Comparison of Clinical and Digital Assessment of Nuclear Optical Density

1999 ◽  
Vol 31 (2) ◽  
pp. 119-126 ◽  
Author(s):  
L.D. Robman ◽  
C.A. McCarty ◽  
S.K.M. Garrett ◽  
H. Stephenson ◽  
A.P. Thomas ◽  
...  
Keyword(s):  
Optical Density ◽  
Digital Assessment

Analysis of photographic emulsions for High-Voltage Electron Microscopy

1993 ◽  
Vol 51 ◽  
pp. 452-453 ◽  
Author(s):  
James R. Kremer ◽  
Paul S. Furcinitti ◽  
Eileen O’Toole ◽  
J. Richard McIntosh
Keyword(s):  
Electron Microscope ◽  
Optical Density ◽  
High Voltage ◽  
Noise Power ◽  
Limited Information ◽  
Modulation Transfer ◽  
Transmission Microscopy ◽  
High Voltage Electron Microscopy ◽  
Voltage Range ◽  
Voltage Electron

Characteristics of electron microscope film emulsions, such as the speed, the modulation transfer function, and the exposure dependence of the noise power spectrum, have been studied for electron energies (80-100keV) used in conventional transmission microscopy. However, limited information is available for electron energies in the intermediate to high voltage range, 300-1000keV. Furthermore, emulsion characteristics, such as optical density versus exposure, for new or improved emulsions are usually only quoted by film manufacturers for 80keV electrons. The need for further film emulsion studies at higher voltages becomes apparent when searching for a film to record low dose images of radiation sensitive biological specimens in the frozen hydrated state. Here, we report the optical density, speed and relative resolution of a few of the more popular electron microscope films after exposure to 1MeV electrons.Three electron microscope films, Kodak S0-163, Kodak 4489, and Agfa Scientia 23D56 were tested with a JEOLJEM-1000 electron microscope operating at an accelerating voltage of 1000keV.

Fibrinogen Montreal

1973 ◽  
Vol 29 (03) ◽  
pp. 536-546 ◽  
Author(s):  
M Lacombe ◽  
J Soria ◽  
C Soria ◽  
G d’Angelo ◽  
R Lavallee ◽  
...  
Keyword(s):  
Optical Density ◽  
Polyacrylamide Gel ◽  
Clotting Time ◽  
Functional Defect ◽  
A Chain ◽  
Fibrin Monomers

SummaryA new case of congenital dysfibrinogenemia characterized by a prolonged thrombin clotting time and a low optical density of the polymerization curve has been discovered in Montreal. The functional defect is due to an abnormal aggregation of fibrin monomers.The characteristics of this abnormal fibrinogen are serum gélification (Paracoagulation) at 37°, 22° and 4° C, a normal immuno-electrophoretic and electrofocusing pattern, a slight increase in the mobility in the α (A) chain by electrophoresis of the dissociated chains in polyacrylamide gel. However, no abnormality was found in the α (A) chain of the disulphide knot.

Automation of Two-Stage Factor VIII Assay

1978 ◽  
Vol 39 (02) ◽  
pp. 455-465 ◽  
Author(s):  
Yvonne Stirling ◽  
D J Howarth ◽  
Marguerite Vickers ◽  
W R S North ◽  
T W Meade
Keyword(s):  
Factor Viii ◽  
Optical Density ◽  
Electric Circuit ◽  
Clotting Time ◽  
Two Stage ◽  
Laboratory Error ◽  
Premature Closure ◽  
Factor Viii Concentrates ◽  
Experimental Findings ◽  
Automated Methods

SummaryTwo automated methods for two-stage factor VIII assays have been compared with one another, and evaluated in practice. The Depex method records the clotting time when an electric circuit is completed by the formation of a fibrin thread across a hook-type electrode; the Electra method is based on an optical density technique of clot detection. The two methods gave comparable results for measured levels of factor VIII when haemophilic or “normal” plasmas were assayed. Results from the two methods in practice also suggest that both are valid at low and “normal” factor VIII levels. The Electra method is also probably suitable for assays of concentrates; however, the Depex method appears to give falsely high values in these circumstances, and experimental findings suggest that the reason may be that increased viscosity due to the high fibrinogen levels in factor VIII concentrates causes premature closure of the circuit between the two ends of the Depex electrode. The main advantage of the Depex method is that, provided 3 or 4 machines are available, a given number of assays can be completed more quickly than on Electra. The main advantages of Electra are that it is probably subject to less laboratory error than Depex, and that it is suitable for assaying concentrates as well as haemophilic and “normal” plasmas.

