An Experimental Investigation of Natural Convection With Vertical Cylinders in Mercury

1974 ◽  
Vol 96 (4) ◽  
pp. 455-458 ◽  
Author(s):  
L. E. Wiles ◽  
J. R. Welty
Keyword(s):  
Heat Transfer ◽  
Experimental Investigation ◽  
Natural Convection ◽  
Flat Plate ◽  
Convection Heat Transfer ◽  
Vertical Cylinder ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Transfer Coefficients ◽  
Flat Plates

An experimental investigation of laminar natural convection heat transfer from a uniformly heated vertical cylinder immersed in an effectively infinite pool of mercury is described. A correlation was developed for the local Nusselt number as a function of local modified Grashof number for each cylinder. A single equation incorporating the diameter-to-length ratio was formulated that satisfied the data for all three cylinders. An expression derived by extrapolation of the results to zero curvature (the flat plate condition) was found to agree favorably with others’ work, both analytical and experimental. The influence of curvature upon the heat transfer was found to be small but significant. It was established that the effective thermal resistance through the boundary layer is less for a cylinder of finite curvature than for a flat plate. Consequently, local heat transfer coefficients for cylinders are larger than those for flat plates operating under identical conditions.

Natural Convection Heat Transfer From a Staggered Vertical Plate Array

1993 ◽  
Vol 115 (4) ◽  
pp. 938-945 ◽  
Author(s):  
G. Tanda
Keyword(s):  
Heat Transfer ◽  
Natural Convection ◽  
Vertical Plate ◽  
Convection Heat Transfer ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Natural Convection Heat Transfer ◽  
Convection Heat ◽  
Transfer Coefficients ◽  
Heat Transfer Coefficients

An experimental study was performed to evaluate the natural convection heat transfer characteristics of an array of four staggered vertical plates. The thermal input at each plate was the same or differed from plate to plate depending on various heating modes. The effects of the interplate spacing and the plate-to-ambient temperature difference were investigated. The experiments were performed in air. Convective interactions among the plates were identified by examining the per-plate heat transfer coefficients and the local heat transfer coefficients along the vertical sides of plates. Local heat transfer results were obtained by means of the schlieren quantitative technique. Comparison of local heat transfer coefficients along the plate assembly with those of a continuous vertical plate (having the same height) showed enhancements up to a factor of two. Comparison of average heat transfer results with those for a parallel plate channel having the same exchanger size showed only little reductions in heat transfer rate, despite a 28 percent reduction in heat transfer area, with enhancements, in terms of specific heat flux, up to 30 percent.

An Experimental Study of Natural Convection Heat Transfer in Concentric and Eccentric Horizontal Cylindrical Annuli

1978 ◽  
Vol 100 (4) ◽  
pp. 635-640 ◽  
Author(s):  
T. H. Kuehn ◽  
R. J. Goldstein
Keyword(s):  
Heat Transfer ◽  
Experimental Study ◽  
Natural Convection ◽  
Convection Heat Transfer ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Natural Convection Heat Transfer ◽  
Convection Heat ◽  
Transfer Coefficients ◽  
Laminar Convection

An experimental study has been conducted to determine the influence of eccentricity and Rayleigh number on natural convection heat transfer through a fluid bounded by two horizontal isothermal cylinders. Eccentricity of the inner cylinder substantially alters the local heat transfer on both cylinders, but the overall heat transfer coefficients change by less than 10 percent over the range of eccentricities investigated. Heat transfer results using the concentric geometry are given for Rayleigh numbers from 2.2 × 102 to 7.7 × 107 which includes regions of conduction, laminar convection, and partially turbulent convection.

Time-Resolved Heat Transfer and Fluid Dynamic Analysis of Natural Convection From Isothermal Horizontal Cylinders

2010 ◽  
Author(s):  
Tim Persoons ◽  
Ian M. O. Gorman ◽  
Gerry Byrne ◽  
Darina B. Murray
Keyword(s):  
Heat Transfer ◽  
Natural Convection ◽  
Fluid Dynamic ◽  
Vertical Cylinder ◽  
Local Heat Transfer ◽  
Temporal Analysis ◽  
Local Heat ◽  
Operating Conditions ◽  
Thermal Plume ◽  
Horizontal Cylinders

This paper discusses the close coupling between fluid dynamics and local natural convection heat transfer rates from a pair of isothermally heated horizontal cylinders submerged in water. The presence of a second heated cylinder induces heat transfer enhancements of up to 10%, and strong fluctuations in local heat transfer rate. Therefore specific attention is focused on how the local heat transfer characteristics of the upper cylinder are affected by buoyancy induced fluid flow from the lower cylinder. The paper investigates a range of Rayleigh number between 2·106 and 6·106, and a vertical cylinder spacing between 2D and 4D. Simultaneous local heat flux measurements and flow velocity measurements using particle image velocimetry reveal oscillatory behaviour of the thermal plume, depending on operating conditions. A joint temporal analysis of the data has provided new insights into the governing mechanisms, which enables further optimisation of the heat transfer performance.

Temperature Distributions in Laminar Flat Plate Shear Flow

1968 ◽  
Vol 90 (1) ◽  
pp. 32-36 ◽  
Author(s):  
A. F. Emery ◽  
K. F. Brettman
Keyword(s):  
Heat Transfer ◽  
Flat Plate ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Transfer Coefficients ◽  
Shearing Flow ◽  
Heat Transfer Coefficients ◽  
Temperature Distributions ◽  
High Shearing ◽  
The Heat Transfer Coefficient

An approximate solution to the heat transfer coefficient on a flat plate in a linear shearing flow is given. It is shown that high shearing rates may significantly increase the local heat transfer coefficients.

