This project proposes multilayer advanced high-performance bus architecture for low power applications. The proposed AHB architecture consists of the bus arbiter and the bus tracer (A.R.M.A., 1999. Specification (Rev 2.0) ARM IHI0011A). The bus arbiter, which is self motivated selects
the input packet based on the control signals of the incoming packet. So that arbitration leads to a maximum performance. The On-Chip bus is an important system-on-chip infrastructure that connects major hardware components. Monitoring the on-chip bus signals is crucial to the SoC debugging
and performance analysis/optimization (Gu, R.T., et al., 2007. A Low Cost Tile-Based 3D Graphics Full Pipeline with Real-Time Performance Monitoring Support for OpenGL ES in Consumer Electronics. 2007 IEEE International Symposium on Consumer Electronics, June; IEEE. pp.1–6). But,
such signals are difficult to observe since they are deeply embedded in a SoC and there are often no sufficient I/O pins to access these signals. Therefore, a straightforward approach is to embed a bus tracer in SoC to capture the bus signal trace and store the trace in on-chip storage such
as the trace memory which could then be off loaded to outside world for analysis. The bus tracer is capable of capturing the bus trace with different resolutions, all with efficient built in compression mechanisms such as dictionary based compression scheme for address and control signals
and differential compression scheme for data. To improve the compression ratio matrix based compression which is lossless compression is used instead of differential compression. This system is designed using Verilog HDL, simulated using Modelsim and synthesized using Xilinx software.
Design and Performance Evaluation of On-chip Antenna for Ultra Low Power Wireless Transceiver