scholarly journals Computational Fluid Dynamics-Based Estimation of Blood Flow Rate in Doppler Analysis: In Vivo Validation by Means of Phase Contrast Magnetic Resonance Imaging

Author(s):  
Raffaele Ponzini ◽  
Christian Vergara ◽  
Giovanna Rizzo ◽  
Alessandro Veneziani ◽  
Alberto Redaelli ◽  
...  

In this work we carry out an in vivo validation of a method for estimating blood flow rate from the peak velocity, as it is usually done in single-wire Doppler catheter measurements. This method, originally proposed in [1] stems from the application of numerical analysis of the blood flow with Computational Fluid Dynamics (CFD) techniques. It proposes a new formula linking the maximum velocity and the flow rate, which, however, has the same practical cost of classical approaches based on a priori assumptions on the velocity profile. After the first clinical observations indicating the improved accuracy in flow rate estimates introduced by the new method discussed in [2, 3], in this paper we present an ad hoc in vivo validation, as firstly suggested in [4], still confirming the reliability of the new approach.

2019 ◽  
Vol 40 (2) ◽  
pp. 264-272
Author(s):  
Szu-Hsien Chou ◽  
Kuan-Yu Lin ◽  
Zhen-Ye Chen ◽  
Chun-Jung Juan ◽  
Chien-Yi Ho ◽  
...  

Abstract Purpose The aim of this study was to use the computational fluid dynamics (CFD) method, patient-specific electrocardiogram (ECG) signals, and computed tomography three-dimensional image reconstruction technique to investigate the blood flow in coronary arteries during cardiac arrhythmia. Methods Two patients with premature ventricular contraction-type cardiac arrhythmia and one with atrial fibrillation-type cardiac arrhythmia were investigated. The inlet velocity of the coronary artery in simulation was applied with the measured velocity profile of the left ventricular outflow tract (LVOT) from the Doppler echocardiography. The measured patient central aortic blood pressure waveform was employed for the coronary artery outlet in simulation. The no-slip boundary condition was applied to the arterial wall. Results For the patient with irregular cardiac rhythms (Case I), the coronary blood flow rate under the shortened and lengthened cardiac rhythms were 0.66 and 0.96 mL/s, respectively. In Case II, the maximum velocity at the LVOT under a normal heartbeat was found to be 101 cm/s, whereas the average value was 73 cm/s. In Case III, the patient was also diagnosed with a congenital stenosis problem at the myocardial bridge (MCB) at the LAD. The measured blood flow rate at the MCB of the LAD for the three heartbeats in Case III was found to be 0.68, 1.08, and 1.14 mL/s. Conclusion The integration of patient-specific ECG signals and image-based CFD methods can clearly analyze hemodynamic information for patients during cardiac arrhythmia. The cardiac arrhythmia can reduce the blood flow in the coronary arteries.


Author(s):  
M. Elkhoury ◽  
N. Youssef ◽  
C. Issa

In this study, FLUENT (computational fluid dynamics software) is utilized to compare the performance of three widely used hemodialysis catheters, Niagara double lumen, Flexxicon II double lumen and Hemosplit long-term catheters of BARD Access Systems, in terms of blood flow rate and shorter exposure time. Running the three models at a fixed blood flow rate of 300 ml/min, it is found that Niagara catheter displays the lowest shear rates, yet high enough to induce thrombosis, which occurs as a result of platelet aggregation. High vorticity magnitudes exceeding 50,000s−1 are detected near the venous luminal walls of the Hemosplit catheter rendering the formation of Hemolysis which causes free toxic hemoglobin to circulate in the blood stream. Furthermore, the highest shear rates are found to occur at the arterial inlet, downstream the openings where inflow of blood occurs. It was found that the Niagara catheter, with open side holes, is the most recommended among the three considered catheters.