Impairment of Local Heat Transfer of the Turbulent Mixed Convection in a Vertical Flat Plate

2018 ◽  
Author(s):  
Myeong-Seon Chae ◽  
Bum-Jin Chung
Keyword(s):  
Heat Transfer ◽  
Mass Transfer ◽  
Mixed Convection ◽  
Flat Plate ◽  
Forced Convection ◽  
Convection Heat Transfer ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Convection Heat ◽  
Vertical Flat Plate

The heat transfer of the buoyancy-aided turbulent mixed convective flow in a vertical flat plate was investigated experimentally. Mass transfer experiments were carried out based on the heat and mass transfer analogy. The Rayleigh numbers ranged from 1.69 × 108 to 2.11 × 1013, depending on the height of the vertical flat plate. The Reynolds numbers varied from 4,585 to 17,320 for turbulent regimes. The test results for turbulent forced convections agreed well with the forced convection correlations established by Petukhov et al. The local heat transfer rates of the turbulent mixed flow exhibited the impairment of heat transfer compared to the forced convection and non-monotonous behavior along the axial position due to buoyancy effect. The local minimum heat transfer was 38.6% lower than the forced convection heat transfer. The turbulent mixed convection heat transfer is affected by the height of vertical plate.

scholarly journals Turbulent Natural Convection from a Vertical Plane Surface

1968 ◽  
Vol 90 (1) ◽  
pp. 1-6 ◽  
Author(s):  
R. Cheesewright
Keyword(s):  
Heat Transfer ◽  
Boundary Layer ◽  
Natural Convection ◽  
Vertical Plane ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Convection Boundary Layer ◽  
Transfer Coefficients ◽  
Turbulent Natural Convection ◽  
Heat Transfer Coefficients

The paper reports the results of an experimental investigation which was intended to clarify the present uncertain position with regard to the distributions of mean temperature and mean velocity in a turbulent natural-convection boundary layer. Data reported for the turbulent boundary layer for Grashof numbers between 1010 and 1011 include local heat transfer coefficients as well as temperatures and velocities. Local heat transfer coefficients and temperature distributions are also reported for the laminar and transitional boundary-layer regions. Results are compared with other experimental data and with theoretical predictions.

Forced Convection Heat Transfer From a Uniformly Heated Sphere

1962 ◽  
Vol 84 (2) ◽  
pp. 133-140 ◽  
Author(s):  
W. S. Brown ◽  
C. C. Pitts ◽  
G. Leppert
Keyword(s):  
Heat Transfer ◽  
Heat Transfer Coefficient ◽  
Transfer Coefficient ◽  
Convection Heat Transfer ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Sphere Diameter ◽  
Transfer Coefficients ◽  
Number Range ◽  
Average Heat

An approximate analytical solution is presented for the variation of the local heat-transfer coefficient over the forward half of a uniformly heated sphere. Experimental measurements with water over a Reynolds number range of 5000 to 480,000 and a Prandtl number range of 2.2 to 6.8 give local coefficients which are in good agreement with analytical results. Average heat-transfer coefficients for the uniformly heated sphere are slightly higher than similar results reported earlier [1] for an isothermal sphere. The effect of variations of heat flux on the average heat-transfer coefficient is correlated in a manner similar to that which was used for the isothermal data. Three different duct sizes were used in the experiment to determine the effect of this variable, and the correlations which are presented are based on duct-to-sphere diameter ratios of 2, 2.67, and 4.

scholarly journals CFD Calculation of Internal Natural Convection in the Annulus Between Horizontal Concentric Cylinders

2003 ◽  
Author(s):  
Stephen W. Webb ◽  
Nicholas D. Francis ◽  
Michael T. Itamura ◽  
Darryl L. James
Keyword(s):  
Heat Transfer ◽  
Natural Convection ◽  
Convection Heat Transfer ◽  
Turbulence Models ◽  
Local Heat Transfer ◽  
Local Heat ◽  
Wall Functions ◽  
Thermally Induced ◽  
Concentric Cylinders ◽  
Commercial Code

Thermally-induced natural convection heat transfer in the annulus between horizontal concentric cylinders has been studied using the commercial code Fluent. The boundary layers are meshed all the way to the wall because forced convection wall functions are not appropriate. Various oneand two-equation turbulence models have been considered. Overall and local heat transfer rates are compared with existing experimental data.

Numerical Analysis of Local Heat Transfer From a Flat Plate to a Swirling Air Impingining Jet

2006 ◽  
Author(s):  
X. Terry Yan ◽  
Rahul S. Kalvakota
Keyword(s):  
Heat Transfer ◽  
Flat Plate ◽  
Stokes Equations ◽  
Three Dimensional ◽  
Local Heat Transfer ◽  
Impinging Jet ◽  
Local Heat ◽  
Flow Profile ◽  
Transfer Coefficients ◽  
Stagnation Region

Local heat transfer from a flat plate to a swirling circular air impinging jet is investigated numerically. Reynolds Averaged Navier-Stokes equations (RANS) and energy equation are solved for the axisymmetric, three dimensional flow. Eddy-viscosity based turbulence models, RNG and V2F, are used. Non-uniform meshes are used for the three dimensional flows and mesh independent solutions are obtained. The flow Reynolds number, which is based on the jet diameter, is kept at 23,000. In the analysis, local heat transfer coefficients are obtained for different swirl numbers, S = 0.21, 0.35 and 0.47 and jet-to-plate distance, L/D, ranging from 2 to 9. Investigation of the effect of swirl flow profile at the exiting plane of the jet on heat transfer is also presented. It is found that different swirl profiles with the same swirl number lead to very different heat transfer behaviors in the stagnation region of the impinging jet.

Sign in / Sign up

Export Citation Format

Share Document