DDX6 regulates sequestered nuclear CUG-expanded DMPK-mRNA in dystrophia myotonica type 1

Mitochondrial alterations were studied in 25 liver biopsies from patients with alcoholic liver disease. Of special interest were the morphologic resemblance of certain fine structural variations in mitochondria and crystalloid inclusions. Four types of alterations within mitochondria were found that seemed to relate to cytoplasmic crystalloids.Type 1 alteration consisted of localized groups of cristae, usually oriented in the long direction of the organelle (Fig. 1A). In this plane they appeared serrated at the periphery with blind endings in the matrix. Other sections revealed a system of equally-spaced diagonal lines lengthwise in the mitochondrion with cristae protruding from both ends (Fig. 1B). Profiles of this inclusion were not unlike tangential cuts of a crystalloid structure frequently seen in enlarged mitochondria described below.

Download Full-text

Evidence for a shear mechanism for the precipitation of γ-zirconium hydride in zirconium

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s042482010011043x ◽

1978 ◽

Vol 36 (1) ◽

pp. 658-659

Author(s):

G.J.C. Carpenter

Keyword(s):

Elevated Temperature ◽

Strain Field ◽

Zirconium Hydride ◽

Zirconium Atom ◽

Atom Diffusion ◽

Solvus Temperature ◽

Hexagonal Close Packed ◽

Partial Dislocations ◽

The Face

In zirconium-hydrogen alloys, rapid cooling from an elevated temperature causes precipitation of the face-centred tetragonal (fct) phase, γZrH, in the form of needles, parallel to the close-packed <1120>zr directions (1). With low hydrogen concentrations, the hydride solvus is sufficiently low that zirconium atom diffusion cannot occur. For example, with 6 μg/g hydrogen, the solvus temperature is approximately 370 K (2), at which only the hydrogen diffuses readily. Shears are therefore necessary to produce the crystallographic transformation from hexagonal close-packed (hep) zirconium to fct hydride.The simplest mechanism for the transformation is the passage of Shockley partial dislocations having Burgers vectors (b) of the type 1/3<0110> on every second (0001)Zr plane. If the partial dislocations are in the form of loops with the same b, the crosssection of a hydride precipitate will be as shown in fig.1. A consequence of this type of transformation is that a cumulative shear, S, is produced that leads to a strain field in the surrounding zirconium matrix, as illustrated in fig.2a.

Download Full-text

Direct structure images of 30° partial dislocation cores in silicon

Proceedings, annual meeting, Electron Microscopy Society of America ◽

10.1017/s0424820100126111 ◽

1987 ◽

Vol 45 ◽

pp. 242-243

Author(s):

J. C. Barry ◽

H. Alexander

Keyword(s):

Dislocation Core ◽

Preparation Technique ◽

Burgers Vector ◽

Vector Type ◽

Sample Preparation Technique ◽

Lattice Images ◽

Dislocation Core Structure ◽

Type Lattice ◽

Direct Inspection

Dislocations in silicon produced by plastic deformation are generally dissociated into partials. 60° dislocations (Burgers vector type 1/2[101]) are dissociated into 30°(Burgers vector type 1/6[211]) and 90°(Burgers vector type 1/6[112]) dislocations. The 30° partials may be either of “glide” or “shuffle” type. Lattice images of the 30° dislocation have been obtained with a JEM 100B, and with a JEM 200Cx. In the aforementioned experiments a reasonable but imperfect match was obtained with calculated images for the “glide” model. In the present experiment direct structure images of 30° dislocation cores have been obtained with a JEOL 4000EX. It is possible to deduce the 30° dislocation core structure by direct inspection of the images. Dislocations were produced by compression of single crystal Si (sample preparation technique described in Alexander et al.).

Download Full-text