Enhancement of Platelet Sensitivity to ADP-Aggregation by Isometric Exercise in Arteriosclerotic Patients and its Prevention

1977 ◽  
Vol 37 (02) ◽  
pp. 329-338 ◽  
Author(s):  
Tadahiro Sano ◽  
Takeshi Motomiya ◽  
Hiroh Yamazaki ◽  
Takio Shimamoto
Keyword(s):  
Cyclic Amp ◽  
Mechanical Stress ◽  
Optical Density ◽  
Platelet Function ◽  
Isometric Exercise ◽  
Phosphodiesterase Inhibitor ◽  
New Method ◽  
Platelet Aggregability ◽  
Control Subjects ◽  
Healthy Control

SummaryA new method for assessment of platelet sensitivity to ADP-aggregation was devised. Its reproducibility and the correlations between the values obtained by this method, the optical density (O. D.) method, and the screen filtration pressure (SFP) method were assessed. In summary, this method may be said to have three main points:1. It can be performed without centrifugation, avoiding mechanical stress to platelets, using only 0.8 ml. of blood and inexpensive equipment.2. It may reflect different aspects of platelet function from the O. D. method and the SFP method, despite the positive significant correlations between the values obtained by these three methods.3. It was proved to be highly reproducible and is thought to be useful clinically.By using this method, the effect of sustained isometric exercise by handgripping on platelet aggregability was assessed in coronary sclerotic and cerebral arteriosclerotic patients on placebo and EG-626, a newly synthesized cyclic AMP phosphodiesterase inhibitor. On placebo, an enhancement of platelet sensitivity was observed after isometric exercise in coronary and cerebral arteriosclerotic patients but not in healthy control subjects. The enhancement was prevented by pretreatment of EG-626, administered orally 1.5 hours prior to exercise.

Novel organic, polymeric materials for electronics applications

2002 ◽  
Vol 722 ◽  
Author(s):  
Ram W. Sabnis ◽  
Mary J. Spencer ◽  
Douglas J. Guerrero
Keyword(s):  
Optical Density ◽  
Chemical Vapor ◽  
Polymeric Materials ◽  
Substantial Improvement ◽  
Polymeric Systems ◽  
Patterned Wafers ◽  
Visible Spectra ◽  
Potential Applications ◽  
Deep Ultraviolet ◽  
Deposited Films

AbstractNovel organic, polymeric materials and processes of depositing thin films on electronics substrates by chemical vapor deposition (CVD) have been developed and the lithographic behavior of photoresist coated over these CVD films at deep ultraviolet (DUV) wavelength has been evaluated. The specific monomers synthesized for DUV applications include [2.2](1,4)- naphthalenophane, [2.2](9,10)-anthracenophane and their derivatives which showed remarkable film uniformity on flat wafers and conformality over structured topography wafers, upon polymerization by CVD. The chemical, physical and optical properties of the deposited films have been characterized by measuring parameters such as thickness uniformity, solubility, conformality, adhesion to semiconductor substrates, ultraviolet-visible spectra, optical density, optical constants, defectivity, and resist compatibility. Scanning electron microscope (SEM) photos of cross-sectioned patterned wafers showed verticle profiles with no footing, standing waves or undercut. Resist profiles down to 0.10 νm dense lines and 0.09 νm isolated lines were achieved in initial tests. CVD coatings generated 96-100% conformal films, which is a substantial improvement over commercial spin-on polymeric systems. The light absorbing layers have high optical density at 248 nm and are therefore capable materials for DUV lithography applications. CVD is a potentially useful technology to extend lithography for sub-0.15 νm devices. These films have potential applications in microelectronics, optoelectronics and photonics.

STUDY OF HOMOGENEITY, POROSITY AND INTERNAL DEFECTS IN AERATED AND EPS AGGREGATE POLY BRICKS USING NEUTRON RADIOGRAPHY TECHNIQUE

2015 ◽  
Vol 7 (2) ◽  
pp. 1428-1439
Author(s):  
Khurshed Alam ◽  
Md. Sayeedur Rahman ◽  
Md. Mostafizur Rahman ◽  
S. M. Azaharul Islam
Keyword(s):  
Optical Density ◽  
Neutron Radiography ◽  
Density Variation ◽  
Expanded Polystyrene ◽  
Elemental Distribution ◽  
Non Destructive Testing ◽  
Internal Defects ◽  
Destructive Testing ◽  
Radiographic Images ◽  
Non Destructive

A powerful non-destructive testing (NDT) technique is adopted to study the internal defects and elemental distribution/homogeneity and porosity of aerated brick and EPS aggregate poly brick samples. In the present study the internal defects like homogeneity, porosity, elemental distribution, EPS aggregate and aerator distributor in the test samples have been observed by the measurement of gray value/optical density of the neutron radiographic images of these samples. From this measurement it is found that the neutron intensity/optical density variation with the pixel distance of the AOI of the NR images in both expanded polystyrene (EPS) aggregate poly brick and aerated brick samples comply almost same in nature with respect to the whole AOI but individually each AOI shows different nature from one AOI to another and it confirms that the elemental distribution within a AOI is almost homogeneous. Finally it was concluded that homogeneity, elemental distribution in the EPS aggregate poly brick sample is better than that of the aerated brick sample. 

Use of airborne radar imagesat the mapping of steppe fire areas

1995 ◽  
pp. 67-68
Author(s):  
A. K. Monakhov ◽  
M. A. Shubina
Keyword(s):  
Optical Density ◽  
Airborne Radar ◽  
Horizontal Polarization ◽  
Made In

The article proposes the methods of using the radiolocation (RL) images for analysis of picture of steppe fire areas. The images were obtained in the sm wave-diapason with horizontal polarization and resolution in the first tens of meters. By the RL negatives, made in the summer and winter periods, the characteristics of optical density and the contrasts of RL images between fire areas and steppes were determined.

Sign in / Sign up

Export Citation Format

Share Document