scholarly journals Optimal planning of RDGs in electrical distribution networks using hybrid SAPSO algorithm

2020 ◽  
Vol 10 (6) ◽  
pp. 6153
Author(s):  
Mohammed Hamouda Ali ◽  
Mohammed Mehanna ◽  
Elsaied Othman
Keyword(s):  
Renewable Energy ◽  
Radial Distribution ◽  
Distribution Network ◽  
Distribution Networks ◽  
Sensitivity Factor ◽  
Sensitivity Index ◽  
Voltage Profile ◽  
Power Losses ◽  
Electrical Distribution ◽  
The Impact

The impact of the renewable distributed generations (RDGs), such as photovoltaic (PV) and wind turbine (WT) systems can be positive or negative on the system, based on the location and size of the DG. So, the correct location and size of DG in the distribution network remain an obstacle to achieving their full possible benefits. Therefore, the future distribution networks with the high penetration of DG power must be planned and operated to improve their efficiency. Thus, this paper presents a new methodology for integrated of renewable energy-based DG units with electrical distribution network. Since the main objective of the proposed methodology is to reduce the power losses and improve the voltage profile of the radial distribution system (RDS). In this regard, the optimization problem was formulated using loss sensitivity factor (LSF), simulated annealing (SA), particle swarm optimization (PSO) and a combination of loss sensitivity index (LSI) with SA & PSO (LSISA, LSIPSO) respectively. This paper contributes a new methodology SAPSO, which prevents the defects of SA & PSO. Optimal placement and sizing of renewable energy-based DG tested on 33-bus system. The results demonstrate the reliability and robustness of the proposed SAPSO algorithm to find the near-optimal position and size of the DG units to mitigate the power losses and improve the radial distribution system's voltage profile.

scholarly journals New Evolutionary Technique for Optimization Shunt Capacitors in Distribution Networks

2011 ◽  
Vol 62 (3) ◽  
pp. 163-167 ◽  
Author(s):  
Ali Elmaouhab ◽  
Mohamed Boudour ◽  
Rabah Gueddouche
Keyword(s):  
Radial Distribution ◽  
Annual Cost ◽  
Distribution Network ◽  
Distribution Networks ◽  
Active Power ◽  
Power Losses ◽  
Evolutionary Technique ◽  
Active Power Losses ◽  
Shunt Capacitors

New Evolutionary Technique for Optimization Shunt Capacitors in Distribution NetworksThe paper presents a new evolutionary technique for optimizing on one part the numbers, the sizes and locations of shunt capacitors in radial distribution network in away to minimize the annual cost of active power losses with the improvement of voltage profiles of different buses. The technique is applied on 10 buses network and on IEEE 34 buses network test. The results are compared with ones of previous studies using heuristiques methods and the same network tests.

scholarly journals Network Reconfiguration for Loss Reduction and Voltage Profile Improvement of 110-Bus Radial Distribution System Using Exhaustive Search Techniques

2015 ◽  
Vol 5 (4) ◽  
pp. 788
Author(s):  
Su Mon Myint ◽  
Soe Win Naing
Keyword(s):  
Radial Distribution ◽  
Power Dissipation ◽  
Distribution System ◽  
Distribution Systems ◽  
Distribution Network ◽  
Network Reconfiguration ◽  
Loss Reduction ◽  
Voltage Profile ◽  
Power Losses ◽  
Voltage Profile Improvement

Nowadays, the electricity demand is increasing day by day and hence it is very important not only to extract electrical energy from all possible new power resources but also to reduce power losses to an acceptable minimum level in the existing distribution networks where a large amount of power dissipation occurred. In Myanmar, a lot of power is remarkably dissipated in distribution system.  Among methods in reducing power losses, network reconfiguration method is employed for loss minimization and exhaustive technique is also applied to achieve the minimal loss switching scheme. Network reconfiguration in distribution systems is performed by opening sectionalizing switches and closing tie switches of the network for loss reduction and voltage profile improvement. The distribution network for existing and reconfiguration conditions are modelled and simulated by Electrical Transient Analyzer Program (ETAP) 7.5 version software. The inputs are given based on the real time data collected from 33/11kV substations under Yangon Electricity Supply Board (YESB). The proposed method is tested on 110-Bus, overhead AC radial distribution network of Dagon Seikkan Township since it is long-length, overloaded lines and high level of power dissipation is occurred in this system. According to simulation results of load flow analysis, voltage profile enhancement and power loss reduction for proposed system are revealed in this paper.

