Co-Gasification of Coal/Biomass Blends in a Pressurized Fluidized-Bed Gasifier: The Advantageous Synergies in the Process

Author(s):  
Guanxing Chen ◽  
Qizhuang Yu ◽  
Claes Brage ◽  
Christer Rosén ◽  
Krister Sjöström

An experimental study on co-gasification of coal and biomass blends in an oxygen-containing atmosphere has been carried out in a pressurized fluidized-bed gasifier. Several different biomass materials including wood and energy crops were used in the study, whereas two coals ranked of bituminite from Poland and UK were used in the investigation. The gasifier used was a Laboratory Development Unit (LDU) with an inner diameter of 144 mm. The operation temperature was 900 °C, and the pressure was 0.4 MPa. The research was part of the European Commission’s APAS and JOULE III clean coal technology programs. The study was focused on possible synergistic effects in the thermochemical treatment of the fuel blends. The char formed was examined. The tar produced in the process was analyzed. The environmentally concerned nitrogen compounds emitted from the process were detected. An unexpected result was that the blends of the fuels and their char formed in situ exhibited higher gasification reaction rate under the studied conditions. The yield of char diminished and consequently the gas production increased. Furthermore, both the formation of tar and nitrogen compounds seemed also affected synergistically in co-gasification process of the fuel blends. The yields of tar and ammonia were lower than expected.

2018 ◽  
Vol 67 ◽  
pp. 02059
Author(s):  
I Nyoman Suprapta Winaya ◽  
I Ketut Gede Wirawan ◽  
I Wayan Arya Darma ◽  
I Putu Lokantara ◽  
Rukmi Sari Hartati

One of the main issues using biomass as fuel in air gasification is the dilution of its product gas by the nitrogen in the air. A dual reactor fluidized bed (DRFB) overcomes this problem in which the gasification and combustion reactions are decoupled and conducted in two separate fluidized bed reactors connected by circulating bed material. The DFRB unit made of 304 stainless steel pipe with a height of 100 and 150 cm, and inner diameters (i.d.) of 15.2 and 5.1 cm for gasifier and combustor respectively. The rice husk as fuel and quartz sand as bed material having the same size of 0.4 - 0.6 mm were applied in this investigation. Since the gasification process is an endothermic reaction, gasification temperatures are varied at 600°C to 700°C while combustion reactor were kept at 600°C using the electric heaters enclosed in ceramic cover. The superficial gas velocity in this study was kept constant at 17 m/s using the external air volumetric flux of the blower flow entering the DRFB loop. Gas gasification samples are then examined by gas chromatography to determine syngas content (CO, CH4 and H2). The test results showed that by the increasing temperature of the gasification reactor there was an increase in syngas especially CO gas conentration. The temperature increases in the gasification reactor (600°C, 650°C, 700°C) is able to increase the endothermic reaction in the gasification process which is dominated by CO gas production. The syngas efficiency was found to increase from 40.95% to 43.77%.as the temperature of the gasification reactor increased.


2021 ◽  
Vol 8 (1) ◽  
Author(s):  
Ahmad F ◽  
◽  
Ahmad N ◽  
Asghar U ◽  
Ali A ◽  
...  

Converting rice husk into energy is a promising method of generating renewable energy and reducing greenhouse gas emissions. In this research rice hush is considered as biomass fuel. The characteristics of rice husk gasification were investigated at an Equivalence Ratio (ER) of 0.25–0.38 and a gasifier temperature of 750-870°C in 20 tons per day (TPD) using steam explosion process in fluidized bed gasifier system. Different operation conditions, temperatures and loads, are investigated for their effects on the compositions, calorific properties, gasification efficiencies of syngas. The effects of the critical parameters, namely, Steam-to-Biomass Ratio (S/B), Particle size variation and gasification temperature on the quality of the product gas as well as the gasifier cold gas efficiency were analyzed. This is the new finding in the research. The optimal conditions of the gasification operation were an ER of 0.20 and gasifier temperature of 800°C. The low heating value of the gas product and cold gas efficiency were 1390kcal/Nm³ and 75%, respectively. After passing the generated gas through the gas cleaning units, it was confirmed that the tar in the product gas was removed with an efficiency of 98%. The cleaned product gas was used for the operation of 420kW, gas engine. Pressure loss often occurred at the bottom of the gasifier during the gasification operation; we found that the agglomerates generated by the gasification process caused it. To prevent the pressure loss caused by the agglomerates, the stable control of temperature inside the gasifier is needed and an ash removal device remove agglomerates should be installed to maintain stable long-term operation. This paper leads towards the production of Syngas and further on the electricity from the rice husk, an eminent biomass, copiously available all around the world. Especially in Pakistan, the rice is used abundantly so the raw material is easily available. The gas is produced using the gasification process in dual fluidized gasifier. It is a wonderful alternative to the natural gas with high calorific value. The sulfur contents are quite less compared to natural gas. It also have a good correlation with environment as flue gases emission is negligible relative to other source like coal, wood, plastic, waste etc. Another benefit of this process is the waste management and pollution control. The results are developed by using the detailed analysis of the process values of plants which is generating electricity by rice husk gasification. We learned, all results revealed that the dual fluidized bed gasification is more economical and efficient method compared to all other methods for commercial scale production of syngas. Results are analyzed which imply that the biomass is more gigantic source which replace the fossil fuels and leads towards the green energy in a more economical way. This paper provides an overview of previous works on combustion and gasification of rice husk in atmospheric fluiuidized bed reactors and summarizes the state of the art knowledge. As the high ash content, low bulk density, p characteristics and low ash melting point makes the other types of reactors like grate furnaces and downdraft gasifers either inefficient or unsuitable for rice husk conversion to energy, the fluiuidized bed reactor seems to be the promising choice. The overview shows that the reported results are from only small bench or lab scale units. Although a combustion efficiency of about 80% can normally be attained; the reported values in the literature, which are more than 95%, seem to be in higher order. Combustion intensity of about 530kg/h/m² is reported. It is also technically feasible to gasify rice husk in a fluidized bed reactor to yield combustible producer gas, even with sufficient heating value for application in internal combustion engines.


