Stabilization of cubic Na-modified ZrO2: a neutron diffraction study

1999 ◽  
Vol 32 (3) ◽  
pp. 475-480 ◽  
Author(s):  
P. Canton ◽  
G. Fagherazzi ◽  
R. Frattini ◽  
P. Riello

Neutron diffraction patterns, collected at room temperature and, within situthermal treatment, from 981 to 1173 K, on a zirconia sample containing 3 wt% of sodium, show the presence and the stability of the cubic form of zirconia from 298 to 1073 K. The analysis has also demonstrated the presence of a significant amount of the tetragonal form of zirconia, which cannot be clearly detected using conventional X-ray diffraction. We report and discuss the Rietveld refinements performed on the samples, analysed at 298 and at 981 K. The cubic form appears to be stabilized by the incorporation of sodium ions, which randomly replace the zirconium ions, thus forming a substitutional solid solution.

Crystals ◽  
2018 ◽  
Vol 9 (1) ◽  
pp. 2 ◽  
Author(s):  
Alka Garg ◽  
Daniel Errandonea ◽  
Julio Pellicer-Porres ◽  
Domingo Martinez-Garcia ◽  
Swayam Kesari ◽  
...  

The high-pressure behaviour of LiCrO2, a compound isostructural to the battery compound LiCoO2, has been investigated by synchrotron-based angle-dispersive X-ray powder diffraction, Raman spectroscopy, and resistance measurements up to 41, 30, and 10 Gpa, respectively. The stability of the layered structured compound on a triangular lattice with R-3m space group is confirmed in all three measurements up to the highest pressure reached. The dependence of lattice parameters and unit-cell volume with pressure has been determined from the structural refinements of X-ray diffraction patterns that are used to extract the axial compressibilities and bulk modulus by means of Birch–Murnaghan equation-of-state fits. The pressure coefficients for the two Raman-active modes, A1g and Eg, and their mode-Grüneisen parameters are reported. The electrical resistance measurements indicate that pressure has little influence in the resistivity up to 10 GPa. The obtained results for the vibrational and structural properties of LiCrO2 under pressure are in line with the published results of the similar studies on the related compounds. Research work reported in this article contributes significantly to enhance the understanding on the structural and mechanical properties of LiCrO2 and related lithium compounds.


Nanomaterials ◽  
2021 ◽  
Vol 11 (8) ◽  
pp. 1885
Author(s):  
Xinyu Wu ◽  
Feng Yang ◽  
Jian Gan ◽  
Zhangqian Kong ◽  
Yan Wu

The silver particles were grown in situ on the surface of wood by the silver mirror method and modified with stearic acid to acquire a surface with superhydrophobic and antibacterial properties. Fourier transform infrared spectroscopy (FTIR), X-ray diffraction (XRD), and X-ray energy spectroscopy (XPS) were used to analyze the reaction mechanism of the modification process. Scanning electron microscopy (SEM) and contact angle tests were used to characterize the wettability and surface morphology. A coating with a micro rough structure was successfully constructed by the modification of stearic acid, which imparted superhydrophobicity and antibacterial activity to poplar wood. The stability tests were performed to discuss the stability of its hydrophobic performance. The results showed that it has good mechanical properties, acid and alkali resistance, and UV stability. The durability tests demonstrated that the coating has the function of water resistance and fouling resistance and can maintain the stability of its hydrophobic properties under different temperatures of heat treatment.


2021 ◽  
Vol 10 (3) ◽  
pp. 578-586
Author(s):  
Lin-Kun Shi ◽  
Xiaobing Zhou ◽  
Jian-Qing Dai ◽  
Ke Chen ◽  
Zhengren Huang ◽  
...  

AbstractA nano-laminated Y3Si2C2 ceramic material was successfully synthesized via an in situ reaction between YH2 and SiC using spark plasma sintering technology. A MAX phase-like ternary layered structure of Y3Si2C2 was observed at the atomic-scale by high resolution transmission electron microscopy. The lattice parameters calculated from both X-ray diffraction and selected area electron diffraction patterns are in good agreement with the reported theoretical results. The nano-laminated fracture of kink boundaries, delamination, and slipping were observed at the tip of the Vickers indents. The elastic modulus and Vickers hardness of Y3Si2C2 ceramics (with 5.5 wt% Y2O3) sintered at 1500 °C were 156 and 6.4 GPa, respectively. The corresponding values of thermal and electrical conductivity were 13.7 W·m-1·K-1 and 6.3×105 S·m-1, respectively.


