Solar Powered Water Desalination Using Fresnel Lens Tracking System

2019 ◽  
Author(s):  
Rakesh Borase ◽  
Jayanand Gawande ◽  
Sushant Pawar ◽  
Sharad Jadhav
Keyword(s):  
Tracking System ◽  
Fresnel Lens ◽  
Water Desalination ◽  
Solar Powered

Solar Thermophotovoltaic Converters Based on Tungsten Emitters

2006 ◽  
Vol 129 (3) ◽  
pp. 298-303 ◽  
Author(s):  
V. M. Andreev ◽  
A. S. Vlasov ◽  
V. P. Khvostikov ◽  
O. A. Khvostikova ◽  
P. Y. Gazaryan ◽  
...  
Keyword(s):  
Band Gap ◽  
High Efficiency ◽  
Radiation Spectrum ◽  
Cost Effective ◽  
Fresnel Lens ◽  
Photocurrent Density ◽  
Back Side ◽  
High Concentration ◽  
Emitter System ◽  
Solar Powered

Results of a solar thermophotovoltaic (STPV) system study are reported. Modeling of the STPV module performance and the analysis of various parameters influencing the system are presented. The ways for the STPV system efficiency to increase and their magnitude are considered such as: improvement of the emitter radiation selectivity and application of selective filters for better matching the emitter radiation spectrum and cell photoresponse; application of the cells with a back side reflector for recycling the sub-band gap photons; and development of low-band gap tandem TPV cells for better utilization of the radiation spectrum. Sunlight concentrator and STPV modules were designed, fabricated, and tested under indoor and outdoor conditions. A cost-effective sunlight concentrator with Fresnel lens was developed as a primary concentrator and a secondary quartz meniscus lens ensured the high concentration ratio of ∼4000×, which is necessary for achieving the high efficiency of the concentrator–emitter system owing to trap escaping radiation. Several types of STPV modules have been developed and tested under concentrated sunlight. Photocurrent density of 4.5A∕cm2 was registered in a photoreceiver based on 1×1cm2GaSb cells under a solar powered tungsten emitter.

Design Optimization of a Solar-Powered Reverse Osmosis Desalination System for Small Communities

2013 ◽  
Author(s):  
Jihun Kim ◽  
Karim Hamza ◽  
Mohamed El Morsi ◽  
Ashraf O. Nassef ◽  
Sayed Metwalli ◽  
...  
Keyword(s):  
Reverse Osmosis ◽  
Fresh Water ◽  
Energy Resource ◽  
Production Capacity ◽  
Water Desalination ◽  
Battery Storage ◽  
Water Stream ◽  
Permeable Membrane ◽  
Small Communities ◽  
Solar Powered

Fresh water availability is essential for the economic development in small communities in remote areas. In desert climate, where naturally occurring fresh water is scarce, seawater or brackish water from wells is often more abundant. Since water desalination approaches are energy intensive, a strong motivation exists for the design of cost-effective desalination systems that utilize the abundant renewable energy resource; solar energy. This paper presents an optimization model of a solar-powered reverse osmosis (RO) desalination system. RO systems rely on pumping salty water at high pressure through semi-permeable membrane modules. Under sufficient pressure, water molecules will flow through the membranes, leaving salt ions behind, and are collected in a fresh water stream. Since RO system are primarily powered via electricity, the system model incorporates photovoltaic (PV) panels, and battery storage for smoothing out fluctuations in the PV power output, as well as allowing system operation for a number of hours after sunset. Design variables include sizing of the PV solar collectors, battery storage capacity, as well as the sizing of the RO system membrane module and power elements. The objective is to minimize the cost of unit volume produced fresh water, subject to constraints on production capacity. A genetic algorithm is used to generate and compare optimal designs for two different locations near the Red Sea and Sinai.

scholarly journals Development of Solar Powered Sprinkler Robot Based on Watering Plant Using IOT Approach

2021 ◽  
Vol 2107 (1) ◽  
pp. 012024
Author(s):  
Lim Xin You ◽  
Nordiana Shariffudin ◽  
Mohd Zamri Hasan
Keyword(s):  
Renewable Energy ◽  
Solar Energy ◽  
System Analysis ◽  
Tracking System ◽  
Sprinkler System ◽  
Solar Panel ◽  
Maximum Efficiency ◽  
Solar Tracking ◽  
Solar Tracker ◽  
Solar Powered

Abstract Nowadays, solar energy’s popularity is growing consistently every year, along with the growth of amazing solar technologies, which is considered to be one of the most popular. Non-renewable energy like petrol and gasoline is being replaced with solar energy, which is renewable energy. The main objective of this project is to design and simulate a robot solar system. The robot is developed using Arduino Mega 2560 as the main brain of the system. This system is equipped with a solar tracking system to track the movement of the sun and LDR is used to detect the presence of sunlight. The solar tracker is used to get the maximum efficiency of solar energy and reduce power losses. In addition, the solar tracker can rotate from 0° - 180°, which is the best angle for the solar panel to reach the sunlight. This robot will be attached to the sprinkler system to perform the watering process. This robot is developed for use in the agriculture field to reduce the manpower and cost of the watering process. Three analyses will be conducted in this project such as solar panel analysis, Wi-Fi connectivity analysis and sprinkler system analysis. The result shows the solar panel will gain the highest intensity of the sunlight at 12.00 pm and a sunny day compared to the other time and a cloudy day. The maximum range of Wi-Fi connectivity and the water pump, time used to finish the watering process and watering area will be discussed.

