Simulation of Fluid Flow Through a Granular Bed

2006 ◽  
Author(s):  
Arezou Jafari ◽  
S. Mohammad Mousavi
Keyword(s):  
Stokes Equations ◽  
Numerical Study ◽  
Fluid Velocity ◽  
Three Dimensional ◽  
Packed Bed ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Wide Range ◽  
Duct Geometry ◽  
Flow Through

Numerical study of flow through random packing of non-overlapping spheres in a cylindrical geometry is investigated. Dimensionless pressure drop has been studied for a fluid through the porous media at moderate Reynolds numbers (based on pore permeability and interstitial fluid velocity), and numerical solution of Navier-Stokes equations in three dimensional porous packed bed illustrated in excellent agreement with those reported by Macdonald [1979] in the range of Reynolds number studied. The results compare to the previous work (Soleymani et al., 2002) show more accurate conclusion because the problem of channeling in a duct geometry. By injection of solute into the system, the dispersivity over a wide range of flow rate has been investigated. It is shown that the lateral fluid dispersion coefficients can be calculated by comparing the concentration profiles of solute obtained by numerical simulations and those derived analytically by solving the macroscopic dispersion equation for the present geometry.

Numerical Study of the Pulsating Flow at the Tongue Region of a Centrifugal Pump for Several Flow Rates

2008 ◽  
Author(s):  
Rau´l Barrio ◽  
Jorge Parrondo ◽  
Eduardo Blanco ◽  
Joaqui´n Ferna´ndez
Keyword(s):  
Unsteady Flow ◽  
Centrifugal Pump ◽  
Stokes Equations ◽  
Numerical Study ◽  
Three Dimensional ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Numerical Predictions ◽  
Partial Load ◽  
Flow Through

A numerical study is presented on the unsteady flow at the tongue region of a single suction volute-type centrifugal pump with a specific speed of 0.46. The flow through the pump, available at laboratory, was simulated by means of a commercial CFD software that solved the Reynolds averaged Navier-Stokes equations for three-dimensional unsteady flow (3D-URANS). A sensitivity analysis of the numerical model was carried out and the numerical predictions were compared with previous experimental results of both global and unsteady variables. Once validated, the model was used to study the flow pulsations associated to the interaction between the impeller blades and the volute tongue as a function of the flow rate, from partial load to overload. The study allowed relating the passage of the impeller blades with the tangential and radial velocity pulsations at some reference positions and with the pressure pulsations at the tongue region.

scholarly journals Dynamics of Single Droplet Splashing on Liquid Film by Coupling FVM with VOF

Processes ◽  
2021 ◽  
Vol 9 (5) ◽  
pp. 841
Author(s):  
Yuzhen Jin ◽  
Huang Zhou ◽  
Linhang Zhu ◽  
Zeqing Li
Keyword(s):  
Liquid Film ◽  
Weber Number ◽  
Stokes Equations ◽  
Numerical Study ◽  
Three Dimensional ◽  
Navier Stokes ◽  
Single Droplet ◽  
Navier Stokes Equations ◽  
Volume Method ◽  
The Relationship

A three-dimensional numerical study of a single droplet splashing vertically on a liquid film is presented. The numerical method is based on the finite volume method (FVM) of Navier–Stokes equations coupled with the volume of fluid (VOF) method, and the adaptive local mesh refinement technology is adopted. It enables the liquid–gas interface to be tracked more accurately, and to be less computationally expensive. The relationship between the diameter of the free rim, the height of the crown with different numbers of collision Weber, and the thickness of the liquid film is explored. The results indicate that the crown height increases as the Weber number increases, and the diameter of the crown rim is inversely proportional to the collision Weber number. It can also be concluded that the dimensionless height of the crown decreases with the increase in the thickness of the dimensionless liquid film, which has little effect on the diameter of the crown rim during its growth.

scholarly journals Numerical Study on the Solid Fuel Rocket Scramjet Combustor with Cavity