2010 ◽  
Vol 57 (7) ◽  
pp. 1807-1815 ◽  
Author(s):  
Raffaele Ponzini ◽  
Christian Vergara ◽  
Giovanna Rizzo ◽  
Alessandro Veneziani ◽  
Alberto Roghi ◽  
...  

2021 ◽  
Author(s):  
George Hyde-Linaker ◽  
Pauline Hall Barrientos ◽  
Sokratis Stoumpos ◽  
Asimina Kazakidi

Abstract Despite arteriovenous fistulae (AVF) being the preferred vascular access for haemodialysis, high primary failure rates (30-70%) and low one-year patency rates (40-70%) hamper their use. The haemodynamics within the vessels of the fistula change significantly following surgical creation of the anastomosis and can be a surrogate of AVF success or failure. Computational fluid dynamics (CFD) can crucially predict AVF outcomes through robust analysis of a fistula’s haemodynamic patterns, which is impractical in-vivo. We present a proof-of-concept CFD framework for characterising the AVF blood flow prior and following surgical creation of a successful left radiocephalic AVF in a 20-year-old end-stage kidney disease patient. The reconstructed vasculature was generated utilising multiple contrast-enhanced magnetic resonance imaging (MRI) datasets. Large eddy simulations were conducted for establishing the extent of arterial and venous remodelling. Following anastomosis creation, a significant 2-3-fold increase in blood flow rate was induced downstream of the left subclavian artery. This was validated through comparison with post-AVF patient-specific phase-contrast data. The increased flow rate yielded an increase in time-averaged wall shear stress (TAWSS), a key marker of adaptive vascular remodelling. We have demonstrated TAWSS and oscillatory shear distributions of the transitional-flow in the venous anastomosis are predictive of AVF remodelling.


Author(s):  
Dooyoung Lee ◽  
Kuldeepsinh Rana ◽  
Karin Lee ◽  
Lisa A. DeLouise ◽  
Michael R. King

In previous work, we have described the adhesive capture of circulating stem cells to surfaces coated with adhesive selectin protein, both in vitro and in vivo. Here we describe PDMS surfaces microfabricated to contain an array of square 80 × 80 × 80 micron cavities. These cavities are intended to provide a local bioreactor environment to culture stem cells over extended periods of time, while sheltered from the higher shear stresses of the surrounding blood flow external of the cavities. In this paper we present in vitro flow experiments with polymeric, blood cell-sized microspheres, showing the creation of stable vortices within the microscale cavities. Computational fluid dynamics (CFD) was performed to predict the velocity field within the cavity, and for comparison with experimentally determined microsphere velocities. Future work will establish the ability to place local chemoattract molecules within the cavity interior, and the ability to accumulate viable stem cells within these cavities.


1992 ◽  
Vol 262 (4) ◽  
pp. H1156-H1163 ◽  
Author(s):  
G. R. Cokelet ◽  
I. H. Sarelius

Microscopic images of blood flow through individual capillary segments and divergent capillary bifurcations in cremaster muscle of golden hamster were videotaped, and the data from the videotapes (projected vessel image width and individual red cell velocities) were used in two ways to evaluate blood flow rate. The first method assumes 1) that the vessel lumen is circular with a diameter equal to the projected image width and 2) that the blood average velocity is proportional to the average red cell velocity. The second method makes neither of these assumptions but relies only on the principle of mass conservation. It is demonstrated that the two assumptions of the first method can lead to significant errors in hemodynamic relationships deduced from in vivo data. Although the second method cannot independently give absolute values of average velocity at one vessel location, it can give absolute values of the ratio of blood flow rates through two (or more) vascular lumina.


