Imaging performance of a thin Lu2O3:Eu nanophosphor scintillating screen coupled to a high resolution CMOS sensor under X-ray radiographic conditions: comparison with Gd2O2S:Eu conventional phosphor screen

2014 ◽  
Author(s):  
I. Seferis ◽  
C. Michail ◽  
I. Valais ◽  
J. Zeler ◽  
P. Liaparinos ◽  
...  
Keyword(s):  
High Resolution ◽  
X Ray ◽  
Phosphor Screen ◽  
Cmos Sensor ◽  
Imaging Performance

Imaging performance of a high resolution CMOS sensor under Mammographic and Radiographic conditions

2010 ◽  
Author(s):  
Christos M. Michail ◽  
Vasiliki B. Spyropoulou ◽  
George P. Fountos ◽  
Nektarios E. Kalyvas ◽  
Alexandros K. Mytafidis ◽  
...  
Keyword(s):  
High Resolution ◽  
Cmos Sensor ◽  
Imaging Performance

scholarly journals On the Response of a Micro Non-Destructive Testing X-ray Detector

Materials ◽  
2021 ◽  
Vol 14 (4) ◽  
pp. 888
Author(s):  
Dionysios Linardatos ◽  
Vaia Koukou ◽  
Niki Martini ◽  
Anastasios Konstantinidis ◽  
Athanasios Bakas ◽  
...  
Keyword(s):  
Performance Metrics ◽  
Coefficient Of Determination ◽  
Noise Power ◽  
Modulation Transfer ◽  
Destructive Testing ◽  
Transfer Property ◽  
X Ray ◽  
Cmos Sensor ◽  
Imaging Performance ◽  
Pixel Pitch

Certain imaging performance metrics are examined for a state-of-the-art 20 μm pixel pitch CMOS sensor (RadEye HR), coupled to a Gd2O2S:Tb scintillator screen. The signal transfer property (STP), the modulation transfer function (MTF), the normalized noise power spectrum (NNPS) and the detective quantum efficiency (DQE) were estimated according to the IEC 62220-1-1:2015 standard. The detector exhibits excellent linearity (coefficient of determination of the STP linear regression fit, R2 was 0.9978), while its DQE peaks at 33% and reaches 10% at a spatial frequency of 3 cycles/mm, for the measured with a Piranha RTI dosimeter (coefficient of variation CV = 0.03%) exposure value of 28.1 μGy DAK (detector Air Kerma). The resolution capabilities of the X-ray detector under investigation were compared to other commercial CMOS sensors, and were found in every case higher, except from the previous RadEye HR model (CMOS—Gd2O2S:Tb screen pair with 22.5 μm pixel pitch) version which had slightly better MTF. The present digital imager is designed for industrial inspection applications, nonetheless its applicability to medical imaging, as well as dual-energy is considered and certain approaches are discussed in this respect.

Electron microscopy of rabbit FC crystals

1983 ◽  
Vol 41 ◽  
pp. 730-731
Author(s):  
Robert A. Grant ◽  
Laura L. Degn ◽  
Wah Chiu ◽  
John Robinson
Keyword(s):  
Electron Microscopy ◽  
High Resolution ◽  
High Resolution Electron Microscopy ◽  
Molecular Replacement ◽  
X Ray ◽  
X Ray Crystallography ◽  
Resolution Electron ◽  
Replacement Technique ◽  
Hydrated Crystal ◽  
Molecular Structure Analysis

Proteolytic digestion of the immunoglobulin IgG with papain cleaves the molecule into an antigen binding fragment, Fab, and a compliment binding fragment, Fc. Structures of intact immunoglobulin, Fab and Fc from various sources have been solved by X-ray crystallography. Rabbit Fc can be crystallized as thin platelets suitable for high resolution electron microscopy. The structure of rabbit Fc can be expected to be similar to the known structure of human Fc, making it an ideal specimen for comparing the X-ray and electron crystallographic techniques and for the application of the molecular replacement technique to electron crystallography. Thin protein crystals embedded in ice diffract to high resolution. A low resolution image of a frozen, hydrated crystal can be expected to have a better contrast than a glucose embedded crystal due to the larger density difference between protein and ice compared to protein and glucose. For these reasons we are using an ice embedding technique to prepare the rabbit Fc crystals for molecular structure analysis by electron microscopy.

High Resolution Study of Polytypism: Application to SiC and Au3 Mn

1982 ◽  
Vol 40 ◽  
pp. 540-541
Author(s):  
G. Van Tendeloo ◽  
J. Van Landuyt ◽  
S. Amelinckx
Keyword(s):  
Electron Microscopy ◽  
High Resolution ◽  
Stacking Sequence ◽  
X Ray ◽  
Powerful Technique ◽  
Resolution Study ◽  
The Ideal

Polytypism has been studied for a number of years and a wide variety of stacking sequences has been detected and analysed. SiC is the prototype material in this respect; see e.g. Electron microscopy under high resolution conditions when combined with x-ray measurements is a very powerful technique to elucidate the correct stacking sequence or to study polytype transformations and deviations from the ideal stacking sequence.

