scholarly journals Rotor-Flying Manipulator: Modeling, Analysis, and Control

2014 ◽  
Vol 2014 ◽  
pp. 1-13 ◽  
Author(s):  
Bin Yang ◽  
Yuqing He ◽  
Jianda Han ◽  
Guangjun Liu
Keyword(s):  
Controller Design ◽  
Linear Quadratic Regulator ◽  
Linear Quadratic ◽  
Combined System ◽  
Underwater Robots ◽  
Modeling Analysis ◽  
Full State Feedback ◽  
Lqr Controller ◽  
Linearized Model ◽  
And Control

Equipping multijoint manipulators on a mobile robot is a typical redesign scheme to make the latter be able to actively influence the surroundings and has been extensively used for many ground robots, underwater robots, and space robotic systems. However, the rotor-flying robot (RFR) is difficult to be made such redesign. This is mainly because the motion of the manipulator will bring heavy coupling between itself and the RFR system, which makes the system model highly complicated and the controller design difficult. Thus, in this paper, the modeling, analysis, and control of the combined system, called rotor-flying multijoint manipulator (RF-MJM), are conducted. Firstly, the detailed dynamics model is constructed and analyzed. Subsequently, a full-state feedback linear quadratic regulator (LQR) controller is designed through obtaining linearized model near steady state. Finally, simulations are conducted and the results are analyzed to show the basic control performance.

scholarly journals Simulation of a Steam Injected Gas Turbine Plant Control System

1997 ◽  
Author(s):  
Shusheng Zang ◽  
Jaqiang Pan
Keyword(s):  
Gas Turbine ◽  
Flow Rate ◽  
Controller Design ◽  
Dynamic Performance ◽  
Linear Quadratic Regulator ◽  
Linear Quadratic ◽  
Turbine Plant ◽  
Fuel Flow ◽  
Lqr Controller ◽  
Gas Turbine Plant

The design of a modern Linear Quadratic Regulator (LQR) is described for a test steam injected gas turbine (STIG) unit. The LQR controller is obtained by using the fuel flow rate and the injected steam flow rate as the output parameters. To meet the goal of the shaft speed control, a classical Proportional Differential (PD) controller is compared to the LQR controller design. The control performance of the dynamic response of the STIG plant in the case of rejection of load is evaluated. The results of the computer simulation show a remarkable improvement on the dynamic performance of the STIG unit.

scholarly journals System design for inverted pendulum using LQR control via IoT

2020 ◽  
Vol 11 ◽  
pp. 12
Author(s):  
Dechrit Maneetham ◽  
Petrus Sutyasadi
Keyword(s):  
Inverted Pendulum ◽  
Control Method ◽  
Linear Quadratic Regulator ◽  
Linear Quadratic ◽  
Lqr Control ◽  
Lqr Controller ◽  
Model Tuning ◽  
And Performance ◽  
Performance Results ◽  
And Control

This research proposes control method to balance and stabilize an inverted pendulum. A robust control was analyzed and adjusted to the model output with real time feedback. The feedback was obtained using state space equation of the feedback controller. A linear quadratic regulator (LQR) model tuning and control was applied to the inverted pendulum using internet of things (IoT). The system's conditions and performance could be monitored and controlled via personal computer (PC) and mobile phone. Finally, the inverted pendulum was able to be controlled using the LQR controller and the IoT communication developed will monitor to check the all conditions and performance results as well as help the inverted pendulum improved various operations of IoT control is discussed.

Augmented-Stability Controller Design for a UAV’s Longitudinal Motion

2011 ◽  
Vol 63-64 ◽  
pp. 533-536
Author(s):  
Xiao Jun Xing ◽  
Jian Guo Yan
Keyword(s):  
Dynamic Characteristics ◽  
Controller Design ◽  
Damping Ratio ◽  
Linear Quadratic Regulator ◽  
Longitudinal Motion ◽  
Linear Quadratic ◽  
Short Period ◽  
Quality Specifications ◽  
Simulation Results ◽  
And Control

With the purpose of overcoming the defect that unmanned air vehicles (UAVs) are easily disturbed by air current and tend to be unstable, an augmented-stability controller was developed for a certain UAV’s longitudinal motion. According to requirements of short-period damping ratio and control anticipation parameter (CAP) in flight quality specifications of GJB185-86 and C*, linear quadratic regulator (LQR) theory was used in the augmented-stability controller’s design. The simulation results show that the augmented-stability controller not only improves the UAV’s stability and dynamic characteristics but also enhances the UAV’s robustness.

scholarly journals Performance Comparisons Of Hybrid Fuzzy-LQR And Hybrid PID-LQR Controllers On Stabilizing Double Rotary Inverted Pendulum

