The accuracy of elements concentration determination using the k0-standardization method directly depends on irradiation and measurement parameters including Non-1/E epithermal neutron flux distribution shape α (ϕ epi ≈1/E1+α ) , thermal-to-epithermal neutron flux ratio f, efficiency ε, peak area… In the case of the irradiation position at the rotary rack of the Dalat Nuclear Research Reactor (DNRR), the difference of thermal neutron flux between the bottom (3.54x1012 n.cm-2.s-1) and the top (1.93x1012 n.cm-2.s-1) of the 15 cm aluminum container is up to 45%. Therefore, it is necessary to accurately determine above-mentioned parameters in the sample irradiation position. The present paper deals with the determination of the distribution of thermal neutron flux along the sample irradiation container by using 0.1% Au–Al wire activation technique. The thermal neutron flux was then used to calculate the concentration of elements in the Standard Reference Material 2711a and SMELS type III using k0-INAA method at different positions in the container. The obtained results with the neutron flux correction were found to be in good agreement with the certified values. In conclusion, the proposed technique can be applied for activation analyses without sandwiching flux monitors between samples during irradiations.
DETERMINATION OF THE ABSOLUTE NEUTRON FLUX SPECTRUM IN THE PCTR FAST NEUTRON CAVITY FROM MULTIPLE FOIL ACTIVATION MEASUREMENTS.
