Abstract
If a signal on clock tree is slower than expected due to either a design error or a manufacturing defect, it may cause complicated fault behaviors during scan-based testing. It makes the diagnosis of such defect especially difficult if the defective clock signal is used for both shift and capture operations during the scan testing, because (1) the defect induces hold time faults on scan chains during shift cycles, and (2) hold-time faults may also be introduced during capture cycles in the functional logic paths. In this paper we illustrate the failure behaviors of such clock defects and propose an algorithm to diagnose it.
Pre-bond testable low-power clock tree design for 3D stacked ICs
