of the labial and first thoracic segments in Drosophila melanogaster. In imaginal cells, some Scr mutations allow cis-regulatory elements on one chromosome to stimulate expression of the promoter on the homolog, a phenomenon that was named transvection by Ed Lewis in 1954. Transvection at the Scr gene is blocked by rearrangements that disrupt pairing, but is zeste independent. Silencing of the Scr gene in the second and third thoracic segments, which requires the Polycomb group proteins, is disrupted by most chromosomal aberrations within the Scr gene. Some chromosomal aberrations completely derepress Scr even in the presence of normal levels of all Polycomb group proteins. On the basis of the pattern of chromosomal aberrations that disrupt Scr gene silencing, we propose a model in which two cis-regulatory elements interact to stabilize silencing of any promoter or cis-regulatory element physically between them. This model also explains the anomalous behavior of the Scx allele of the flanking homeotic gene, Antennapedia. This allele, which is associated with an insertion near the Antennapedia P1 promoter, inactivates the Antennapedia P1 and P2 promoters in cis and derepresses the Scr promoters both in cis and on the homologous chromosome.

Sign in / Sign up

Export Citation Format

Share Document