scholarly journals The influence of off-fault deformation zones on the near-fault distribution of coseismic landslides

Geology ◽  
2021 ◽  
Author(s):  
Colin K. Bloom ◽  
Andrew Howell ◽  
Timothy Stahl ◽  
Chris Massey ◽  
Corinne Singeisen
Keyword(s):  
Rock Mass ◽  
Seismic Waves ◽  
Ground Motions ◽  
Three Dimensional ◽  
Landslide Risk ◽  
Coseismic Landslides ◽  
Landslide Occurrence ◽  
Near Fault ◽  
Coseismic Landslide ◽  
Fault Deformation

Coseismic landslides are observed in higher concentrations around surface-rupturing faults. This observation has been attributed to a combination of stronger ground motions and increased rock mass damage closer to faults. Past work has shown it is difficult to separate the influences of rock mass damage from strong ground motions on landslide occurrence. We measured coseismic off-fault deformation (OFD) zone widths (treating them as a proxy for areas of more intense rock mass damage) using high-resolution, three-dimensional surface displacements from the 2016 Mw 7.8 Kaikōura earthquake in New Zealand. OFD zones vary in width from ~50 m to 1500 m over the ~180 km length of ruptures analyzed. Using landslide densities from a database of 29,557 Kaikōura landslides, we demonstrate that our OFD zone captures a higher density of coseismic landslide incidence than generic “distance to fault rupture” within ~650 m of surface fault ruptures. This result suggests that the effects of rock mass damage within OFD zones (including ground motions from trapped and amplified seismic waves) may contribute to near-fault coseismic landslide occurrence in addition to the influence of regional ground motions, which attenuate with distance from the fault. The OFD zone represents a new path toward understanding, and planning for, the distribution of coseismic landslides around surface fault ruptures. Inclusion of estimates of fault zone width may improve landslide susceptibility models and decrease landslide risk.

SEISMIC RESPONSE OF POWER TRANSMISSION TOWER-LINE SYSTEM UNDER MULTI-COMPONENT MULTI-SUPPORT EXCITATIONS

2012 ◽  
Vol 06 (04) ◽  
pp. 1250025 ◽  
Author(s):  
TIAN LI ◽  
LI HONGNAN ◽  
LIU GUOHUAN
Keyword(s):  
Seismic Waves ◽  
Power Transmission ◽  
Incident Angle ◽  
Ground Motions ◽  
Three Dimensional ◽  
Transmission Tower ◽  
Line System ◽  
Time Stepping ◽  
Dimensional Finite Element ◽  
Three Dimensional Finite Element

The effect of multi-component multi-support excitations on the response of power transmission tower-line system is analyzed in this paper, using three-dimensional finite element time-stepping analysis of a transmission tower-line system based on an actual project. Multi-component multi-support earthquake input waves are generated based on the Code for Design of Seismic of Electrical Installations. Geometric non-linearity was considered in the analysis. An extensive parametric study was conducted to investigate the behavior of the transmission tower-line system under multi-component multi-support seismic excitations. The parameters include single-component multi-support ground motions, multi-component multi-support ground motions, the correlations among the three-component of multi-component multi-support ground motions, the spatial correlation of multi-component multi-support ground motions, the incident angle of multi-component multi-support seismic waves, the ratio of the peak values of the three-component of multi-component multi-support ground motions, and site condition with apparent wave velocity of multi-component multi-support ground motions.

scholarly journals Significance of Rotating Ground Motions on Behavior of Symmetric- and Asymmetric-Plan Structures: Part II. Multi-Story Structures

2015 ◽  
Vol 31 (3) ◽  
pp. 1613-1628 ◽  
Author(s):  
Erol Kalkan ◽  
Juan C. Reyes
Keyword(s):  
Ground Motion ◽  
Nonlinear Response ◽  
Rotation Angle ◽  
Ground Motions ◽  
Three Dimensional ◽  
Companion Paper ◽  
Apparent Velocity ◽  
Near Fault ◽  
Design Values ◽  
Linear And Nonlinear

The influence of the ground motion rotation angle on engineering demand parameters (EDPs) is examined in the companion paper based on three-dimensional (3-D) computer models of single-story structures. Further validations are performed here using 3-D models of nine-story buildings that have symmetric and asymmetric layouts subjected to a suite of bi-directional near-fault records with and without apparent velocity-pulses. The linear and nonlinear response-history analyses (RHAs) are used for evaluating the use of fault-normal and fault-parallel (FN/FP) directions and maximum-direction (MD) to rotate ground motions. This study suggests that individual ground motions rotated to MD or FN/FP directions not always provide conservative EDPs in nonlinear range, but often produce larger EDPs than as-recorded motions. In practice, when a suite of ground motions is used, nonlinear RHAs should be performed by rotating them to the MD and FN/FP directions, and maximum response values should be taken from these analyses as design values.