2014 ◽  
Vol 70 (a1) ◽  
pp. C94-C94
Author(s):  
Pawel Kuczera ◽  
Walter Steurer

The structure of d(ecagonal)-Al-Cu-Rh has been studied as a function of temperature by in-situ single-crystal X-ray diffraction in order to contribute to the discussion on energy or entropy stabilization of quasicrystals (QC) [1]. The experiments were performed at 293 K, 1223 K, 1153 K, 1083 K, and 1013 K. A common subset of 1460 unique reflections was used for the comparative structure refinements at each temperature. The results obtained for the HT structure refinements of d-Al-Cu-Rh QC seem to contradict a pure phasonic-entropy-based stabilization mechanism [2] for this QC. The trends observed for the ln func(I(T1 )/I(T2 )) vs.|k⊥ |^2 plots indicate that the best on-average quasiperiodic order exists between 1083 K and 1153 K, however, what that actually means is unclear. It could indicate towards a small phasonic contribution to entropy, but such contribution is not seen in the structure refinements. A rough estimation of the hypothetic phason instability temperature shows that it would be kinetically inaccessible and thus the phase transition to a 12 Å low T structure (at ~800 K) is most likely not phason-driven. Except for the obvious increase in the amplitude of the thermal motion, no other significant structural changes, in particular no sources of additional phason-related configurational entropy, were found. All structures are refined to very similar R-values, which proves that the quality of the refinement at each temperature is the same. This suggests, that concerning the stability factors, some QCs could be similar to other HT complex intermetallic phases. The experimental results clearly show that at least the ~4 Å structure of d-Al-Cu-Rh is a HT phase therefore entropy plays an important role in its stabilisation mechanism lowering the free energy. However, the main source of this entropy is probably not related to phason flips, but rather to lattice vibrations, occupational disorder unrelated to phason flips like split positions along the periodic axis.


2021 ◽  
Vol 139 ◽  
pp. 107371
Author(s):  
Haiyan He ◽  
Bing Wang ◽  
Dong Ma ◽  
Alexandru D. Stoica ◽  
Zhenduo Wu ◽  
...  

1998 ◽  
Vol 31 (5) ◽  
pp. 823-825 ◽  
Author(s):  
Ö. Bergstöm ◽  
A. M. Andersson ◽  
K. Edström ◽  
T. Gustafsson

An electrochemical cell has been constructed forin situneutron diffraction studies of lithium-insertion/extraction processes in electrode materials for Li-ion batteries. Its key components are a Pyrex tube, gold plated on its inside, which functions as a current collector, and a central lithium rod, which serves as the negative electrode. The device is demonstrated here for a neutron diffraction study of lithium extraction from LiMn2O4: a mechanical Celgard©separator soaked in the electrolyte surrounds the lithium electrode. The LiMn2O4powder, mixed with electrolyte, occupies the space between separator and current collector.


ChemInform ◽  
2010 ◽  
Vol 24 (1) ◽  
pp. no-no
Author(s):  
M. LATROCHE ◽  
A. PERCHERON-GUEGAN ◽  
Y. CHABRE ◽  
C. POINSIGNON ◽  
J. PANNETIER

1998 ◽  
Vol 53 (5-6) ◽  
pp. 557-561
Author(s):  
Tobias Unruh ◽  
Günter Schwitzgebel ◽  
Clemens Ritter

Abstract DxNb2O5 is thermodynamically unstable. Therefore, neutron diffraction measurements were performed in the electrochemical cell used for the intercalation of deuterium into sintered Nb2O5 powder samples. Diffraction patterns were recorded at equilibrium potentials of -443, -428, -332 and -197 mV vs. NHE (corresponding to x = 0.232, x = 0.23, x = 0.21 and x = 0.06). The structural changes in Nb2O5 caused by the deuterium insertion are small but could be determined reproducibly. The lattice parameters of the host lattice exhibit a characteristic dependence on the deuterium content of the bronze. A model has been developed for the partially inhomogeneous distribution of the deuterium in the Nb2O5 unit cell, which explains the changes of the peak intensities observed in the low angle region (6° ≤ 2θ ≤ 18°).


Sign in / Sign up

Export Citation Format

Share Document