2020 ◽  
Vol 1 (2) ◽  
pp. 71-80
Author(s):  
Jamilu Kamilu Adamu ◽  
Mukhtar Fatihu Hamza ◽  
Abdulbasid Ismail Isa
Keyword(s):  
Inverted Pendulum ◽  
Fuzzy Logic Controller ◽  
Linear Quadratic Regulator ◽  
State Feedback Control ◽  
Linear Quadratic ◽  
Trajectory Tracking Control ◽  
Stabilization Control ◽  
Full State Feedback ◽  
Lqr Controller ◽  
Rotary Inverted Pendulum

Double Rotary Inverted Pendulum (DRIP) is a member of the mechanical under-actuated system which is unstable and nonlinear. The DRIP has been widely used for testing different control algorithms in both simulation and experiments. The DRIP control objectives include Stabilization control, Swing-up control and trajectory tracking control. In this research, we present the design of an intelligent controller called “hybrid Fuzzy-LQR controller” for the DRIP system. Fuzzy logic controller (FLC) is combined with a Linear Quadratic Regulator (LQR). The LQR is included to improve the performance based on full state feedback control. The FLC is used to accommodate nonlinearity based on its IF-THEN rules. The proposed controller was compared with the Hybrid PID-LQR controller. Simulation results indicate that the proposed hybrid Fuzzy-LQR controllers demonstrate a better performance compared with the hybrid PID-LQR controller especially in the presence of disturbances.

scholarly journals System Identification and LQR Controller Design with Incomplete State Observation for Aircraft Trajectory Tracking

Energies ◽  
2020 ◽  
Vol 13 (20) ◽  
pp. 5354
Author(s):  
Piotr Lichota ◽  
Franciszek Dul ◽  
Andrzej Karbowski
Keyword(s):  
Simulation Model ◽  
Trajectory Tracking ◽  
Controller Design ◽  
Linear Quadratic Regulator ◽  
Atmospheric Conditions ◽  
Nonlinear Transport ◽  
Linear Quadratic ◽  
Likelihood Principle ◽  
Tracking Errors ◽  
Lqr Controller

This paper presents a controller design process for an aircraft tracking problem when not all states are available. In the study, a nonlinear-transport aircraft simulation model was used and identified through Maximum Likelihood Principle and Extended Kalman Filter. The obtained mathematical model was used to design a Linear–Quadratic Regulator (LQR) with optimal weighting matrices when not all states are measured. The nonlinear aircraft simulation model with LQR controller tracking abilities were analyzed for multiple experiments with various noise levels. It was shown that the designed controller is robust and allows for accurate trajectory tracking. It was found that, in ideal atmospheric conditions, the tracking errors are small, even for unmeasured variables. In wind presence, the tracking errors were proportional to the wind velocity and acceptable for small and moderate disturbances. When turbulence was present in the experiment, state variable oscillations occurred that were proportional to the turbulence intensity and acceptable for small and moderate disturbances.

Real Time Modeling and Control of Three Tank Hybrid System

2018 ◽  
Vol 13 (1) ◽  
Author(s):  
K. Sathishkumar ◽  
V. Kirubakaran ◽  
T. K. Radhakrishnan
Keyword(s):  
Real Time ◽  
Controller Design ◽  
Linear Quadratic Regulator ◽  
Estimation Model ◽  
Linear Quadratic ◽  
Loop Control ◽  
Modeling And Control ◽  
Time Modeling ◽  
Lqr Controller ◽  
Servo Tracking

AbstractThis study discusses the modeling and linear quadratic regulator (LQR) controller based closed loop control of a three tank hybrid (TTH) process. A pseudo random binary signal (PRBS) based excitation data obtained from a real time TTH setup is utilized in validating its first principle model (FPM). Based on top and bottom interactions, various modes prevalent are considered based on steady state physical reachability analysis of the TTH for a given input range for controller design. The FPM is linearized using nominal values of process parameters using Jacobians from each existing mode. LQR controllers are designed for each mode. A supervisory structure is designed for selecting estimation model and controller for each appropriate mode. Results from real time servo tracking and disturbance rejection experiments are discussed.