Design and Performance of Small Scale Solar Powered Water Desalination Systems, Utilizing Reverse Osmosis

2000 ◽  
Vol 122 (4) ◽  
pp. 170-175 ◽  
Author(s):  
K. B. Franc¸a ◽  
H. M. Laborde ◽  
H. Neff
Keyword(s):  
High Pressure ◽  
Energy Consumption ◽  
Feed Solution ◽  
Water Desalination ◽  
Small Scale ◽  
Feed Water ◽  
High Pressure Pump ◽  
And Performance ◽  
Solar Powered ◽  
Power Needs

A small scale solar powered desalination system has been designed, analyzed, and optimized with regard to power needs and energy consumption. Both quantities scale linearly with the concentration of the total dissolved salt concentration (TDS) in the feed solution. The desalination of brackish water at a TDS value of 3,000 ppm requires an energy of approximately 1.5 kWh/m3. For seawater at a TDS value of 34,000 ppm, this value increases to 9.5 kWh/m3. The selected type of membrane, the system design, and, in particular, the efficiency of the high pressure pump crucially affect energy consumption. The desalination cost also has been estimated for a small scale system that linearly scale with the TDS value of the feed water. [S0199-6231(00)00104-0]

Seven-Point Solar Tracking Control for a Fiber-Optic Daylighting System

2020 ◽  
Vol 143 (2) ◽  
Author(s):  
Rahate Ahmed ◽  
Yeongmin Kim ◽  
Zeeshan ◽  
Muhammad Uzair Mehmood ◽  
Hyun Joo Han ◽  
...  
Keyword(s):  
Tracking Control ◽  
Tracking System ◽  
Weather Conditions ◽  
Fresnel Lens ◽  
Solar Tracking ◽  
Stepper Motors ◽  
Solar Tracker ◽  
Series Of Experiments ◽  
Optical Fiber Cable ◽  
Cloud Effect

Abstract A strategy for precise solar tracking has been developed using feedback signals from seven photosensors in conjunction with the operation of an active daylighting system. The tracking system was composed of a microcontroller, two stepper motors, photosensors, a grooves-in Fresnel lens concentrator, and a glass optical fiber cable. A robust control was implemented using cadmium sulfide (CdS) sensors to track the sun’s path precisely from sunrise to sunset. To avoid the cloud effect, two separate sensors were installed apart from the main tracking sensors. The control system was allowed to track the sun’s position if clouds covered the sky continuously for less than approximately 70 min. To analyze the performance of the solar tracker for daylighting applications, a series of experiments were performed in different weather conditions where the accuracy and effectiveness of the present solar tracking control were confirmed.

High-Efficiency Solar Power Supply Design

2012 ◽  
Vol 605-607 ◽  
pp. 433-437
Author(s):  
Hong Yang ◽  
Wen Qi Huang ◽  
Zhen Fei Wang ◽  
Long Guang Chen ◽  
Yao Yin
Keyword(s):  
Experimental Data ◽  
Power Supply ◽  
High Efficiency ◽  
Incident Angle ◽  
Tracking System ◽  
Fresnel Lens ◽  
Solar Panels ◽  
Solar Module ◽  
Charging System ◽  
Voltage Current Characteristic

In order to improve the efficiency of solar module, we have designed the Fresnel lens concentrated system and charging system, their schematic diagrams are depicted detailed in this paper. The experimental data show that adding Fresnel lens parts can improve the solar panels' power from 130% to 200% and incident angle can affect solar panels' voltage current characteristic deeply. All of these results can give some support to design the tracking system.

scholarly journals Design of a Solar Powered Reverse Osmosis System in Egypt

2021 ◽  
Vol 5 (2) ◽  
pp. 125-140
Author(s):  
Said M. A. Ibrahim ◽  
Ahmed G. M. Shabak
Keyword(s):  
Solar Energy ◽  
Reverse Osmosis ◽  
Saline Water ◽  
Water Desalination ◽  
Solar Irradiation ◽  
Water Demands ◽  
Clean Environment ◽  
Mathematical Equations ◽  
Solar Powered ◽  
The Cost

Scarcity of fresh water, forced many countries to get their water needs, or part of it, by means of saline water desalination. Reverse osmosis (RO) systems are useful tools in this concern. In case the grid electricity is not available or costly, photovoltaic (PV) power is necessary to derive RO systems. The present paper is concerned with providing a methodology for complete sizing and design of a photovoltaic reverse osmosis (PVRO) system in Egypt. Egypt has very favorable solar energy. A computer program was constructed to solve the mathematical equations of the model to get the numerical values. The program is capable of calculating the solar irradiation for any city in Egypt. Calculations and selection of the RO system with all connected pumps, the peak PV power needed, and the actual PV area were performed for different water demands ranging from 1-100 m3/day, and various water total dissolved solids (TDSs) of 5000, 15000, and 30000 mg/l. The cost of the complete PVRO system was also determined. The concern of the paper is related to water desalination and solar energy, which are responsible for our existence. The work also aims toward sustainable and clean environment via utilizing solar energy.

Sign in / Sign up

Export Citation Format

Share Document