scholarly journals The Effect Analysis of Carrier Gas Flow Rate on the Rapid Gas Chromatographic Separation System

2020 ◽  
Vol 2020 ◽  
pp. 1-5
Author(s):  
Xu Zhang ◽  
Sixiang Zhang ◽  
Wei Zhou ◽  
Yang Qi

Odor pollution did not only disturb the human normal life but also aroused the attention of environmental researchers and environmental protection departments. Therefore, the research on odor detecting method and instrument is important to theory and application. On this basis, the self-developed microfluidic chip capillary column is used in our odor detecting system. In this paper, lead the chip column into the chromatography separation system, with its small size, high efficiency, easy integration, and other characteristics to replace the original traditional column. The chip column was used in many gas experiments for several typical VOCs. At different carrier gas flow rates, the baseline value, toluene response, and toluene and methyl sulfide mixed gas separation were compared to verify the experiment to determine the optimal carrier gas flow rate in accordance with its response and separation degree. Under the premise of ensuring column efficiency as high as possible, it is determined that the optimal carrier gas flow rate is 6 ml/min. This paper shows the most proper carrier gas flow rate of our odor detecting system with the self-developed microfluidic chip capillary column.

2013 ◽  
Vol 39 (3) ◽  
pp. 258-261 ◽  
Author(s):  
A. G. Kurenya ◽  
D. V. Gorodetskiy ◽  
V. E. Arkhipov ◽  
A. V. Okotrub

2015 ◽  
Vol 430 ◽  
pp. 87-92 ◽  
Author(s):  
Ming Li ◽  
Jingyun Wang ◽  
Kan Li ◽  
Yingjie Xing ◽  
H.Q. Xu

2016 ◽  
Vol 18 (3) ◽  
pp. 88-96 ◽  
Author(s):  
Najaf Ali ◽  
Mahmood Saleem ◽  
Khurram Shahzad ◽  
Sadiq Hussain ◽  
Arshad Chughtai

Abstract The yield and composition of pyrolysis products depend on the characteristics of feed stock and process operating parameters. Effect of particle size, reaction temperature and carrier gas flow rate on the yield of bio-oil from fast pyrolysis of Pakistani maize stalk was investigated. Pyrolysis experiments were performed at temperature range of 360-540°C, feed particle size of 1-2 mm and carrier gas fl ow rate of 7.0-13.0 m3/h (0.61.1 m/s superficial velocity). Bio-oil yield increased with the increase of temperature followed by a decreasing trend. The maximum yield of bio-oil obtained was 42 wt% at a temperature of 490°C with the particle size of around 1.0 mm and carrier gas flow rate of 11.0 m3/h (0.9 m/s superficial velocity). High temperatures resulted in the higher ratios of char and non-condensable gas.


1998 ◽  
Vol 12 (1) ◽  
Author(s):  
Satoru Tanaka ◽  
Hideaki Tsuchida ◽  
Hajime Sonoda ◽  
Akiyoshi Namiki

2013 ◽  
Vol 284-287 ◽  
pp. 342-346 ◽  
Author(s):  
Young Min Cho ◽  
Young Min Yang ◽  
Duck Shin Park ◽  
Soon Bark Kwon ◽  
Woo Sung Jung ◽  
...  

LiOH is known to be one of the most efficient CO2adsorbent because it reacts with CO2to form Li2CO3. However, LiOH still suffers from lack of enough hardness for practical use. In this study, various substrates, were modified with LiOH. Their X-ray diffraction patterns were investigated, and LiOH peak was observed from all prepared samples. CO2adsorption capacity of each prepared sample was measured by monitoring CO2concentration change during the adsorption process under constant CO2gas inflow condition. LiOH-modified Al2O3and zeolite 5A showed good CO2adsorption performance, while LiOH-modified AC and SiO2showed relatively poor CO2adsorption. Al2O3and zeolite 5A contains many basic functional groups of Al3+, which promote the neutralization reaction with acidic CO2. The effect of carrier gas, carrier gas flow rate, initial CO2concentration, and amount of LiOH-modified Al2O3loading was investigated. CO2 adsorption performance was better when the carrier gas was N2, because O2competes with CO2on LiOH. CO2adsorption performance was better with lower carrier gas flow rate, lower initial CO2concentration, and less loading of adsorbent due to the increase of contact time and contact points.


Sign in / Sign up

Export Citation Format

Share Document