CuInSe2/Zn(S,O,OH) junction on Mo foil by electrochemical and chemical route for photovoltaic applications

Author(s):  
R. L. Oliveri ◽  
R. Inguanta ◽  
G. Ferrara ◽  
S. Piazza ◽  
C. Sunseri ◽  
...  
Author(s):  
Pratibha L. Gai ◽  
M. A. Saltzberg ◽  
L.G. Hanna ◽  
S.C. Winchester

Silica based ceramics are some of the most fundamental in crystal chemistry. The cristobalite form of silica has two modifications, α (low temperature, tetragonal form) and β (high temperature, cubic form). This paper describes our structural studies of unusual chemically stabilized cristobalite (CSC) material, a room temperature silica-based ceramic containing small amounts of dopants, prepared by a wet chemical route. It displays many of the structural charatcteristics of the high temperature β-cristobalite (∼270°C), but does not undergo phase inversion to α-cristobalite upon cooling. The Structure of α-cristobalite is well established, but that of β is not yet fully understood.Compositions with varying Ca/Al ratio and substitutions in cristobalite were prepared in the series, CaO:Al2O3:SiO2 : 3-x: x : 40, with x= 0-3. For CSC, a clear sol was prepared from Du Pont colloidal silica, Ludox AS-40®, aluminium nitrate nonahydrate, and calcium nitrate hexahydrate in proportions to form a final composition 1:2:40 composition.


Author(s):  
J.P.S. Hanjra

Tin mono selenide (SnSe) with an energy gap of about 1 eV is a potential material for photovoltaic applications. Various authors have studied the structure, electronic and photoelectronic properties of thin films of SnSe grown by various deposition techniques. However, for practical photovoltaic junctions the electrical properties of SnSe films need improvement. We have carried out investigations into the properties of flash evaporated SnSe films. In this paper we report our results on the structure, which plays a dominant role on the electrical properties of thin films by TEM, SEM, and electron diffraction (ED).Thin films of SnSe were deposited by flash evaporation of SnSe fine powder prepared from high purity Sn and Se, onto glass, mica and KCl substrates in a vacuum of 2Ø micro Torr. A 15% HF + 2Ø% HNO3 solution was used to detach SnSe film from the glass and mica substrates whereas the film deposited on KCl substrate was floated over an ethanol water mixture by dissolution of KCl. The floating films were picked up on the grids for their EM analysis.


Sign in / Sign up

Export Citation Format

Share Document