Energies ◽  
2019 ◽  
Vol 12 (7) ◽  
pp. 1235 ◽  
Author(s):  
Chaolong Li ◽  
Zhixun Xia ◽  
Likun Ma ◽  
Xiang Zhao ◽  
Binbin Chen
Keyword(s):  
Solid Fuel ◽  
Stokes Equations ◽  
Numerical Study ◽  
Three Dimensional ◽  
Combustion Efficiency ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Particle Combustion ◽  
Scramjet Combustor ◽  
Cavity Configuration

Scramjet based on solid propellant is a good supplement for the power device of future hypersonic vehicles. A new scramjet combustor configuration using solid fuel, namely, the solid fuel rocket scramjet (SFRSCRJ) combustor is proposed. The numerical study was conducted to simulate a flight environment of Mach 6 at a 25 km altitude. Three-dimensional Reynolds-averaged Navier–Stokes equations coupled with shear stress transport (SST) k − ω turbulence model are used to analyze the effects of the cavity and its position on the combustor. The feasibility of the SFRSCRJ combustor with cavity is demonstrated based on the validation of the numerical method. Results show that the scramjet combustor configuration with a backward-facing step can resist high pressure generated by the combustion in the supersonic combustor. The total combustion efficiency of the SFRSCRJ combustor mainly depends on the combustion of particles in the fuel-rich gas. A proper combustion organization can promote particle combustion and improve the total combustion efficiency. Among the four configurations considered, the combustion efficiency of the mid-cavity configuration is the highest, up to about 70%. Therefore, the cavity can effectively increase the combustion efficiency of the SFRSCRJ combustor.

Fluid Flow and Lateral Fluid Dispersion in Bounded Granular Beds

2002 ◽  
Author(s):  
Azita Soleymani ◽  
Eveliina Takasuo ◽  
Piroz Zamankhan ◽  
William Polashenski
Keyword(s):  
Reynolds Number ◽  
Porous Media ◽  
Numerical Solutions ◽  
Stokes Equations ◽  
Numerical Study ◽  
Fluid Velocity ◽  
Three Dimensional ◽  
Numerical Results ◽  
Transition To Turbulence ◽  
Wide Range

Results are presented from a numerical study examining the flow of a viscous, incompressible fluid through random packing of nonoverlapping spheres at moderate Reynolds numbers (based on pore permeability and interstitial fluid velocity), spanning a wide range of flow conditions for porous media. By using a laminar model including inertial terms and assuming rough walls, numerical solutions of the Navier-Stokes equations in three-dimensional porous packed beds resulted in dimensionless pressure drops in excellent agreement with those reported in a previous study (Fand et al., 1987). This observation suggests that no transition to turbulence could occur in the range of Reynolds number studied. For flows in the Forchheimer regime, numerical results are presented of the lateral dispersivity of solute continuously injected into a three-dimensional bounded granular bed at moderate Peclet numbers. Lateral fluid dispersion coefficients are calculated by comparing the concentration profiles obtained from numerical and analytical methods. Comparing the present numerical results with data available in the literature, no evidence has been found to support the speculations by others for a transition from laminar to turbulent regimes in porous media at a critical Reynolds number.

scholarly journals Hydrodynamic Effects Produced by Submerged Breakwaters in a Coastal Area with a Curvilinear Shoreline

2019 ◽  
Vol 7 (10) ◽  
pp. 337 ◽  
Author(s):  
Francesco Gallerano ◽  
Giovanni Cannata ◽  
Federica Palleschi
Keyword(s):  
Coastal Area ◽  
Stokes Equations ◽  
Numerical Study ◽  
Three Dimensional ◽  
Integral Form ◽  
Navier Stokes ◽  
Hydrodynamic Effect ◽  
Riemann Solver ◽  
Three Dimensional Model ◽  
Navier Stokes Equations

A three-dimensional numerical study of the hydrodynamic effect produced by a system of submerged breakwaters in a coastal area with a curvilinear shoreline is proposed. The three-dimensional model is based on an integral contravariant formulation of the Navier-Stokes equations in a time-dependent curvilinear coordinate system. The integral form of the contravariant Navier-Stokes equations is numerically integrated by a finite-volume shock-capturing scheme which uses Monotonic Upwind Scheme for Conservation Laws Total Variation Diminishing (MUSCL-TVD) reconstructions and an Harten Lax van Leer Riemann solver (HLL Riemann solver). The numerical model is used to verify whether the presence of a submerged coastal defence structure, in the coastal area with a curvilinear shoreline, is able to modify the wave induced circulation pattern and the hydrodynamic conditions from erosive to accretive.

