scholarly journals Enhancing the LVRT Capability and Mitigation of Power Quality Issues Using UPQC of a Grid Connected Wind Conversion System

2017 ◽  
Vol 7 (3) ◽  
pp. 643
Author(s):  
C.S Boopathi ◽  
Kuppusamy Selvakumar ◽  
Avisek Dutta
Keyword(s):  
Power Quality ◽  
Reactive Power ◽  
Low Voltage ◽  
Active Filter ◽  
Shunt Active Filter ◽  
Unified Power Quality Conditioner ◽  
Conversion System ◽  
Quality Issues ◽  
Power Quality Conditioner ◽  
Doubly Fed

In this paper unified power quality conditioner has been used to enhance low voltage ride through capability of grid connected wind conversion system taking Doubly fed induction generator (DFIG). Unified Power quality conditioner (UPQC) device is a combination of series active filter and shunt active filter. This custom power device is mainly used to mitigate power quality issues which is an essential factor today because of wide application of power electronics devices. UPQC is capable to deal with voltage and current imperfection simultaneously. It is installed in the system mainly to improve the power quality i.e. Voltage sag/swell, Harmonics, reactive power compensation etc. at point of common coupling. System is modeled in MATLAB/SIMULINK and results shows utilization of UPQC for the enhancement of LVRT of a DFIG wind system according to Grid code. when fault occurs in the system, it will create voltage dip and series compensator of UPQC injects during this time to prevent disconnection from grid and stay connected to contribute during fault. UPQC is also used for fast restoration of system steady state, power factor improvement, prevent rotor over current.

scholarly journals Design and Implementation of Novel Multi-Converter-Based Unified Power Quality Conditioner for Low-Voltage High-Current Distribution System

Energies ◽  
2018 ◽  
Vol 11 (11) ◽  
pp. 3150 ◽  
Author(s):  
Bin Yang ◽  
Kangli Liu ◽  
Sen Zhang ◽  
Jianfeng Zhao
Keyword(s):  
Power Quality ◽  
Current Distribution ◽  
Distribution Systems ◽  
Reactive Power ◽  
Low Voltage ◽  
Voltage Regulation ◽  
Control Algorithms ◽  
High Current ◽  
Unified Power Quality Conditioner ◽  
Power Quality Conditioner

This paper introduces a novel multi-converter-based unified power quality conditioner (MCB-UPQC). Three optimization methods are proposed based on the traditional UPQC: (1) The shunt converter is substituted with multi-modular parallel converters. Hence, the reactive power and harmonic currents can be increased greatly, which are suitable for low-voltage high-current distribution systems. (2) The series converters consist of three H-bridge inverters, and each of the H-bridge inverters is controlled separately. The control strategy is easier to achieve and can improve the control performance of voltage regulation under unbalanced voltage sag or swell. (3) A three-phase four-leg (3P4L) converter is connected to the common DC bus of the proposed UPQC to connect the renewable energy and energy storage system. The detailed mathematical models of shunt and series converters are analyzed, respectively. A multi-proportional resonant (PR) controller is presented in the voltage regulation and reactive power compensation control algorithms. The simulation results verify the feasibility of the control algorithms. Finally, the experimental platform is established, and the experimental results are presented to verify the validity and superiority of the proposed topology and algorithms.

Voltage Dip/Swell Mitigation and Imaginary Power Compensation in Low Voltage Distribution Utilizing Improved Unified Power Quality Conditioner (I-UPQC)

2020 ◽  
Vol 49 ◽  
pp. 84-103
Author(s):  
Oluwafunso Oluwole Osaloni ◽  
Akshay Kumar Saha
Keyword(s):  
Power Quality ◽  
Reactive Power ◽  
Low Voltage ◽  
Distribution Networks ◽  
Power Sharing ◽  
Voltage Distribution ◽  
Unified Power Quality Conditioner ◽  
Imaginary Power ◽  
Power Quality Improvement ◽  
Power Quality Conditioner

The main purpose of this work is to introduced power quality improvement in low voltage distribution networks with the application of Improved Unified Power Quality Conditioner (I-UPQC). Ordinarily, in the normal UPQC, the series inverter handles active injection while the shunt inverter provides load imaginary power injection. However, in the case of I-UPQC, the series inverter of the UPQC performs two functions concurrently as a sag and swell compensator and assists the shunt inverter in load reactive power requirements. The reactive power sharing is achieved by the integration of the Power Angle Control (PAC) of UPQC to coordinate imaginary power-sharing between the two inverters. With the view that the series inverter produces active and reactive power, this concept is named I-UPQC. Full mathematical analysis to extend the PAC method to I-UPQC has been carried out in this work. The simulation and results produced in the MATLAB / SIMULINK environment and discussion to support the developed concept are also presented. The result from the proposed concept is confirmed by comparing the concept with operation unified power quality conditioner in steady-state.

scholarly journals Design and Simulation of a Unified Power Quality Conditioner by Fuzzy Logic for Egyptian Power Grid Connected to Zafarana Egypt Wind System

