A Media Access Control Protocol for Broadcast Type Super High-Speed WDM Networks

2003 ◽  
Vol 04 (02) ◽  
pp. 147-162
Author(s):  
Akio Koyama ◽  
Masato Akiyama
Keyword(s):  
New Media ◽  
Wavelength Division Multiplexing ◽  
High Speed ◽  
Wdm Networks ◽  
Media Access Control ◽  
Media Access ◽  
Wavelength Division ◽  
Transmission Distance ◽  
Long Time ◽  
Control Packets

In this paper, we propose a new media access protocol for single hop Wavelength Division Multiplexing (WDM) networks with a passive star topology. In the conventional protocols, when the control packets collided with other ones or the packets didn't get a data channel from the channel reservation mechanism, these packets should be retransmitted. But, when transmission distance becomes long, it takes a long time to transmit the control packets and the propogation dalay time will be long. We propose a new protocol that can allocate data channels without retransmitting control packets except the collided ones. By using the proposed protocol, it is possible to reduce the transmission delay time and to get high throughput because the number of retransmitted control packets is reduced. The simulation results show that the proposed protocol has good performance comparied with conventional protocols.

Comparative Analysis of High Speed 20/20 Gbps OTDM-PON, WDM-PON and TWDM-PON for Long-Reach NG-PON2

2019 ◽  
Vol 0 (0) ◽  
Author(s):  
Meet Kumari ◽  
Reecha Sharma ◽  
Anu Sheetal
Keyword(s):  
Wavelength Division Multiplexing ◽  
High Speed ◽  
Optical Network ◽  
Access Network ◽  
Cost Effective ◽  
Input Power ◽  
Passive Optical Network ◽  
Wavelength Division ◽  
Transmission Distance ◽  
Wdm Pon

AbstractNowadays, bandwidth demand is enormously increasing, that causes the existing passive optical network (PON) to become the future optical access network. In this paper, next generation passive optical network 2 (NG-PON2) based, optical time division multiplexing passive optical network (OTDM-PON), wavelength division multiplexing passive optical network (WDM-PON) and time & wavelength division multiplexing passive optical network (TWDM-PON) systems with 20 Gbps (8 × 2.5 Gbps) downstream and 20 Gbps (8 × 2.5 Gbps) upstream capacity for eight optical network units has been proposed. The performance has been compared by varying the input power (−6 to 27 dBm) and transmission distance (10–130 km) in terms of Q-factor and optical received power in the presence of fiber noise and non-linearities. It has been observed that TWDM-PON outperforms OTDM-PON and WDM-PON for high input power and data rate (20/20 Gbps). Also, TWDM-PON shows its superiority for long-reach transmission up to 130 km, which is a cost-effective solution for future NG-PON2 applications.

Control Traffic Flows and Differing Quality of Service with Reservation of Bandwidth in Optical Network

2011 ◽  
Vol 219-220 ◽  
pp. 1309-1312
Author(s):  
Ning Zhang
Keyword(s):  
Wavelength Division Multiplexing ◽  
High Speed ◽  
Optical Network ◽  
Traffic Grooming ◽  
Wdm Networks ◽  
Wavelength Division ◽  
Optical Wdm Networks ◽  
Optical Wdm ◽  
High Bandwidth ◽  
Control Traffic

In this paper, a traffic flow control scheme is presented. Wavelength division multiplexing (WDM) technology have significantly increased the transmission capacity of today’s transport networks, and played an extremely important role in high-speed network. Since high bandwidth wavelength channels will be filled up by many low-speed traffic streams, efficiently provisioning customer connections with such diverse bandwidth needs is a very important problem and is also known as the traffic-grooming problem. Traffic grooming is an extremely important issue for next-generation optical WDM networks.