1980 ◽  
Vol 238 (4) ◽  
pp. H553-H560
Author(s):  
E. M. Cornford ◽  
L. D. Braun ◽  
W. M. Pardridge ◽  
W. H. Oldendorf

Author(s):  
X Y Xu ◽  
M W Collins

The local blood flow in arteries, especially at bends and bifurcations, is correlated with the distribution of atherosclerotic lesions. The flow is three-dimensional, unsteady and difficult to measure in vivo. In this paper a numerical treatment of blood flow in general three-dimensional arterial bifurcations is presented. The flow is assumed to be laminar and incompressible, the blood non-Newtonian and the vessel wall rigid. The three-dimensional time-dependent Navier-Stokes equations are employed to describe the flow, and a newly developed computational fluid dynamics (CFD) code AST EC based on finite volume methods is used to solve the equations. A comprehensive range of code validations has been carried out. Good agreement between numerical predictions and in vitro model data is demonstrated, but the correlation with in vivo measurements is less satisfactory. Effects of the non-Newtonian viscosity have also been investigated. It is demonstrated that differences between Newtonian and non-Newtonian flows occur mainly in regions of flow separation. With the non-Newtonian fluid, the duration of flow separation is shorter and the reverse flow is weaker. Nevertheless, it does not have significant effects on the basic features of the flow field. As for the magnitude of wall shear stress, the effect of non-Newtonian viscosity might not be negligible.


2019 ◽  
Vol 40 (Supplement_1) ◽  
Author(s):  
L Swanson ◽  
B Owen ◽  
A Revell ◽  
M Ngoepe ◽  
A Keshmiri ◽  
...  

Abstract Background Tetralogy of Fallot (ToF) and coarctation of the aorta (CoA) each constitute approximately 7% of congenital heart disease (CHD) births worldwide. Compared to developed countries, developing countries have a disparate level of access to prompt diagnosis and treatment for these diseases. Computational fluid dynamics (CFD) approaches implemented on routinely available non-invasive imaging data may yield low-cost improvements to the management of these patients. Purpose The purpose of this research is to develop a patient-specific computational pipeline that allows the modelling of blood flow in diseased arteries of patients suffering from ToF and CoA. The project aims to prove the feasible use of broadly available imaging techniques - CT angiograms (CTA) and echocardiographs (echo) - for achieving this in low-to-middle income countries. The capability of the pipeline will be demonstrated through a qualitative study of the effects of different systemic to pulmonary shunt configurations used in the palliative treatment of ToF. In addition, the effects of idealised stent configurations on the blood flow through the aorta of a patient with CoA will be studied. Methods A retrospective search through the hospital database was conducted to select suitable CTA data for a CoA and ToF case. Data for patient A, a five-month-old child with typical CoA, and patient B, a twelve-month-old child with typical ToF who had a central shunt in place, was found. Echo data was obtained for patient A through an investigation protocol which focused on CFD application whereas there was no echo data available for patient B. As a result, idealised volume flow rate data was implemented for patient B. Geometries for patient A and patient B were extracted and volume discretisation was implemented for grid independence testing. The Navier-Stokes governing equations for fluid flow were solved using the open source software, OpenFOAM, for the transient case where inlet volume flow rate was defined for four cardiac cycles. Figure 1 shows key features of the flow in the shunt and pulmonary branches (A), the aortic arch (B), the inlet at the ascending aorta (C) and the descending aorta (D) for the geometry extracted from the data set of patient B. Figure 1. Key flow features of patient B Results and discussion We have implemented CFD models which are able to qualitatively assess the favourable or unfavourable impact of different approaches to ToF and CoA repairs on the characteristics of blood flow in the aorta and pulmonary arteries. An echo investigation protocol has been developed and successfully applied. CTA studies have been shown as feasible sources of geometry data in spite of the restriction on quality by the important requirement for low doses of radiation in paediatric patients. This project represents progress towards an advanced tool that may be broadly implemented in both well-resourced and minimally-resourced hospitals. Acknowledgement/Funding National Research Fund, British Heart Foundation, Newton Fund (UK MRC, South African Medical Research Council), University of Cape Town


Sign in / Sign up

Export Citation Format

Share Document