scholarly journals Loss Minimization of Power Distribution Network using Different Types of Distributed Generation Unit

2015 ◽  
Vol 5 (5) ◽  
pp. 918
Author(s):  
Su Hlaing Win ◽  
Pyone Lai Swe
Keyword(s):  
Power System ◽  
Distributed Generation ◽  
Radial Distribution ◽  
Distribution System ◽  
Reactive Power ◽  
Distribution Network ◽  
Loss Reduction ◽  
Voltage Profile ◽  
Optimum Location ◽  
Power Losses

A Radial Distribution network is important in power system area because of its simple design and reduced cost. Reduction of system losses and improvement of voltage profile is one of the key aspects in power system operation. Distributed generators are beneficial in reducing losses effectively in distribution systems as compared to other methods of loss reduction. Sizing and location of DG sources places an important role in reducing losses in distribution network. Four types of DG are considered in this paper with one DG installed for minimize the total real and reactive power losses. The objective of this methodology is to calculate size and to identify the corresponding optimum location for DG placement for minimizing the total real and reactive power losses and to improve voltage profile   in primary distribution system. It can obtain maximum loss reduction for each of four types of optimally placed DGs. Optimal sizing of Distributed Generation can be calculated using exact loss formula and an efficient approach is used to determine the optimum location for Distributed Generation Placement.  To demonstrate the performance of the proposed approach 36-bus radial distribution system in Belin Substation in Myanmar was tested and validated with different sizes and the result was discussed.

scholarly journals Siting and Sizing of DG in Medium Primary Radial Distribution System with Enhanced Voltage Stability

2014 ◽  
Vol 2014 ◽  
pp. 1-9 ◽  
Author(s):  
Sanjay Jain ◽  
Ganga Agnihotri ◽  
Shilpa Kalambe ◽  
Renuka Kamdar
Keyword(s):  
Distributed Generation ◽  
Radial Distribution ◽  
Distribution System ◽  
Voltage Stability ◽  
Reactive Power ◽  
Voltage Profile ◽  
Power Losses ◽  
Radial Distribution System ◽  
Power Loss Reduction ◽  
The Impact

This paper intends to enumerate the impact of distributed generation (DG) on distribution system in terms of active as well as reactive power loss reduction and improved voltage stability. The novelty of the method proposed in this paper is the simple and effective way of sizing and siting of DG in a distribution system by using two-port Z-bus parameters. The validity of the method is verified by comparing the results with already published methods. Comparative study presented has shown that the proposed method leads existing methods in terms of its simplicity, undemanding calculation procedures, and less computational efforts and so does the time. The method is implemented on IEEE 69-bus test radial distribution system and results show significant reduction in distribution power losses with improved voltage profile of the system. Simulation is carried out in MATLAB environment for execution of the proposed algorithm.

scholarly journals A Hybrid Optimization Approach for Power Loss Reduction and DG Penetration Level Increment in Electrical Distribution Network

Energies ◽  
2020 ◽  
Vol 13 (22) ◽  
pp. 6008
Author(s):  
Teketay Mulu Beza ◽  
Yen-Chih Huang ◽  
Cheng-Chien Kuo
Keyword(s):  
Power Loss ◽  
Distribution Network ◽  
Distribution Networks ◽  
Test System ◽  
Base Case ◽  
Optimization Approach ◽  
Loss Reduction ◽  
Voltage Profile ◽  
Electrical Distribution ◽  
Power Loss Reduction

The electrical distribution system has experienced a number of important changes due to the integration of distributed and renewable energy resources. Optimal integration of distributed generators (DGs) and distribution network reconfiguration (DNR) of the radial network have significant impacts on the power system. The main aim of this study is to optimize the power loss reduction and DG penetration level increment while keeping the voltage profile improvements with in the permissible limit. To do so, a hybrid of analytical approach and particle swarm optimization (PSO) are proposed. The proposed approach was tested on 33-bus and 69-bus distribution networks, and significant improvements in power loss reduction, DG penetration increment, and voltage profile were achieved. Compared with the base case scenario, power loss was reduced by 89.76% and the DG penetration level was increased by 81.59% in the 69-bus test system. Similarly, a power loss reduction of 82.13% and DG penetration level increment of 80.55% was attained for the 33-bus test system. The simulation results obtained are compared with other methods published in the literature.

scholarly journals Effect of Distributed Photovoltaic Generation on Short-Circuit Currents and Fault Detection in Distribution Networks: A Practical Case Study