Erbium/Ytterbium-Doped Waveguide Amplifier (EYDWA) for extended reach of Wavelength Division Multiplexing based free space optics system (WDM/FSO)

2020 ◽  
Vol 0 (0) ◽  
Author(s):  
Bentahar Attaouia ◽  
Kandouci Malika ◽  
Ghouali Samir
Keyword(s):  
Wavelength Division Multiplexing ◽  
Free Space ◽  
Cost Effective ◽  
Weather Conditions ◽  
Free Space Optical ◽  
Wavelength Division ◽  
Space Optics ◽  
Effective Implementation ◽  
Transmission Distance ◽  
The Cost

AbstractThis work is focused to carry out the investigation of wavelength division multiplexing (WDM) approach on free space optical (FSO) transmission systems using Erbium Ytterbium Doped Waveguide Amplifier (EYDWA) integrated as post-or pre-amplifier for extending the reach to 30 Km for the cost-effective implementation of FSO system considering weather conditions. Furthermore, the performance of proposed FSO-wavelength division multiplexing (WDM) system is also evaluated on the effect of varying the FSO range and results are reported in terms of Q factor, BER, and eye diagrams. It has been found that, under clear rain the post-amplification was performed and was able to reach transmission distance over 27 Km, whereas, the FSO distance has been limited at 19.5 Km by using pre-amplification.

Optical Networks Performance Optimization Based on Hybrid Configurations of Optical Fiber Amplifiers and Optical Receivers

2019 ◽  
Vol 0 (0) ◽  
Author(s):  
I. S. Amiri ◽  
Fatma Mohammed Aref Mahmoud Houssien ◽  
Ahmed Nabih Zaki Rashed ◽  
Abd El-Naser A. Mohammed
Keyword(s):  
Optical Fiber ◽  
Optical Networks ◽  
Wavelength Division Multiplexing ◽  
Performance Optimization ◽  
Input Power ◽  
Fiber Amplifiers ◽  
Q Factor ◽  
Wavelength Division ◽  
Transmission Distance ◽  
Optical Fiber Amplifiers

AbstractThe 16-channels dense wavelength division multiplexing (DWDM) systems have been optimized by utilizing hybrid configurations of conventional optical fiber amplifiers (EDFA, RAMAN and SOA) and optical photodetectors (PIN, APD(Si) and APD(InGaAs)). The DWDM systems were implemented for 5 Gb/s channel speed using one of these configurations with 100 GHz channel spacing and 25 km amplifying section. The hybrid configurations are the combinations of (PIN + EDFA), (PIN + RAMAN), (PIN + SOA), (APD(Si) + EDFA), (APD(Si) + RAMAN), (APD(Si) + SOA), (APD(InGaAs) + EDFA), (APD(InGaAs) + RAMAN) and (APD(InGaAs) + SOA). Based on BER, Q-factor and eye diagrams, the performance was compared for these configurations under influences of various thermal noise levels of photodetectors over different fiber lengths ranging from 25 km up to 150 km. The results revealed that both APD structures give optimum performance at input power Pin = 5 dBm due to high internal avalanche gain. EDFA outperforms RAMAN and SOA amplifiers. SOA amplifier shows degraded performance because of nonlinearity effects induced. RAMAN amplifier seems to be the best alternative for long reach DWDM systems because it minimizes the effects of fiber nonlinearities. The configuration (APD(Si) + EDFA) is the most efficient and recommended to be used for transmission distance beyond 100 km due to its larger Q-factor.

Investigations of Different Amplifiers in 16 × 40 Gb/S WDM System

2019 ◽  
Vol 40 (4) ◽  
pp. 341-346
Author(s):  
Kulwinder Singh ◽  
Karan Goel ◽  
Kamaljit Singh Bhatia ◽  
Hardeep Singh Ryait
Keyword(s):  
Wavelength Division Multiplexing ◽  
Fiber Amplifier ◽  
Optical Amplifier ◽  
Fiber Amplifiers ◽  
Erbium Doped Fiber Amplifier ◽  
Wavelength Division ◽  
Transmission Distance ◽  
Erbium Doped ◽  
Eye Opening ◽  
Eye Closure

Abstract Different fiber amplifiers such as semiconductor optical amplifier, erbium-doped fiber amplifier and erbium ytterbium-co-doped fiber amplifier (EYCDFA) are investigated for 16×40 GB/s wavelength division multiplexing system. Various performance parameters including Q-factor, bit error rate, jitter, eye opening and eye closure are observed and analyzed. It is reported that EYCDFA is a better choice among the tested amplifiers. The proposed system is also investigated in terms of transmission distance.