Three-dimensional simulation of the near-fault ground motion for the 1995 Hyogo-Ken Nanbu (Kobe), Japan, earthquake

1998 ◽  
Vol 88 (2) ◽  
pp. 428-440 ◽  
Author(s):  
Arben Pitarka ◽  
Kojiro Irikura ◽  
Tomotaka Iwata ◽  
Haruko Sekiguchi
Keyword(s):  
Ground Motion ◽  
Velocity Structure ◽  
Ground Motions ◽  
Three Dimensional ◽  
High Amplitude ◽  
Near Fault ◽  
Basin Edge ◽  
Dimensional Simulation ◽  
Near Fault Ground Motion ◽  
East West

Abstract The 17 January 1995 Hyogo-ken Nanbu earthquake is a typical example showing that the ground motions along basin-edge faults can be very destructive. In this study, we simulate the near-fault ground motion from this earthquake based on a kinematic fault model and a simplified 3D velocity structure of the Kobe area. The kinematic earthquake rupture and the wave propagation are modeled using a 3D finite-difference method (FDM). Our simulation identifies the basin-edge effect as an important factor that influenced the ground-motion amplification pattern in the Kobe area. We found that the coupling of the source directivity and basin-edge effects causes impulsive ground motions with extremely high amplitude at periods greater than 1 sec and in a narrow zone offset less than 1 km from the basin edge. The combination of these effects acted to create a fairly continuous band of amplification that extends about 30 km in an elongated zone parallel to the basin-edge boundary. In some areas, localized site effects might have been as important as the abovementioned effects, but they cannot explain the continuity of the extended east-west zone of damage.

scholarly journals Nonlinear Dynamic Response of a CC-RCC Combined Dam Structure under Oblique Incidence of Near-Fault Ground Motions

2020 ◽  
Vol 10 (3) ◽  
pp. 885
Author(s):  
Jiawen Zhang ◽  
Mengxi Zhang ◽  
Mingchao Li ◽  
Qiaoling Min ◽  
Bowen Shi ◽  
...  
Keyword(s):  
Seismic Waves ◽  
Seismic Analysis ◽  
Incidence Angle ◽  
Ground Motions ◽  
Nonlinear Behavior ◽  
Conventional Concrete ◽  
P Waves ◽  
Near Fault ◽  
Obliquely Incident ◽  
Seismic Records

The velocity pulse contained in near-fault ground motions have a tremendous impact on dam safety. Previous studies have mainly focused on the response of dams under near-fault seismic records without considering the obliquely incident seismic waves. In this study, the structure–soil interaction (SSI) is taken into consideration, and the nonlinear behavior of a conventional concrete roller-compacted concrete (CC-RCC) gravity dam under near-fault pulse records and non-pulse records is investigated with consideration of the obliquely incident P waves. On the basis of the dam site conditions, three groups of near-fault pulse records are chosen, and three corresponding non-pulse records are fitted by their acceleration response spectra. Combining with the viscous-spring artificial boundary, the wave input method is proposed to transform the near-fault seismic records into the equivalent nodal forces at the boundary of the foundation. The concrete damaged plasticity model is used for the nonlinear analysis. The results show that the pulse ground motions are more destructive than the non-pulse motions. The nonlinear behavior of the dam varies with the incidence angle of P waves and generally reaches a maximum at 60° and 75°, the worst damage occurs at the interface between different materials of the dam, and the spatial variation of its damage is very obvious under near-fault seismic records with various incidence angles. Therefore, the effect of the angle of obliquely incident seismic waves and near-fault pulse effect should be considered comprehensively in the seismic analysis of dams.

scholarly journals Supplemental Material: The influence of off-fault deformation zones on the near-fault distribution of coseismic landslides

2021 ◽  
Author(s):  
Colin K. Bloom ◽  
et al.
Keyword(s):  
Coseismic Landslides ◽  
Near Fault ◽  
Fault Deformation ◽  
Fault Distribution

Off-fault deformation (OFD) data, additional methodology, and analysis.<br>

Effect of Supplemental Damping on the Seismic Performance of Triple Pendulum Bearing Isolators under Near-Fault Ground Motions

2016 ◽  
Vol 845 ◽  
pp. 240-245
Author(s):  
Sima Rezaei ◽  
Gholamreza Ghodrati Amiri
Keyword(s):  
Seismic Isolation ◽  
Ground Motions ◽  
Damping Ratio ◽  
Three Dimensional ◽  
Time History ◽  
Period Range ◽  
Natural Period ◽  
Isolation System ◽  
Near Fault ◽  
Triple Pendulum

