scholarly journals Low NOX combustion mechanism of coke oven gas with excess air coefficient and flue gas recirculation

Author(s):  
Guanghua Wang ◽  
Zihao Yan ◽  
Qingdong Wang ◽  
Guocheng Wang
2008 ◽  
Vol 2 (3) ◽  
pp. 1074-1084 ◽  
Author(s):  
Ryosuke MATSUMOTO ◽  
Mamoru OZAWA ◽  
Shinya TERADA ◽  
Takenori IIO

1977 ◽  
Vol 99 (3) ◽  
pp. 371-377 ◽  
Author(s):  
H. L. Goldstein ◽  
C. W. Siegmund

Studies were carried out in a residual fuel fired package boiler to assess the effect of various combustion modification procedures on the amount and size distribution of particulate emissions. It was found that application of moderate levels of either two stage combustion or flue gas recirculation did not have much effect on particulate loading. Severe staging as well as use of interstage heat transfer to cool the gases between stages produced significantly more particulate. Likewise, higher levels of flue gas recirculation produced substantially more particulate. In both techniques the change in size distribution was mainly in the >10- and 1–10-μm ranges. Emulsified oil containing up to 30 percent water reduced particulate loading primarily in the coarse size ranges. Satisfactory combustion could be obtained using a preheat temperature and excess air level below that required for the straight residual fuel oil.


2003 ◽  
Vol 2003.13 (0) ◽  
pp. 158-160
Author(s):  
Tadayuki Ishimi ◽  
Hisao Yamaguchi ◽  
Mitsuhiko Kamada ◽  
Eiji Matsukawa

2016 ◽  
Vol 152 ◽  
pp. 430-437 ◽  
Author(s):  
Stanislaw Gamrat ◽  
Jakub Poraj ◽  
Jakub Bodys ◽  
Jacek Smolka ◽  
Wojciech Adamczyk

Fuel ◽  
2021 ◽  
Vol 297 ◽  
pp. 120775
Author(s):  
Mohsen Abdelaal ◽  
Medhat El-Riedy ◽  
Ahmed M. El-Nahas ◽  
Fathy R. El-Wahsh

Author(s):  
Jochen R. Kalb ◽  
Thomas Sattelmayer

The technological objective of this work is the development of a lean-premixed burner for natural gas. Sub-ppm NOx emissions can be accomplished by shifting the lean blowout limit (LBO) to slightly lower adiabatic flame temperatures than the LBO of current standard burners. This can be achieved with a novel burner concept utilizing periodic flue gas recirculation: Hot flue gas is admixed to the injected premixed fresh mixture with a mass flow rate of comparable magnitude, in order to achieve self-ignition. The subsequent combustion of the diluted mixture again delivers flue gas. A fraction of the combustion products is then admixed to the next stream of fresh mixture. This process pattern is to be continued in a cyclically closed topology, in order to achieve stable combustion of e.g. natural gas in a temperature regime of very low NOx production. The principal ignition behavior and NOx production characteristics of one sequence of the periodic process was modeled by an idealized adiabatic system with instantaneous admixture of partially or completely burnt flue gas to one stream of fresh reactants. With the CHEMKIN-II package a reactor network consisting of one perfectly stirred reactor (PSR, providing ignition in the first place) and two plug flow reactors (PFR) has been used. The effect of varying burnout and the influence of the fraction of admixed flue gas have been evaluated. The simulations have been conducted with the reaction mechanism of Miller and Bowman and the GRI-Mech 3.0 mechanism. The results show that the high radical content of partially combusted products leads to a massive decrease of the time required for the formation of the radical pool. As a consequence, self-ignition times of 1 ms are achieved even at adiabatic flame temperatures of 1600 K and less, if the flue gas content is about 50%–60% of the reacting flow after mixing is complete. Interestingly, the effect of radicals on ignition is strong, outweighs the temperature deficiency and thus allows stable operation at very low NOx emissions.


2014 ◽  
Vol 1006-1007 ◽  
pp. 181-184
Author(s):  
Zhu Sen Yang ◽  
Xing Hua Liu ◽  
Shu Chen

The combustion process of municipal solid waste (MSW) in a operating 750t/d grate furnace in Guangzhou was researched by means of numerical simulation. The influence of MSW moisture content on burning effect was discussed. The results show that: with the moisture content dropped from 50% to 30%, the heat value could be evaluated from 13.72% to 54.91% and the average temperature in the furnace could be promoted 90-248°C. However, the combustible gases and particle in the flue gas of outlet would take up a high proportion since lacking of oxygen would lead to an incomplete combustion. The excess air coefficient should be increased to 2.043~2.593 in order to ensure the flue gas residence time more than 2s and temperature in the furnace higher to 800°C.


Sign in / Sign up

Export Citation Format

Share Document