Power Quality Investigation of Grid Integrated PV System in Distribution Networks

2018 ◽  
Author(s):  
Sunil Gupta ◽  
Abhishek Gandhar
Keyword(s):  
Power Quality ◽  
Distribution Networks ◽  
Pv System

scholarly journals Power Quality and Performance Analysis of Grid-Connected Solar PV System Based on Recent Grid Integration Requirements

2021 ◽  
Vol 2021 ◽  
pp. 1-14
Author(s):  
Estifanos Abeje Sharew ◽  
Habtemariam Aberie Kefale ◽  
Yalew Gebru Werkie
Keyword(s):  
Power Quality ◽  
High Harmonic ◽  
Harmonic Distortion ◽  
Distribution Networks ◽  
Photovoltaic System ◽  
Solar Pv ◽  
Pv System ◽  
Solar Pv System ◽  
Maximum Penetration ◽  
The Impact

The electrical energy demand is steadily growing, and hence, the integration of photovoltaic system to the distribution networks is also dramatically increasing though it has a significant effect on the network’s power quality. The purpose of this paper is to analyze the impact of solar PV integration on the power quality of distribution networks. The study is conducted using ETAP software, taking one of the radial distribution networks available in Bahir Dar city during the peak of connected loads which has the least voltage profile. Furthermore, the optimal location of the PV in the network is done using particle swarm optimization. Accordingly, the appropriate location of the PV system is determined to be the farthest end bus (bus 34). Also, the impact in terms of voltage and current harmonic distortion on the distribution feeder network is comparatively discussed by comparing the distribution system parameters with different penetration levels of solar PV system. The simulation results obtained demonstrate that high harmonic distortion level is injected correspondingly as the penetration capacity of PV system increased which indicates that the solar PV system should be integrating only up to a maximum possible capacity the network can carry. The integration of the PV system beyond this maximum penetration level causes production of high harmonic distortion which adversely affects the system performance. At the maximum penetration level which allows the acceptable harmonic distortion limit, the total voltage harmonic distortion and current demand distortion are found to be 4.97% and 14.98%, respectively.

scholarly journals An Advanced Control Technique for Power Quality Improvement of Grid-Tied Multilevel Inverter

2021 ◽  
Vol 13 (2) ◽  
pp. 505
Author(s):  
Sumaya Jahan ◽  
Shuvra Prokash Biswas ◽  
Md. Kamal Hosain ◽  
Md. Rabiul Islam ◽  
Safa Haq ◽  
...  
Keyword(s):  
Power Quality ◽  
Harmonic Distortion ◽  
Multilevel Inverter ◽  
Control Technique ◽  
Solar Pv ◽  
Pv System ◽  
Reference Tracking ◽  
Proportional Integral ◽  
Lead Compensator ◽  
Power Quality Improvement

The use of different control techniques has become very popular for controlling the performance of grid-connected photovoltaic (PV) systems. Although the proportional-integral (PI) control technique is very popular, there are some difficulties such as less stability, slow dynamic response, low reference tracking capability, and lower output power quality in solar PV applications. In this paper, a robust, fast, and dynamic proportional-integral resonance controller with a harmonic and lead compensator (PIR + HC + LC) is proposed to control the current of a 15-level neutral-point-clamped (NPC) multilevel inverter. The proposed controlled is basically a proportional-integral resonance (PIR) controller with the feedback of a harmonic compensator and a lead compensator. The performance of the proposed controller is analyzed in a MATLAB/Simulink environment. The simulation result represents admirable performance in terms of stability, sudden load change response, fault handling capability, reference tracking capability, and total harmonic distortion (THD) than those of the existing controllers. The responses of the inverter and grid outlets under different conditions are also analyzed. The harmonic compensator decreases the lower order harmonics of grid voltage and current, and the lead compensator provides the phase lead. It is expected that the proposed controller is a dynamic aspirant in the grid-connected PV system.