2019 ◽  
Vol 4 (9) ◽  
pp. 1-8
Author(s):  
Montaser Abd El Sattar ◽  
Adel A. Elbaset ◽  
Ali H. KasemAlaboudy ◽  
Wessam Arafa Hafez
Keyword(s):  
Wind Energy ◽  
Power Quality ◽  
Reactive Power ◽  
Power Grid ◽  
Energy System ◽  
Wind System ◽  
Unified Power Quality Conditioner ◽  
Wind Energy System ◽  
Power Quality Conditioner

Wind energy system is lately receiving a lot of attention, because they are cost inexpensive, environmental safe and clean renewable energy source, as compared with nuclear and fossil fuel power generation. The operational characteristics of wind electric turbines has considerable dissatisfaction and stress on the quality of electric power system. Harmonics, variations of voltage and reactive power are most of power quality issues for grid connected with wind turbine. This paper introduces a design and simulation of unified power quality conditioner using a fuzzy controller to improve the power quality for Egyptian power grid connected to Zafarana Egypt wind system. The proposed performance of the unified power quality conditioner system is verified by simulating the model using MATLAB/SIMULINK environment. The simulation results showed that the proposed unified power quality conditioner provide efficient cancellation of both load current  harmonics  and supply voltage sag in addition to compensation of reactive power, and thus making the electrical grid connected wind energy system more efficient by improving the quality of power.

Photovoltaic tied unified power quality conditioner topology based on a novel notch filter utilized control algorithm for power quality improvement

2018 ◽  
Vol 41 (7) ◽  
pp. 1912-1922 ◽  
Author(s):  
Santanu Kumar Dash ◽  
Pravat Kumar Ray
Keyword(s):  
Quality Improvement ◽  
Power Quality ◽  
Power Distribution ◽  
Control Algorithm ◽  
Notch Filter ◽  
Zero Crossing ◽  
Unified Power Quality Conditioner ◽  
Power Quality Improvement ◽  
Quality Issues ◽  
Power Quality Conditioner

Nonlinear loads and grid side disturbances in the power distribution network cause harmonic rich currents and voltage perturbations such as voltage harmonics, voltage sags and voltage swells. The unified power quality conditioner (UPQC) with shunt inverter and series inverter are usually employed for elimination of current and voltage related power quality issues. However, elimination of voltage and current quality issues in a grid connected Photovoltaic (PV) system is essential. Therefore, PV integrated UPQC topology is proposed in this paper with a novel controller for power quality improvement. The control algorithm based on notch filter Phase Locked Loop (PLL) is utilized for proper phase detection and elimination of voltage and current disturbances. PV tied UPQC controller based on notch filter PLL has the capability to avoid multiple zero crossing during highly distorted grid voltage condition. Conventional control algorithms such as synchronous reference frame theory, unit vector controller based on traditional PLL are also analyzed for the control of PV tied UPQC. The proposed system is developed in Matlab/Simulink and the results obtained are evaluated to measure the performance. A real-time hardware prototype is developed using dSPACE processor. The obtained experimental results validate the efficiency of the proposed controller for PV tied UPQC.

Modelling and Analysis of PV-Based Shunt Active Filter with BESS and Conservative Power Theory for Enhancing Power Quality

2019 ◽  
Vol 20 (6) ◽  
Author(s):  
Gomathi Ramalingam ◽  
Ajay Kumar Choudhary ◽  
Suresh Mikkili
Keyword(s):  
Power Quality ◽  
Reactive Power ◽  
Reactive Power Compensation ◽  
Active Power ◽  
Active Filters ◽  
Shunt Active Filter ◽  
Three Phase ◽  
Quality Issues ◽  
Conservative Power Theory ◽  
Conservative Power

Abstract Power Quality has always been a major concern ever since the increase in the usage of many power electronic loads such as Personal Computers (PCs), TVs, variable frequency drives in nearly every household. These loads are a major source of harmonics into the distribution system. Unbalanced Three-phase loads or different single-phase loads result in unbalance in the three-phase voltages and currents in the grid. Equipment damage, Loss of data, nuisance tripping, overheating of wires, relay tripping are few of the major issues caused due to power quality. Also, there is an increase in the awareness about the various power quality issues as well as its ill-effects amongst the consumers. Hence, it is essential to improve the quality of the power supplied. Active and Passive filters play a huge role in the mitigation of power quality issues. In recent years, usage of active filters has increased because tuning is possible for various harmonic elimination and active filters when combined with a storage system can provide active as well as reactive power compensation. The fast depletion of non-renewable sources of energy and its effect on the environment has shifted the focus on the usage of non-renewable energy sources such as solar energy, wind energy, etc for the production of electricity. In this research work, solar energy is combined with shunt active filter for the mitigation of various power quality issues occurring in a grid-connected non-linear and unbalanced three-phase load. The active power filter will provide reactive power compensation to the non-linear load and active power delivery for unbalanced loads such the grid current and voltage will remain balanced and the stress on the grid is reduced while meeting the load demand. A battery system is also integrated to store the excess energy that may be generated by the Photo-Voltaic(PV) array and acts as a source of energy when PV array output is low or nil. Conservative Power Theory is used for controlling the power injection into the system by the Voltage Source Converter(VSC). The proposed system is verified using MATLAB/SIMULINK.

Sign in / Sign up

Export Citation Format

Share Document