2016 ◽  
Vol 30 (9) ◽  
pp. 7277-7283 ◽  
Author(s):  
Xi Zeng ◽  
Yuping Dong ◽  
Fang Wang ◽  
Pengju Xu ◽  
Ruyi Shao ◽  
...  

2016 ◽  
Vol 35 (1) ◽  
pp. 89-101
Author(s):  
C. Lelievre ◽  
C. A. Pickles ◽  
S. Hultgren

AbstractThe gasification of a sub-bituminous coal using CO2–O2 gas mixtures was studied in a plasma-augmented fluidized bed gasifier. Firstly, the coal was chemically characterized and the gasification process was examined using Thermogravimetric and Differential Thermal Analysis (TGA/DTA) in CO2, O2 and at a CO2 to O2 ratio of 3 to 1. Secondly, the equilibrium gas compositions were obtained using the Gibbs free energy minimization method (HSC Chemistry®7). Thirdly, gasification tests were performed in a plasma-augmented fluidized bed and the off-gas temperatures and compositions were determined. Finally, for comparison purposes, control tests were conducted using a conventional fluidized bed coal gasifier and these results were compared to those achieved in the plasma-augmented fluidized bed gasifier. The effects of bed temperature and CO2 to O2 ratio were studied. For both gasifiers, at a given bed temperature, the off-gas compositions were in general agreement with the equilibrium values. Also, for both gasifiers, an experimental CO2 to O2 ratio of about 3 to 1 resulted in the highest syngas grade (%CO + %H2). Both higher off-gas temperatures and syngas grades could be achieved in the plasma-augmented gasifier, in comparison to the conventional gasifier. These differences were attributed to the higher bed temperatures in the plasma-augmented fluidized bed gasifier.


2021 ◽  
Vol 11 (2) ◽  
pp. 579
Author(s):  
Max Schmid ◽  
Selina Hafner ◽  
Günter Scheffknecht

The conversion of biogenic residues to fuels and chemicals via gasification and synthesis processes is a promising pathway to replace fossil carbon. In this study, the focus is set on sewage sludge gasification for syngas production. Experiments were carried out in a 20 kW fuel input bubbling fluidized bed facility with steam and oxygen as gasification agent. In-situ produced sewage sludge ash was used as bed material. The sensitivity of the key operation parameters gasifier temperature, oxygen ratio, steam to carbon ratio, and the space velocity on the syngas composition (H2, CO, CO2, CH4, CxHy, H2S, COS, NH3, and tars) was determined. The results show that the produced syngas has high H2 and CO concentrations of up to 0.37 m3 m−3 and 0.18 m3 m−3, respectively, and is thus suitable for synthesis of fuels and chemicals. By adjusting the steam to carbon ratio, the syngas’ H2 to CO ratio can be purposely tailored by the water gas shift reaction for various synthesis products, e.g., synthetic natural gas (H2/CO = 3) or Fischer–Tropsch products (H2/CO = 2). Also, the composition and yields of fly ash and bed ash are presented. Through the gasification process, the cadmium and mercury contents of the bed ash were drastically reduced. The ash is suitable as secondary raw material for phosphorous or phosphate fertilizer production. Overall, a broad database was generated that can be used for process simulation and process design.


2021 ◽  
Vol 784 (1) ◽  
pp. 012033
Author(s):  
Xuefeng Li ◽  
Zhenhua Yan ◽  
Qingping Zhang ◽  
Bo Gao ◽  
Hao Chen ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document