Improved κ-ɛ Modelling of Impeller Flow Performance of a Mixed-Flow Pump under off-Design Operating States

1993 ◽  
Vol 207 (4) ◽  
pp. 219-229 ◽  
Author(s):  
S M Fraser ◽  
Y Zhang
Keyword(s):  
Stokes Equations ◽  
Three Dimensional ◽  
Careful Analysis ◽  
Navier Stokes ◽  
Mean Flow ◽  
Mixed Flow ◽  
Navier Stokes Equations ◽  
Flow Through ◽  
The Mean ◽  
Flow Pump

Three-dimensional turbulent flow through the impeller passage of a model mixed-flow pump has been simulated by solving the Navier-Stokes equations with an improved κ-ɛ model. The standard κ-ɛ model was found to be unsatisfactory for solving the off-design impeller flow and a converged solution could not be obtained at 49 per cent design flowrate. After careful analysis, it was decided to modify the standard κ-ɛ model by including the extra rates of strain due to the acceleration of impeller rotation and geometrical curvature and removing the mathematical ill-posedness between the mean flow turbulence modelling and the logarithmic wall function.

Numerical Study on Impeller Performance of Mini Hydro Turbine

2015 ◽  
Vol 772 ◽  
pp. 552-555 ◽  
Author(s):  
Kyu Han Kim ◽  
Joni Cahyono
Keyword(s):  
Stokes Equations ◽  
Numerical Study ◽  
Flow Behavior ◽  
Three Dimensional ◽  
Horizontal Axis ◽  
Navier Stokes ◽  
Navier Stokes Equations ◽  
Hydro Turbine ◽  
Pressure Distributions ◽  
Power Outputs

The aim of this paper is to numerically explore the feasibility of designing a Mini-Hydro turbine. The interest for this kind of horizontal axis turbine relies on its versatility. In the present study, the numerical solution of the discredited three-dimensional, incompressible Navier-Stokes equations over an unstructured grid is accomplished with an ANSYS program. In this study, a mini hydro turbine (3kW) has been considered for utilization of horizontal axis impeller. The turbine performance and flow behavior have been evaluated by means of numerical simulations. Moreover, the performance of the impeller varied in the pressure distribution, torque, rotational speed and power generated by the different number of blades and angles. The results trends are similar between the highest pressure distributions at the impeller also produced highest power outputs on 6 numbers of blades at impeller. The model has been validated, comparing numerical results with available experimental data.

Lift, drag and added mass of a hemispherical bubble sliding and growing on a wall in a viscous linear shear flow

2008 ◽  
Vol 366 (1873) ◽  
pp. 2233-2248 ◽  
Author(s):  
Dominique Legendre ◽  
Catherine Colin ◽  
Typhaine Coquard
Keyword(s):  
Shear Flow ◽  
Stokes Equations ◽  
Three Dimensional ◽  
Added Mass ◽  
Unsteady Motion ◽  
Navier Stokes ◽  
Mass Force ◽  
Navier Stokes Equations ◽  
Wide Range ◽  
Linear Shear

The three-dimensional flow around a hemispherical bubble sliding and growing on a wall in a viscous linear shear flow is studied numerically by solving the full Navier–Stokes equations in a boundary-fitted domain. The main goal of the present study is to provide a complete description of the forces experienced by the bubble (drag, lift and added mass) over a wide range of sliding and shear Reynolds numbers (0.01≤ Re b , Re α ≤2000) and shear rate (0≤ Sr ≤5). The drag and lift forces are computed successively for the following situations: an immobile bubble in a linear shear flow; a bubble sliding on the wall in a fluid at rest; and a bubble sliding in a linear shear flow. The added-mass force is studied by considering an unsteady motion relative to the wall or a time-dependent radius.

Sign in / Sign up

Export Citation Format

Share Document