638 Auricular Splinting Following Severe Facial Burn Injury and Reconstruction

2020 ◽  
Vol 41 (Supplement_1) ◽  
pp. S164-S164
Author(s):  
Lisa LePage

Abstract Introduction With a severe facial burn, injury often involves the ear(s) resulting in damage or loss which may require reconstruction. In consideration of the functional and psychological effect that loss of a defined ear lobe may entail, reconstruction is an important consideration for the burn survivor. Two cases described in detail with illustration will highlight an auricular contracture release; one with V-Y Advancement and the other with a transposition flap. Preservation of the auricular reconstruction is accomplished by implementing necessary splinting. The auricular splint fabricated was made from a combination of silicone and low-temperature thermoplastic material. A step-by-step process will illustrate the needed materials and techniques to fabricate a worthy splint in order to preserve what was surgically achieved. The splint maintains the space between the ear and head to properly position and prevent contracture through the healing and scar maturation process. It secured with a one-inch head band that is sublime enough to foster compliance with wear. The auricular splint material also serves as scar management with the many proven benefits of silicone. Methods Two case studies are reviewed with auricular contractures that required release and reconstruction. The auricular splints were fabricated to stabilize and preserve the reconstructed ear lobe. The wear schedule was intermittent during the day and overnight in combination with scar massage. The patients reported good compliance with wear and stability of splint position with overnight wear. Skin integrity was not compromised with overnight or intermittent wear. The splint fabrication process is reviewed and illustrated with a simplistic innovative end result that is user friendly. Results Surgical reconstruction was required following development of auricular contractures and partial loss. With post-operative bandage removal and wound closure, positioning was a necessary consideration to preserve post-surgical reconstruction. Conclusions In conclusion, the peri-auricular splint is fabricated with low temperature splinting material lined in silicone proved worthy for effective positioning and reported comfort with wear. Effective splinting is necessary for the preservation of surgical reconstruction and to prevent contracture from sabotaging surgical efforts. Applicability of Research to Practice Consideration of fabrication of silicone auricular splints to preserve the accomplishments of auricular surgical reconstruction.

2021 ◽  
Vol 42 (Supplement_1) ◽  
pp. S95-S96
Author(s):  
Malvina Sher ◽  
Hope Hunter ◽  
Jamie Heffernan ◽  
Angela Rabbitts

Abstract Addressing the neck during burn rehabilitation is challenging, but critical as hypertrophy and contractures can result in adverse psychosocial, functional and cosmetic outcomes. Attention to the neck early in the rehabilitation process is crucial in minimizing scarring and preventing cervical contractures. This video will demonstrate fabrication of a neck splint using silicon lined low-temperature thermoplastic material. The silicone-lined material is durable and has the capability of maintaining optimal pressure and position. It can be utilized alone or in a combination with compression garment to ensure 23 hours of pressure, which is crucial in preventing neck contractures, maintaining good cervical spine alignment and ROM, maximizing function and enhancing aesthetic appearance. Based on our clinical experience, use of silicon lined low temperature thermoplastic splint allows for early and aggressive scar management. Furthermore, patients report improved compliance with wear and ease of care for this splint.


2006 ◽  
Vol 30 (2) ◽  
pp. 351-365 ◽  
Author(s):  
Michael Noonan

Thousands of languages are currently in danger of extinction without having been adequately documented by linguists. This fact represents a tragedy for communities in which endangered languages are spoken, for linguistics as a discipline and for all of humanity. One major role of the field of linguistics is to describe languages accurately and thoroughly for the benefit of all concerned. This paper presents the results of an informal survey of major users of grammatical descriptions and gives lists of dos and don’ts for those contemplating a descriptive study of one of the many endangered languages of the world. Concrete suggestions are provided that will help grammar writers produce user-friendly, thorough and useful grammatical descriptions.


1998 ◽  
Vol 1629 (1) ◽  
pp. 137-148 ◽  
Author(s):  
Manuel Ayres ◽  
Matthew W. Witczak

A new rational mechanistic model for analysis and design of flexible pavement systems has been developed. Furthermore, a fundamental probabilistic approach was incorporated into this system to account for the uncertainty of material and environmental conditions. The system was integrated in a user-friendly Windows program with a variety of user-selected options that include widely used models and those recently developed in the Strategic Highway Research Program project. Three basic types of distress can be investigated separately or all together, including fatigue cracking, permanent deformation, and low-temperature cracking. The mechanistic approach makes use of the JULEA layered elastic analysis program to obtain pavement response. The system provides optional deterministic and probabilistic solutions, accounts for aging and temperature effects over the asphalt materials, variable interface friction, multiple wheel loads, and user-selected locations for analysis. Tabular and graphical results provide expected distress values for each month as well as their variability, probability of failure, and assessment of the overall reliability of the pavement relative to each type of distress for a user-selected failure criterion. Only the load-associated module of AYMA is presented; a separate work describes the low-temperature cracking analysis.