The isolating system absorbs part of the earthquake energy before transferring it to the structure, by shifting the natural period of the isolated structure. This period shift results in a reduction in the inertial forces. It is clear that the effects of near-fault (NF) ground motions with large velocity pulses can bring the seismic isolation devices to critical working conditions. In this study, two three-dimensional RC buildings with the heights of 9.0m and 21.0m which are supported by Triple Friction Pendulum Bearing (TFPB) isolators are idealized. Various TFPB configurations are selected for isolation systems. There are also viscous dampers to limit the excess deformation of isolators. Nonlinear time history analyses were performed by using OpenSees to study the influence of supplemental dampers on structural responses such as isolator displacements and maximum drifts under ten near-fault ground motion records. The results show noticeable reduction in isolator displacement when using dampers. However, maximum drift rises considerablely. Moreover by increasing the period range or reducing the damping ratio of isolation system, maximum driftreduces but the displacement of isolator increases.

scholarly journals Supplemental Material: The influence of off-fault deformation zones on the near-fault distribution of coseismic landslides

2021 ◽  
Author(s):  
Colin K. Bloom ◽  
et al.
Keyword(s):  
Coseismic Landslides ◽  
Near Fault ◽  
Fault Deformation ◽  
Fault Distribution

Off-fault deformation (OFD) data, additional methodology, and analysis.<br>

Significance of Rotating Ground Motions on Behavior of Symmetric- and Asymmetric-Plan Structures: Part I. Single-Story Structures

2015 ◽  
Vol 31 (3) ◽  
pp. 1591-1612 ◽  
Author(s):  
Juan C. Reyes ◽  
Erol Kalkan
Keyword(s):  
Statistical Evaluation ◽  
Rotation Angle ◽  
Ground Motions ◽  
Three Dimensional ◽  
Normal Fault ◽  
Near Fault ◽  
Earthquake Ground Motions ◽  
History Analysis ◽  
Response History Analysis ◽  
Design Values

The California Building Code requires at least two ground motion components for the three-dimensional (3-D) response history analysis (RHA) of structures. For near-fault sites, these records should be rotated to fault-normal/fault-parallel (FN/FP) directions, and two RHA analyses should be performed separately. This approach is assumed to lead to two sets of responses that envelope the range of possible responses over all non-redundant rotation angles. This assumption is examined here using 3-D computer models of single-story structures having symmetric and asymmetric plans subjected to a suite of bidirectional earthquake ground motions. The influence that the rotation angle has on several engineering demand parameters is investigated in linear and nonlinear domains to evaluate the use of the FN/FP directions, and the maximum direction (MD). The statistical evaluation suggests that RHAs should be conducted by rotating a set of records to the MD and FN/FP directions, and taking the maximum response values from these analyses as design values.

Isolation Performance of Intelligent Seismic Isolation System Using Air Bearing

2009 ◽  
Author(s):  
Satoshi Fujita ◽  
Keisuke Minagawa ◽  
Mitsuru Miyazaki ◽  
Go Tanaka ◽  
Toshio Omi ◽  
...  
Keyword(s):  
Seismic Isolation ◽  
Seismic Waves ◽  
Three Dimensional ◽  
Vertical Motion ◽  
Air Bearings ◽  
Natural Period ◽  
Isolation System ◽  
Vertical Excitation ◽  
Long Period ◽  
Isolation Performance

This paper describes three-dimensional isolation performance of seismic isolation system using air bearings. Long period seismic waves having predominant period of from a few seconds to a few ten seconds have recently been observed in various earthquakes. Also resonances of high-rise buildings and sloshing of petroleum tanks in consequence of long period seismic waves have been reported. Therefore the isolation systems having very long natural period or no natural period are required. In a previous paper [1], we proposed an isolation system having no natural period by using air bearings. Additionally we have already reported an introduction of the system, and have investigated horizontal motion during earthquake in the previous paper. It was confirmed by horizontal vibration experiment and simulation in the previous paper that the proposed system had good performance of isolation. However vertical motion should be investigated, because vertical motion varies horizontal frictional force. Therefore this paper describes investigation regarding vertical motion of the proposed system by experiment. At first, a vertical excitation test of the system is carried out so as to investigate vertical dynamic property. Then a three-dimensional vibration test using seismic waves is carried out so as to investigate performance of isolation against three-dimensional seismic waves.

Sign in / Sign up

Export Citation Format

Share Document