scholarly journals Intensity and Wavelength Division Multiplexing FBG Sensor System Using a Raman Amplifier and Extreme Learning Machine

2018 ◽  
Vol 2018 ◽  
pp. 1-11 ◽  
Author(s):  
Yibeltal Chanie Manie ◽  
Run-Kai Shiu ◽  
Peng-Chun Peng ◽  
Bao-Yi Guo ◽  
Mekuanint Agegnehu Bitew ◽  
...  
Keyword(s):  
Extreme Learning Machine ◽  
Wavelength Division Multiplexing ◽  
Sensor System ◽  
Bragg Wavelength ◽  
Wavelength Division ◽  
Raman Amplifier ◽  
Fbg Sensor ◽  
Transmission Distance ◽  
Fbg Sensors ◽  
Learning Machine

A fiber Bragg grating (FBG) sensor is a favorable sensor in measuring strain, pressure, vibration, and temperature in different applications, such as in smart structures, wind turbines, aerospace, industry, military, medical centers, and civil engineering. FBG sensors have the following advantages: immune to electromagnetic interference, light weight, small size, flexible, stretchable, highly accurate, longer stability, and capable in measuring ultra-high-speed events. In this paper, we propose and demonstrate an intensity and wavelength division multiplexing (IWDM) FBG sensor system using a Raman amplifier and extreme learning machine (ELM). We use an IWDM technique to increase the number of FBG sensors. As the number of FBG sensors increases and the spectra of two or more FBGs are overlapped, a conventional peak detection (CPD) method is unappropriate to detect the central Bragg wavelength of each FBG sensor. To solve this problem, we use ELM techniques. An ELM is used to accurately detect the central Bragg wavelength of each FBG sensor even when the spectra of FBGs are partially or fully overlapped. Moreover, a Raman amplifier is added to a fiber span to generate a gain medium within the transmission fiber, which amplifies the signal and compensates for the signal losses. The transmission distance and the sensing signal quality increase when the Raman pump power increases. The experimental results revealed that a Raman amplifier compensates for the signal losses and provides a stable sensing output even beyond a 45 km transmission distance. We achieve a remote sensing of strain measurement using a 45 km single-mode fiber (SMF). Furthermore, the well-trained ELM wavelength detection methods accurately detect the central Bragg wavelengths of FBG sensors when the two FBG spectra are fully overlapped.

scholarly journals EDFA AND EYCDFA POWER BOOSTER FOR SECURED, HIGH SPEED AND MULTIPLE WAVELENGTH SERVICES IN OPTICAL COMMUNICATION SYSTEMS USING WDM AND QUAD-SINGLE FORWARD AND TRI BACKWARD PUMPING TECHNIQUE

2021 ◽  
Vol 5 (12) ◽  
Author(s):  
S. Semmalar ◽  
S. Malarkkan
Keyword(s):  
Wavelength Division Multiplexing ◽  
Optical Communication ◽  
Communication Systems ◽  
High Speed ◽  
Optical Power ◽  
Fiber Amplifier ◽  
Signal Power ◽  
Erbium Doped Fiber Amplifier ◽  
Output Optical Power ◽  
Wavelength Division

Proposed the EDFA and EYCDFA power booster (Erbium Doped Fiber Amplifier- Erbium ytterbium co doped fiber amplifier) with quad pumping for high speed and multi wavelength services in an optical communication. The proposed EDFA and EYCDFA power booster with WDM(Wavelength division multiplexing) simulated by dual forward and Backward pumping, Dual-backward pumping, Tri-single forward and dual backward pumping and Quadsingle forward and tri-backward pumping with respect to Pump power and fiber Length. The parameters Input Optical power, Output Optical power, Forward Signal power, Backward Signal power measured and determined the speed of transmission in all types of pumping methods. From that the proposed EDFA- ans EYCDFA power booster with WDM quad pumping is the best suitable for secured high speed optical telecommunication systems. The results shown in Quad pumping Output optical power is maximum 25.2dB and optimum spectral forward Signal power is 30.5dBm and very less spectral optical backward signal power of -25.4dBm with Length 5m

Sign in / Sign up

Export Citation Format

Share Document