Static and dynamical elastic behavior of Lu5Ir4Si10 around its first-order structural phase transition

2020 ◽  
Vol 34 (12) ◽  
pp. 2050116
Author(s):  
M. Saint-Paul ◽  
C. Opagiste ◽  
C. Guttin
Keyword(s):  
Phase Transition ◽  
Theoretical Approach ◽  
Order Parameter ◽  
Landau Theory ◽  
Structural Phase ◽  
Elastic Stiffness ◽  
Elastic Behavior ◽  
Velocity Measurements ◽  
First Order ◽  
First Order Transition

Ultrasonic velocity measurements could be performed on a good quality single crystal of [Formula: see text] around its transition around 80 K. The behavior of the stiffness components demonstrates a first-order transition. The temperature dependence of the longitudinal elastic stiffness components [Formula: see text] and [Formula: see text] can be analyzed by the classical Landau theory and assuming a stricter coupling between the strain and the order parameter. A theoretical approach and experimental results are discussed.

TEMPERATURE DEPENDENCE OF SURFACE TENSION OF LIQUID CRYSTALS AT THE PHASE TRANSITION

1995 ◽  
Vol 09 (03n04) ◽  
pp. 237-242 ◽  
Author(s):  
R. MOLDOVAN ◽  
M. TINTARU ◽  
T. BEICA ◽  
S. FRUNZA ◽  
D. N. STOENESCU
Keyword(s):  
Experimental Data ◽  
Phase Transition ◽  
Surface Tension ◽  
Free Energy ◽  
Surface Layer ◽  
Order Parameter ◽  
Unit Area ◽  
Negative Slope ◽  
First Order ◽  
First Order Transition

The surface tension is calculated as the excess of the free energy per unit area, due to the presence of a surface layer, using Landau–de Gennes expansions, in the hypothesis of a first order transition in the bulk and taking into account the dependence of the surface free energy from the surface tilt angle. The surface order parameter is calculated and surface-ordered phase above the phase transition temperature has been found. A variety of calculated surface tension versus temperature curves with a jump at the phase transition, with positive or negative slope, well describing the experimental data from literature, have been attained.

Study of Structural, Elastic Properties and their Pressure Dependence in IrN Compound

2016 ◽  
Vol 28 ◽  
pp. 16-22 ◽  
Author(s):  
Shubhangi Soni ◽  
Arvind Jain ◽  
Kamal Kumar Choudhary ◽  
Netram Kaurav
Keyword(s):  
Phase Transition ◽  
Theoretical Study ◽  
Structural Phase ◽  
Elastic Behavior ◽  
Interionic Interaction ◽  
First Order ◽  
Transition Pressure ◽  
Zinc Blende ◽  
Phase Transition Pressure ◽  
Cscl Structure

A theoretical study of the elastic behavior in IrN compound using effective interionic interaction potential is carried out. The estimated values of phase transition pressure and the vast volume discontinuity in pressure-volume (PV) phase diagram indicate the structural phase transition from zinc blende (B3) to CsCl structure (B2). C11, C12 and C44 increase nearly linearly with pressure. At phase transition pressure IrN has shown a discontinuity in second order elastic constants, which is in accordance with the first-order character of the phase transition.

MULTIPLE PHASE TRANSITIONS IN PEROVSKITE STRUCTURE CERAMICS: STRUCTURAL TRANSITIONS

1999 ◽  
Vol 13 (22n23) ◽  
pp. 791-799
Author(s):  
C. H. EAB ◽  
B. WIWATANAPATAPHEE ◽  
I. M. TANG
Keyword(s):  
Phase Transition ◽  
Phase Transitions ◽  
Structural Phase Transition ◽  
Perovskite Structure ◽  
Landau Theory ◽  
Structural Phase ◽  
Free Energies ◽  
Ginzburg Landau ◽  
First Order ◽  
Multiple Phase

A Ginzburg–Landau theory for the multiple structural phase transition observed in the cuprate perovskite structure ceramics is developed. The order parameters Λi for each phase are defined in terms of the deformations which occur in each phase. In terms of the deformation, the expansion of the free energies is to the twelfth order. The theory can account for a second-order tetragonal to orthorhombic-I transition at high temperatures and a first-order orthorhombic-I to orthorhombic-II transition at lower temperatures. The criterion for the existence of a tricritical line is established.

scholarly journals Elastic Properties and Energy Loss Related to the Disorder–Order Ferroelectric Transitions in Multiferroic Metal–Organic Frameworks [NH4][Mg(HCOO)3] and [(CH3)2NH2][Mg(HCOO)3]

Materials ◽  
2021 ◽  
Vol 14 (11) ◽  
pp. 3125
Author(s):  
Zhiying Zhang ◽  
Hongliang Yu ◽  
Xin Shen ◽  
Lei Sun ◽  
Shumin Yue ◽  
...  
Keyword(s):  
Phase Transition ◽  
Energy Loss ◽  
Elastic Properties ◽  
Ferroelectric Phase ◽  
Loss Modulus ◽  
Structural Phase ◽  
Metal Organic Frameworks ◽  
First Order ◽  
Metal Organic ◽  
Elastic Anomalies