A Novel FACTS Based (DDSC) Compensator for Power-Quality Enhancement of L.V. Distribution Feeder with a Dispersed Wind Generator

2006 ◽  
Vol 7 (3) ◽  
Author(s):  
Adel M Sharaf ◽  
Khaled Mohamed Abo-Al-Ez
Keyword(s):  
Power Quality ◽  
Distributed Generation ◽  
Distribution System ◽  
Power Transmission ◽  
Traditional Approach ◽  
Distribution Networks ◽  
System Capacity ◽  
Quality Enhancement ◽  
Wind Generator ◽  
Transmission And Distribution

In a deregulated electric service environment, an effective electric transmission and distribution networks are vital to the competitive environment of reliable electric service. Power quality (PQ) is an item of steadily increasing concern in power transmission and distribution. The traditional approach to overcoming capacity and quality limitations in power transmission and distribution in many cases is the addition of new transmission and/or generating capacity. This, however, may not be practicable or desirable in the real case, for many of reasons. From technical, economical and environmental points of view, there are two important - and most of the time combined - alternatives for building new transmission or distribution networks to enhance the transmission system capacity, and power quality: the Flexible alternating current transmission devices and controllers, and the distributed generation resources near the load centers. The connection of distributed generation to the distribution grid may influence the stability of the power system, i.e. angle, frequency and voltage stability. It might also have an impact on the protection selectivity, and the frequency and voltage control in the system. This paper presents a low cost FACTS based Dynamic Distribution System Compensator (DDSC) scheme for voltage stabilization and power transfer and quality enhancement of the distribution feeders connected to a dispersed wind generator, using MATLAB/ SimPower System simulation tool.

scholarly journals Particle swarm optimization algorithm-based PI inverter controller for a grid-connected PV system

PLoS ONE ◽  
2020 ◽  
Vol 15 (12) ◽  
pp. e0243581
Author(s):  
M. F. Roslan ◽  
Ali Q. Al-Shetwi ◽  
M. A. Hannan ◽  
P. J. Ker ◽  
A. W. M. Zuhdi
Keyword(s):  
Power System ◽  
Power Quality ◽  
Transient Response ◽  
Particle Swarm ◽  
Pi Controller ◽  
Pv System ◽  
Quality Performance ◽  
Three Phase ◽  
Input Parameters ◽  
Utility Grid

The lack of control in voltage overshoot, transient response, and steady state error are major issues that are frequently encountered in a grid-connected photovoltaic (PV) system, resulting in poor power quality performance and damages to the overall power system. This paper presents the performance of a control strategy for an inverter in a three-phase grid-connected PV system. The system consists of a PV panel, a boost converter, a DC link, an inverter, and a resistor-inductor (RL) filter and is connected to the utility grid through a voltage source inverter. The main objective of the proposed strategy is to improve the power quality performance of the three-phase grid-connected inverter system by optimising the proportional-integral (PI) controller. Such a strategy aims to reduce the DC link input voltage fluctuation, decrease the harmonics, and stabilise the output current, voltage, frequency, and power flow. The particle swarm optimisation (PSO) technique was implemented to tune the PI controller parameters by minimising the error of the voltage regulator and current controller schemes in the inverter system. The system model and control strategies were implemented using MATLAB/Simulink environment (Version 2020A) Simscape-Power system toolbox. Results show that the proposed strategy outperformed other reported research works with total harmonic distortion (THD) at a grid voltage and current of 0.29% and 2.72%, respectively, and a transient response time of 0.1853s. Compared to conventional systems, the PI controller with PSO-based optimization provides less voltage overshoot by 11.1% while reducing the time to reach equilibrium state by 32.6%. The consideration of additional input parameters and the optimization of input parameters were identified to be the two main factors that contribute to the significant improvements in power quality control. Therefore, the proposed strategy effectively enhances the power quality of the utility grid, and such an enhancement contributes to the efficient and smooth integration of the PV system.

Sign in / Sign up

Export Citation Format

Share Document