2019 ◽  
Vol 18 (3) ◽  
pp. 219-227 ◽  
Author(s):  
José G. B. Derraik ◽  
Éadaoin M. Butler ◽  
Kittipan Rerkasem

Many researchers find writing a scientific manuscript a highly discouraging task. This problem may be partly responsible for the fact that approximately half of completed clinical studies worldwide remain unreported or unpublished. Therefore, we aimed to create a user-friendly guide with helpful recommendations, which are complementary to the many existing reporting guidelines for quantitative clinical data. This article has been prepared with clearly defined subheadings, to facilitate quick identification of any specific sections/topics. We encourage the use of the IMRaD model (ie, Introduction, Methods, Results, and Discussion), providing guidance on the key information required, as well as the dos and don’ts. We also comment briefly on feedback and rejection, proposing the I AM approach (Ignore, Address, and Move on).


2013 ◽  
Vol 740 ◽  
pp. 198-202 ◽  
Author(s):  
Enoch de Santiago Rojas ◽  
Jorge Ivan Moncada Haaz ◽  
Felipe de J. Rabago Bernal ◽  
Adan Rodriguez Dominguez

This paper describes the design and implementation of a solar powered automated greenhouse. The objectives are to automatically control the environment, irrigation, and fertilizer to plants in the greenhouse. Another aspect is that its operation is suitable for anyone without knowledge in greenhouses, computers, electronics, etc. Specific objectives are: Control the gain of the low temperature by means of a sensor and actuators that extract fans as hot air and introduce fresh air, and a lamp to increase the temperature if necessary. Control the relative humidity by means of a sensor and valves that open to introduce water and fertilize if necessary. Control the charge and discharge of the battery to avoid prejudicing its life. Develop a modular, user-friendly and simple to operate. Battery is charged by solar cells. This greenhouse can be installed in remote towns where electricity is not available.


2005 ◽  
Vol 1281 ◽  
pp. 504-508 ◽  
Author(s):  
L. Kovacs ◽  
A. Zimmermann ◽  
H. Wawrzyn ◽  
K. Schwenzer ◽  
H. Seitz ◽  
...  

2016 ◽  
Vol 41 (6) ◽  
pp. 628-649 ◽  
Author(s):  
Sarah Depaoli ◽  
James P. Clifton ◽  
Patrice R. Cobb

A review of the software Just Another Gibbs Sampler (JAGS) is provided. We cover aspects related to history and development and the elements a user needs to know to get started with the program, including (a) definition of the data, (b) definition of the model, (c) compilation of the model, and (d) initialization of the model. An example using a latent class model with large-scale education data is provided to illustrate how easily JAGS can be implemented in R. We also cover details surrounding the many programs implementing JAGS. We conclude with a discussion of the newest features and upcoming developments. JAGS is constantly evolving and is developing into a flexible, user-friendly program with many benefits for Bayesian inference.


Author(s):  
Saket Srivastava ◽  
Pradeep Gupta

<p><strong>Background:</strong> The scalp is a unique part of the human body and various etiological factors, such as tumour extirpation, infection, burns, or trauma, can lead to scalp defects. Primary closure, skin grafting, local flaps, tissue expansion or free tissue transfer are modalities available for scalp reconstruction. In this article, the authors share their institutional experience using various local flaps concerning the size, location, depth of defect and the quality of surrounding tissue.</p><p><strong>Methods:</strong> From September 2017 to January 2020, 54 patients underwent scalp reconstruction with local flaps for a defect size of 5 to 150 cm<sup>2</sup> in the department of plastic surgery, SMS medical college, Jaipur. Patients were identified by age, sex, cause of the scalp defect; the location, size, and depth of the defect; condition of surrounding tissue and the type of reconstruction done.</p><p><strong>Results:</strong> The most common cause of scalp defect was excision of malignant tumour (50%). Thirty patients had a large sized defect (40-90 cm<sup>2</sup>) and 28 patients had 90-150 cm<sup>2</sup> defects. Surgical reconstruction was done using local flaps, transposition flap was the most used in 36 patients (66.7%) followed by rotation advancement flap in 11 patients (20.4%). The recovery was relatively quick. Minor complications happened in 5 patients (9.3%) that were managed conservatively.</p><p><strong>Conclusions</strong>: In the present era of microsurgical reconstruction, local options as axial flaps provide a simpler and safer method of scalp reconstruction. A carefully planned scalp flap gives healthy, robust, hair-bearing tissue coverage and requires a shorter healing time for the patients.</p>


2006 ◽  
Vol 22 (03) ◽  
Author(s):  
Laszlo Kovacs ◽  
Nikolaos Papadopulos ◽  
Markus Kloeppel ◽  
Katja Schwenzer ◽  
H. Seitz ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document