Elastic properties are important mechanical properties which are dependent on the structure, and the coupling of ferroelasticity with ferroelectricity and ferromagnetism is vital for the development of multiferroic metal–organic frameworks (MOFs). The elastic properties and energy loss related to the disorder–order ferroelectric transition in [NH4][Mg(HCOO)3] and [(CH3)2NH2][Mg(HCOO)3] were investigated using differential scanning calorimetry (DSC) and dynamic mechanical analysis (DMA). The DSC curves of [NH4][Mg(HCOO)3] and [(CH3)2NH2][Mg(HCOO)3] exhibited anomalies near 256 K and 264 K, respectively. The DMA results illustrated the minimum in the storage modulus and normalized storage modulus, and the maximum in the loss modulus, normalized loss modulus and loss factor near the ferroelectric transition temperatures of 256 K and 264 K, respectively. Much narrower peaks of loss modulus, normalized loss modulus and loss factor were observed in [(CH3)2NH2][Mg(HCOO)3] with the peak temperature independent of frequency, and the peak height was smaller at a higher frequency, indicating the features of first-order transition. Elastic anomalies and energy loss in [NH4][Mg(HCOO)3] near 256 K are due to the second-order paraelectric to ferroelectric phase transition triggered by the disorder–order transition of the ammonium cations and their displacement within the framework channels, accompanied by the structural phase transition from the non-polar hexagonal P6322 to polar hexagonal P63. Elastic anomalies and energy loss in [(CH3)2NH2][Mg(HCOO)3] near 264 K are due to the first-order paraelectric to ferroelectric phase transitions triggered by the disorder–order transitions of alkylammonium cations located in the framework cavities, accompanied by the structural phase transition from rhombohedral R3¯c to monoclinic Cc. The elastic anomalies in [NH4][Mg(HCOO)3] and [(CH3)2NH2][Mg(HCOO)3] showed strong coupling of ferroelasticity with ferroelectricity.

Temperature-triggered order–disorder phase transition in molecular-ionic material N-butyldiethanolammonium picrate monohydrate

RSC Advances ◽  
2016 ◽  
Vol 6 (73) ◽  
pp. 69546-69550 ◽  
Author(s):  
Tariq Khan ◽  
Muhammad Adnan Asghar ◽  
Zhihua Sun ◽  
Chengmin Ji ◽  
Lina Li ◽  
...  
Keyword(s):  
Phase Transition ◽  
Structural Phase Transition ◽  
Structural Phase ◽  
Dielectric Materials ◽  
Disorder Phase Transition ◽  
First Order ◽  
Oxygen Atoms

We report an organic–ionic material that undergoes a first-order structural phase transition, induced by order–disorder of oxygen atoms in picrate anion. This strategy offers a potential pathway to explore new switchable dielectric materials.

Parameterization of the coupling between strain and order parameter for LuF[SeO3]

2014 ◽  
Vol 47 (2) ◽  
pp. 701-711 ◽  
Author(s):  
Oxana V. Magdysyuk ◽  
Melanie Müller ◽  
Robert E. Dinnebier ◽  
Christian Lipp ◽  
Thomas Schleid
Keyword(s):  
Phase Transition ◽  
Order Parameter ◽  
Structural Phase ◽  
High Temperature Phase ◽  
Temperature Phase ◽  
Time Resolved ◽  
Synchrotron Powder Diffraction ◽  
First Order Phase Transition ◽  
Temperature Phase Transition ◽  
First Order Phase

The high-temperature phase transition of LuF[SeO3] has been characterized by time-resolved high-resolution synchrotron powder diffraction. On heating, a second-order structural phase transition was found at 393 K, while on cooling the same phase transition occurs at 371 K, showing a large hysteresis typical for a first-order phase transition. Detailed analysis using sequential and parametric whole powder pattern fitting revealed that the coupling between the strain and the displacive order parameter determines the behaviour of the material during the phase transition. Different possible coupling mechanisms have been evaluated and the most probable rationalized.

scholarly journals Спектры пропускания монокристаллов гибридных перовскитов MAPbI-=SUB=-3-=/SUB=- вблизи края фундаментального поглощения

2022 ◽  
Vol 130 (1) ◽  
pp. 116
Author(s):  
В.Е. Аникеева ◽  
К.Н. Болдырев ◽  
О.И. Семенова ◽  
М.Н. Попова
Keyword(s):  
Phase Transition ◽  
Absorption Edge ◽  
Structural Phase ◽  
Fundamental Absorption Edge ◽  
Orthorhombic Phase ◽  
Temperature Hysteresis ◽  
First Order ◽  
Hybrid Perovskite ◽  
First Order Phase Transition ◽  
First Order Phase

The paper presents the transmission spectra of hybrid perovskite MAPbI3 single crystals near the fundamental absorption edge in a wide temperature range. The absorption coefficient α of the single crystal samples is estimated at a temperature T = 150 K for the light with a photon energy E = 1.6 eV and at T = 40 K for E = 1.8 eV. The obtained values turned out to be several orders of magnitude smaller than the values of α for thin-film samples known from the literature. A sharp shift of the fundamental absorption edge by ~ 100 meV was observed at a temperature T1 = 160 K of the structural phase transition from the tetragonal to the orthorhombic phase. The temperature hysteresis of the shift of the fundamental absorption edge near T1 was recorded, which is characteristic of a first-order phase transition.

Sign in / Sign up

Export Citation Format

Share Document