Dynamics Analysis and Control Method of a Novel Spherical Robot

2009 ◽  
Author(s):  
Hanxu Sun ◽  
Yili Zheng ◽  
Qingxuan Jia
Keyword(s):  
Control Method ◽  
Linear Quadratic Regulator ◽  
High Rate ◽  
Pd Controller ◽  
Velocity Control ◽  
Spherical Robot ◽  
Linear Quadratic ◽  
Lqr Controller ◽  
Gyroscopic Effects ◽  
And Control

A novel omni-directional rolling spherical robot equipped with a high-rate flywheel (BYQ-V) is presented; the mechanical structure of the robot are given, and the gyroscopic effects of high-rate flywheel can improve the dynamic stability of the robot. The simplified dynamic model of the robot is derived based on the constrained Lagrangian method. Moreover, a Linear Quadratic Regulator (LQR) controller and a Percentage Derivative (PD) controller are designed to implement the pose and velocity control of the robot respectively, Finally, the control method are validated through continuous circle motion experiment. This robot is designed for territory or lunar exploration in the future.

scholarly journals Controller Design Of Unicycle Mobile Robot

2012 ◽  
Vol 13 (2) ◽  
Author(s):  
Mohd Zamzuri Abd Rashid ◽  
Shahrul Naim Sidek
Keyword(s):  
Mobile Robot ◽  
Controller Design ◽  
Control Strategies ◽  
Simulation Studies ◽  
Linear Quadratic ◽  
Robot System ◽  
System A ◽  
Controller Gain ◽  
Lqr Controller ◽  
Linearized Model

ABSTRACT: The ability of unicycle mobile robot to stand and move around using one wheel has attracted a lot of researchers to conduct studies about the system, particularly in the design of the system mechanisms and the control strategies. This paper reports the investigation done on the design of the controller of the unicycle mobile robot system to maintain its stability in both longitudinal and lateral directions. The controller proposed is a Linear Quadratic Controller (LQR) type which is based on the linearized model of the system. A thorough simulation studies have been carried out to find out the performance of the LQR controller. The best controller gain, K acquired through the simulation is selected to be implemented and tested in the experimental hardware. Finally, the results obtained from the experimental study are compared to the simulation results to study the controller efficacy. The analysis reveals that the proposed controller design is able to stabilize the unicycle mobile robot.ABSTRAK: Kemampuan robot satu roda untuk berdiri dan bergerak di sekitar telah menarik minat ramai penyelidik untuk mengkaji sistem robot terutamanya didalam bidang rangka mekanikal dan strategi kawalan robot. Kertas kajian ini melaporkan hasil penyelidikan ke atas strategi kawalan robot bagi memastikan sistem robot satu roda dapat distabilkan dari arah sisi dan hadapan. Strategi kawalan yang dicadang, menggunakan teknik kawalan kuadratik sejajar (Linear Quadratic Control) yang berdasarkan model robot yang telah dipermudahkan. Kajian simulasi secara terperinci telah dijalankan bagi mengkaji prestasi strategi kawalan yang dicadangkan. Dari kajian simulasi sistem robot, pemilihan faktor konstan, K yang sesuai di dalam strategi kawalan telah dibuat, agar dapat dilaksanakan ke atas sistem robot yang dibangunkan. Keputusan dari kajian simulasi dan tindak balas oleh sistem robot yang dibangunkan akhirnya dibandingkan bagi melihat kesesuaian faktor kostan, K yang dipilih. Analisa menunjukkan dengan menggunakan strategi kawalan yang dicadangkan dapat menstabilkan robot satu roda.KEYWORDS: unicycle mobile robot; nonholonomic system; LQR

Modeling and Control Design for Active Trailer Steering of Heavy Vehicles

2017 ◽  
Author(s):  
Jesse Brown ◽  
Yuping He ◽  
Haoxiang Lang
Keyword(s):  
Degrees Of Freedom ◽  
Load Transfer ◽  
Linear Quadratic Regulator ◽  
Heavy Vehicles ◽  
Linear Quadratic ◽  
Modeling And Control ◽  
Software Packages ◽  
Lqr Controller ◽  
Control Evaluation ◽  
And Control

This paper presents a linear quadratic regulator (LQR) controller for active trailer steering (ATS) of a tractor-semitrailer. The tractor-semitrailer is modelled as a linear yaw/roll model with 5 Degrees-Of-Freedom (DOF). The linear yaw/roll model is validated with a nonlinear tractor-semitrailer model developed with TruckSim under a simulated single lane-change maneuver. Then, the validated linear yaw/roll model is used to design the LQR controller for ATS. The TruckSim model and the LQR controller are integrated by means of an interface between the software packages of TruckSim and Matlab/Simulink. The LQR controller is assessed using numerical simulation of the TruckSim model with and without the ATS control. Evaluation of the controller is based on the performance measures of the trailer in terms of rearward amplification (RA), peak roll angle, and load transfer ratio (LTR). It is demonstrated that the LQR controller leads to the decrease the peak values of the aforementioned measures by 4.81%, 20.7%, and 33%, respectively.

Sign in / Sign up

Export Citation Format

Share Document