2021 ◽  
Vol 11 (1) ◽  
pp. 405
Author(s):  
Daniel Alcala-Gonzalez ◽  
Eva Maria García del Toro ◽  
María Isabel Más-López ◽  
Santiago Pindado
Keyword(s):  
Renewable Energy ◽  
Radial Distribution ◽  
Short Circuit ◽  
Renewable Energy Sources ◽  
Distribution Network ◽  
Distribution Networks ◽  
Energy Sources ◽  
Protection Devices ◽  
Short Circuits ◽  
Short Circuit Currents

The increase in the installation of renewable energy sources in electrical systems has changed the power distribution networks, and a new scenario regarding protection devices has arisen. Distributed generation (DG) might produce artificial delays regarding the performance of protection devices when acting as a result of short-circuits. In this study, the preliminary research results carried out to analyze the effect of renewable energy sources (photovoltaic, wind generation, etc.) on the protection devices of a power grid are described. In order to study this problem in a well-defined scenario, a quite simple distribution network (similar to the ones present in rural areas) was selected. The distribution network was divided into three protection zones so that each of them had DG. In the Institute of Electrical and Electronic Engineers (IEEE) system 13 bus test feeder, the short-circuits with different levels of penetration were performed from 1 MVA to 3 MVA (that represent 25%, 50%, and 75% of the total load in the network). In the simulations carried out, it was observed that the installation of DG in this distribution network produced significant changes in the short-circuit currents, and the inadequate performance of the protection devices and the delay in their operating times (with differences of up to 180% in relation to the case without DG). The latter, that is, the impacts of photovoltaic DG on the reactions of protection devices in a radial distribution network, is the most relevant outcome of this work. These are the first results obtained from a research collaboration framework established by staff from ETSI Civil and the IDR/UPM Institute, to analyze the effect of renewable energy sources (as DG) on the protection devices of a radial distribution network.

scholarly journals Multiple DGs for Reducing Total Power Losses in Radial Distribution Systems Using Hybrid WOA-SSA Algorithm

2019 ◽  
Vol 2019 ◽  
pp. 1-20 ◽  
Author(s):  
Khalid Mohammed Saffer Alzaidi ◽  
Oguz Bayat ◽  
Osman N. Uçan
Keyword(s):  
Radial Distribution ◽  
Distribution Systems ◽  
Distribution Networks ◽  
Load Flow ◽  
Optimal Placement ◽  
Total Power ◽  
Voltage Profile ◽  
Power Losses ◽  
Standard Case ◽  
Whale Optimization

Distributed generators (DGs) are currently extensively used to reduce power losses and voltage deviations in distribution networks. The optimal location and size of DGs achieve the best results. This study presents a novel hybridization of new metaheuristic optimizations in the last two years, namely, salp swarm algorithm (SSA) and whale optimization algorithm (WOA), for optimal placement and size of multi-DG units in radial distribution systems to minimize total real power losses (kW) and solve voltage deviation. This hybrid algorithm is implemented on IEEE 13- and 123-node radial distribution test systems. The OpenDSS engine is used to solve the power flow to find the power system parameters, such power losses, and the voltage profile through the MATLAB coding interface. Results describe the effectiveness of the proposed hybrid WOA-SSA algorithm compared with those of the IEEE standard case (without DG), repeated load flow method, and WOA and SSA algorithms applied independently. The analysis results via the proposed algorithm are more effective for reducing total active power losses and enhancing the voltage profile for various distribution networks and multi-DG units.

scholarly journals Integration of Distributed Generations in Radial Distribution Network using ABC Algorithm

2019 ◽  
Vol 8 (6) ◽  
pp. 1592-1594
Keyword(s):  
Radial Distribution ◽  
Stability Index ◽  
Distribution Networks ◽  
Sensitivity Index ◽  
Optimal Size ◽  
Voltage Profile ◽  
Distributed Generations ◽  
Abc Algorithm ◽  
Radial Distribution Networks ◽  
The Stability

This paper keeps aim to integrate distributed generations(DGs) in radial distribution networks (RDNs) using ABC algorithm. The appropriate nodes of RDN is found out by the well-established loss sensitivity index. The optimal size of DGs are found out by using the ABC algorithm. The optimal integration of DGs not only reduces the loss but also increases the voltage profile and enhances the voltage stability index and hence improves the stability of the system. Here 33-node and 69-node RDNs are considered to implement the proposed method. The outcomes obtained by ABC algorithm have also been compared with that Firefly, PSO and GA algorithms

Sign in / Sign up

Export Citation Format

Share Document