scholarly journals Anisotropic zero-resistance onset in organic superconductors

2021 ◽  
Vol 103 (1) ◽  
Author(s):  
Vladislav D. Kochev ◽  
Kaushal K. Kesharpu ◽  
Pavel D. Grigoriev
2004 ◽  
Vol 114 ◽  
pp. 367-369 ◽  
Author(s):  
F. L. Pratt ◽  
S. J. Blundell ◽  
T. Lancaster ◽  
S. L. Lee ◽  
N. Toyota

1983 ◽  
Vol 44 (C3) ◽  
pp. C3-983-C3-989 ◽  
Author(s):  
H. Gutfreund ◽  
B. Horovitz ◽  
M. Weger

Crystals ◽  
2021 ◽  
Vol 11 (1) ◽  
pp. 72
Author(s):  
Kaushal K. Kesharpu ◽  
Vladislav D. Kochev ◽  
Pavel D. Grigoriev

In highly anisotropic organic superconductor (TMTSF)2ClO4, superconducting (SC) phase coexists with metallic and spin-density wave phases in the form of domains. Using the Maxwell-Garnett approximation (MGA), we calculate the volume ratio and estimate the shape of these embedded SC domains from resistivity data at various temperature and anion disorder, controlled by the cooling rate or annealing time of (TMTSF)2ClO4 samples. We found that the variation of cooling rate and of annealing time affect differently the shape of SC domains. In all cases the SC domains have oblate shape, being the shortest along the interlayer z-axis. This contradicts the widely assumed filamentary superconductivity along the z-axis, used to explain the anisotropic superconductivity onset. We show that anisotropic resistivity drop at the SC onset can be described by the analytical MGA theory with anisotropic background resistance, while the anisotropic Tc can be explained by considering a finite size and flat shape of the samples. Due to a flat/needle sample shape, the probability of percolation via SC domains is the highest along the shortest sample dimension (z-axis), and the lowest along the sample length (x-axis). Our theory can be applied to other heterogeneous superconductors, where the size d of SC domains is much larger than the SC coherence length ξ, e.g., cuprates, iron-based or organic superconductors. It is also applicable when the spin/charge-density wave domains are embedded inside a metallic background, or vice versa.


1990 ◽  
Vol 5 (4) ◽  
pp. 677-679 ◽  
Author(s):  
A. J. Drehman ◽  
M. W. Dumais

Y-Ba-Cu-O films were made by R-F diode sputtering using a single oxide target. It was found that if a small negative bias is applied to the substrate, the etching associated with reactive sputtering is significantly reduced. This results in better composition control and uniformity, which are quite important for the formation of superconducting thin films. Films deposited on strontium titanate, when annealed in oxygen, become superconducting with zero resistance at 89 K.


1991 ◽  
Vol 05 (24n25) ◽  
pp. 1635-1638
Author(s):  
S.M. M.R. NAQVI ◽  
A.A. QIDWAI ◽  
S.M. ZIA-UL-HAQUE ◽  
FIROZ AHMAD ◽  
S.D.H. RIZVI ◽  
...  

Bi1.7-Pb0.3-Sr2-Ca2-Cu3-Ox superconducting samples were prepared at 855°C, 862 C, 870 C, and 882 C sintering temperatures respectively. All samples were sintered for 120 hours. The samples were then quenched in liquid nitrogen. The electrical resistivity measurements showed that the samples sintered at 870° C had the best Tc. For these samples the Tc onset was around 120 K and the zero resistance was obtained at 108 K. X-ray diffraction studies showed that the samples were multiphased.


1992 ◽  
Vol 45 (6) ◽  
pp. 3018-3025 ◽  
Author(s):  
J. Wosnitza ◽  
G. W. Crabtree ◽  
H. H. Wang ◽  
U. Geiser ◽  
J. M. Williams ◽  
...  

1989 ◽  
Vol 169 ◽  
Author(s):  
X.K. Wang ◽  
D.X. Li ◽  
S.N. Song ◽  
J.Q. Zheng ◽  
R.P.H. Chang ◽  
...  

AbstractEpitaxial thin films of YBaCuO were prepared by multilayer deposition from Y, Cu, and BaF2 sources with: (1) the a‐axis perpendicular to (100)SrTiO3; (2) the c‐axis perpendicular to (100)SrTiO3; and (3) the [110] axis perpendicular to (110)SrTiO3. XRD patterns as well as SEM and HREM images confirm that the films are highly oriented, essentially epitaxial. Both the a‐axis oriented and the c‐axis oriented films exhibit zero resistance at 91K. The [110] oriented film shows the sharpest transiton with a transition width of IK and zero resistance at 85K. The zero field critical current density, Jc, determined magnetically, is in excess of 107A/cm2 at 4.4K and 1.04 x 106A/cm2 at 77K for the c‐axis oriented film; for the a‐axis oriented film we obtained 6.7 x 106A/cm2 at 4.4K and 1.2 x 105A/cm2 at 77K. The orientation dependence of the critical current density in the basal plane of the a‐axis oriented film was studied. The largest Jc's occur along the in‐plane <100> axes of the substrate.


2005 ◽  
Vol 71 (21) ◽  
Author(s):  
R. Wesołowski ◽  
J. T. Haraldsen ◽  
J. Cao ◽  
J. L. Musfeldt ◽  
I. Olejniczak ◽  
...  

1982 ◽  
Vol 25 (2) ◽  
pp. 1405-1407 ◽  
Author(s):  
D. C. Tsui ◽  
H. L. Störmer ◽  
A. C. Gossard

Sign in / Sign up

Export Citation Format

Share Document