Development of Medical Mask Utilizing Electrostatic Gradient Force

Author(s):  
S. Katsura ◽  
S. Sakata ◽  
K. Fukuta ◽  
A. Mizuno
Keyword(s):  
2021 ◽  
Vol 103 (3) ◽  
Author(s):  
Hongxia Zheng ◽  
Huajin Chen ◽  
Jack Ng ◽  
Zhifang Lin

2013 ◽  
Vol 7 (1) ◽  
pp. 46-59 ◽  
Author(s):  
Masaki Michihata ◽  
Tada-aki Yoshikane ◽  
Terutake Hayashi ◽  
Yasuhiro Takaya

2006 ◽  
Vol 134 (2) ◽  
pp. 664-674 ◽  
Author(s):  
Jongil Han ◽  
Hua-Lu Pan

Abstract A parameterization of the convection-induced pressure gradient force (PGF) in convective momentum transport (CMT) is tested for hurricane intensity forecasting using NCEP's operational Global Forecast System (GFS) and its nested Regional Spectral Model (RSM). In the parameterization the PGF is assumed to be proportional to the product of the cloud mass flux and vertical wind shear. Compared to control forecasts using the present operational GFS and RSM where the PGF effect in CMT is taken into account empirically, the new PGF parameterization helps increase hurricane intensity by reducing the vertical momentum exchange, giving rise to a closer comparison to the observations. In addition, the new PGF parameterization forecasts not only show more realistically organized precipitation patterns with enhanced hurricane intensity but also reduce the forecast track error. Nevertheless, the model forecasts with the new PGF parameterization still largely underpredict the observed intensity. One of the many possible reasons for the large underprediction may be the absence of hurricane initialization in the models.


Optik ◽  
2016 ◽  
Vol 127 (10) ◽  
pp. 4193-4199 ◽  
Author(s):  
Chunxian Tao ◽  
Jun Fu ◽  
Wen Wang ◽  
Xiumin Gao ◽  
Dawei Zhang

Ocean Science ◽  
2016 ◽  
Vol 12 (1) ◽  
pp. 137-151 ◽  
Author(s):  
M. Grifoll ◽  
A. L. Aretxabaleta ◽  
J. L. Pelegrí ◽  
M. Espino

Abstract. We investigate the rapidly changing equilibrium between the momentum sources and sinks during the passage of a single two-peak storm over the Catalan inner shelf (NW Mediterranean Sea). Velocity measurements at 24 m water depth are taken as representative of the inner shelf, and the cross-shelf variability is explored with measurements at 50 m water depth. During both wind pulses, the flow accelerated at 24 m until shortly after the wind maxima, when the bottom stress was able to compensate for the wind stress. Concurrently, the sea level also responded, with the pressure-gradient force opposing the wind stress. Before, during and after the second wind pulse, there were velocity fluctuations with both super- and sub-inertial periods likely associated with transient coastal waves. Throughout the storm, the Coriolis force and wave radiation stresses were relatively unimportant in the along-shelf momentum balance. The frictional adjustment timescale was around 10 h, consistent with the e-folding time obtained from bottom drag parameterizations. The momentum evolution at 50 m showed a larger influence of the Coriolis force at the expense of a decreased frictional relevance, typical in the transition from the inner to the mid-shelf.


2015 ◽  
Vol 15 (6) ◽  
pp. 8479-8523
Author(s):  
C.-C. Wang ◽  
H.-C. Kuo ◽  
R. H. Johnson ◽  
C.-Y. Lee ◽  
S.-Y. Huang ◽  
...  

Abstract. This paper investigates the formation and evolution of deep convection inside the east–west oriented rainbands associated with a low-level jet (LLJ) in Typhoon Morakot (2009). With typhoon center to the northwest of Taiwan, the westerly LLJ was resulted from the interaction of typhoon circulation with the southwest monsoon flow, which supplied the water vapor for the extreme rainfall (of ~1000 mm) over southwestern Taiwan. The Cloud-Resolving Storm Simulator with 1 km grid spacing was used to simulate the event, and it successfully reproduced the slow-moving rainbands, the embedded cells, and the dynamics of merger and back-building (BB) on 8 August as observed. Our model results suggest that the intense convection interacted strongly with the westerly LLJ that provided reversed vertical wind shear below and above the jet core. Inside mature cells, significant dynamical pressure perturbations (pd') are induced with positive (negative) pd' at the western (eastern) flank of the updraft near the surface and a reversed pattern aloft (>2 km). This configuration produced an upward directed pressure gradient force (PGF) to the rear side and favors new development to the west, which further leads to cell merger as the mature cells slowdown in eastward propagation. The strong updrafts also acted to elevate the jet and enhance the local vertical wind shear at the rear flank. Additional analysis reveals that the upward PGF there is resulted mainly by the shearing effect but also by the extension of upward acceleration at low levels. In the horizontal, the upstream-directed PGF induced by the rear-side positive pd' near the surface is much smaller, but can provide additional convergence for BB development upstream. Finally, the cold-pool mechanism for BB appears to be not important in the Morakot case, as the conditions for strong evaporation in downdrafts do not exist.


2021 ◽  
Vol 11 (1) ◽  
Author(s):  
Abolfazl Aqhili ◽  
Sara Darbari

AbstractIn this report, we propose the closed pack array of gold discs on glass, as a dual mode plasmonic tweezers that benefits from two trapping modes. The first trapping mode is based on leaky surface plasmon mode (LSPM) on the gold discs with a longer penetration depth in the water and a longer spatial trapping range, so that target nanoparticles with a radius of 100 nm can be attracted toward the gold surface from a vertical distance of about 2 µm. This trapping mode can help to overcome the inherent short range trapping challenge in the plasmonic tweezers. The second trapping mode is based on the dimer surface plasmonic mode (DSPM) in the nano-slits between the neighboring gold discs, leading to isolated and strong trapping sites for nanoparticles smaller than 34 nm. The proposed plasmonic tweezers can be excited in both LSPM and DSPM modes by switching the incident wavelength, resulting in promising and complementary functionalities. In the proposed plasmonic tweezers, we can attract the target particles towards the gold surface by LSPM gradient force, and trap them within a wide half widthhalfmaximum (HWHM) that allows studying the interactions between the trapped particles, due to their spatial proximity. Then, by switching to the DSPM trapping mode, we can rearrange the particles in a periodic pattern of isolated and stiff traps. The proposed plasmonic structure and the presented study opens a new insight for realizing efficient, dual-mode tweezers with complementary characteristics, suitable for manipulation of nanoparticles. Our thermal simulations demonstrate that the thermal-induced forces does not interefe with the proposed plasmonic tweezing.


Sign in / Sign up

Export Citation Format

Share Document