A High Resolution Study of G.P. Zones in Aluminum - 4.2 at % Silver

1982 ◽  
Vol 40 ◽  
pp. 722-723 ◽  
Author(s):  
R. Gronsky
Keyword(s):  
Electron Microscopy ◽  
Transmission Electron Microscopy ◽  
High Resolution ◽  
Computer Simulations ◽  
Structural Characteristics ◽  
X Ray Diffraction ◽  
X Ray ◽  
Transmission Electron ◽  
Resolution Study

The phenomenon of clustering in Al-Ag alloys has been extensively studied since the early work of Guinierl, wherein the pre-precipitation state was characterized as an assembly of spherical, ordered, silver-rich G.P. zones. Subsequent x-ray and TEM investigations yielded results in general agreement with this model. However, serious discrepancies were later revealed by the detailed x-ray diffraction - based computer simulations of Gragg and Cohen, i.e., the silver-rich clusters were instead octahedral in shape and fully disordered, atleast below 170°C. The object of the present investigation is to examine directly the structural characteristics of G.P. zones in Al-Ag by high resolution transmission electron microscopy.

Scanning Electron Microscopy and x-ray analysis of microparticles and early hydration effects

1995 ◽  
Vol 53 ◽  
pp. 692-693
Author(s):  
Yun Lu ◽  
David C. Joy
Keyword(s):  
Electron Microscopy ◽  
Scanning Electron Microscopy ◽  
High Resolution ◽  
Morphological Development ◽  
Early Hydration ◽  
X Ray ◽  
Blended Cements ◽  
Powder Particles ◽  
Chemical Wastes ◽  
Scanning Electron

High resolution scanning electron microscopy (SEM) and energy dispersive x-ray analysis (EDXA) were performed to investigate microparticles in blended cements and their hydration products containing sodium-rich chemical wastes. The physical appearance of powder particles and the morphological development at different hydration stages were characterized by using high resolution SEM Hitachi S-900 and by SEM S-800 with a EDX spectrometer. Microparticles were dispersed on the sample holder and glued by 1% palomino solution. Hydrated bulk samples were dehydrated by acetone and mounted on the holder by silver paste. Both fracture surfaces and flat cutting sections of hydrating samples were prepared and examined. Some specimens were coated with an 3 nm thick Au-Pd or Cr layer to provide good conducting surfaces. For high resolution SEM S-900 observations the accelerating voltage of electrons was 1-2 KeV to protect the electron charging. Microchemical analyses were carried out by S800/EDS equipped with a LINK detector of take-off angle =40°.

Tubulin structure at intermediate resolution

1995 ◽  
Vol 53 ◽  
pp. 852-853
Author(s):  
K. H. Downing ◽  
S. G. Wolf ◽  
E. Nogales
Keyword(s):  
High Resolution ◽  
Structural Data ◽  
Therapeutic Drug ◽  
Zinc Ions ◽  
Two Dimensional ◽  
X Ray Diffraction ◽  
X Ray ◽  
Negative Stain ◽  
Functional Mechanisms ◽  
Tubulin Structure

Microtubules are involved in a host of critical cell activities, many of which involve transport of organelles through the cell. Different sets of microtubules appear to form during the cell cycle for different functions. Knowledge of the structure of tubulin will be necessary in order to understand the various functional mechanisms of microtubule assemble, disassembly, and interaction with other molecules, but tubulin has so far resisted crystallization for x-ray diffraction studies. Fortuitously, in the presence of zinc ions, tubulin also forms two-dimensional, crystalline sheets that are ideally suited for study by electron microscopy. We have refined procedures for forming the sheets and preparing them for EM, and have been able to obtain high-resolution structural data that sheds light on the formation and stabilization of microtubules, and even the interaction with a therapeutic drug.Tubulin sheets had been extensively studied in negative stain, demonstrating that the same protofilament structure was formed in the sheets and microtubules. For high resolution studies, we have found that the sheets embedded in either glucose or tannin diffract to around 3 Å.

Nano-probe x-ray analysis and high-resolution imaging on planar defects in high-pressure synthesized infinite-layer superconductor

1994 ◽  
Vol 52 ◽  
pp. 728-729
Author(s):  
Y. Y. Wang ◽  
H. Zhang ◽  
V. P. Dravid ◽  
H. Zhang ◽  
L. D. Marks ◽  
...  
Keyword(s):  
High Pressure ◽  
High Resolution ◽  
Atomic Structure ◽  
Emission Spectra ◽  
High Resolution Electron Microscopy ◽  
Planar Defects ◽  
X Ray ◽  
Infinite Layer ◽  
Resolution Electron ◽  
Resolution Imaging

Azuma et al. observed planar defects in a high pressure synthesized infinitelayer compound (i.e. ACuO2 (A=cation)), which exhibits superconductivity at ~110 K. It was proposed that the defects are cation deficient and that the superconductivity in this material is related to the planar defects. In this report, we present quantitative analysis of the planar defects utilizing nanometer probe xray microanalysis, high resolution electron microscopy, and image simulation to determine the chemical composition and atomic structure of the planar defects. We propose an atomic structure model for the planar defects.Infinite-layer samples with the nominal chemical formula, (Sr1-xCax)yCuO2 (x=0.3; y=0.9,1.0,1.1), were prepared using solid state synthesized low pressure forms of (Sr1-xCax)CuO2 with additions of CuO or (Sr1-xCax)2CuO3, followed by a high pressure treatment.Quantitative x-ray microanalysis, with a 1 nm probe, was performed using a cold field emission gun TEM (Hitachi HF-2000) equipped with an Oxford Pentafet thin-window x-ray detector. The probe was positioned on the planar defects, which has a 0.74 nm width, and x-ray emission spectra from the defects were compared with those obtained from vicinity regions.

Sign in / Sign up

Export Citation Format

Share Document