Abstract P002: Associations Of Bone Fracture Outcomes With Body Compositions Measurements In A Fragility Fracture Clinic Population

Circulation ◽  
2021 ◽  
Vol 143 (Suppl_1) ◽  
Author(s):  
Steven R Horbal ◽  
Brian A Derstine ◽  
Edward Brown ◽  
Nidhi V Shah ◽  
Brianna Henderson ◽  
...  

Introduction: While preoperative bone health optimization is typical in the fragile population, objective assessment is limited. Among the aged, localized discordance in bone loss is prevalent and may not be assessed properly with traditional diagnostic measures. Etiology for bone loss discordance is unknown, but may be attributed to aging, disease state, habitus, or activity. This study investigated the association between body composition measures and common fragility fractures. Hypothesis: We hypothesized that each different fracture outcome would associate differently with measures of body composition. Methods: The Fragility Fracture Clinic at the University of Michigan provides comprehensive care to promote bone health, accelerate healing, and reduce fracture risk in those with and at-risk for fractures. Participants (N=344) included those who enrolled at the clinic between 2013 and 2020 and received an abdomen and/or pelvis computed tomography (CT) scan up to 120 days prior to initial enrollment date. Fracture categorizations included acute vs. non-acute, intensity (high vs. low energy), and location (thoracic vs. lumbar vertebral). Retrospective CT-scans were obtained from the University of Michigan Picture Archive and Communication System. Analytic Morphomics was used to obtain granular vertebral-indexed measurements of vertebral bone density, fascia, adipose tissue, muscle, vasculature, and interior body dimensions. Relevant measures include bone mineral density (BMD) [vertebral body trabecular bone density in Hounsfield Units (HU)], lower muscle group density in HU (DMG) (cross sectional area of DMG in HU range of 31-100), cortical bone density [anterior cortical half-maximum (in HU)], and fascial width (in mm). Measurements were divided by their standard deviation to ease interpretation of odds ratios. Multivariable logistic regression was used to evaluate the relationship between body measures and fracture type. Coefficients are reported as odds ratio (OR) and 95% confidence interval (CI). An alpha level of 0.05 determine statistical significance. Results: Associations were observed between acute fracture and BMD at L3 [OR 0.58, 95% CI 0.36-0.85]; high energy fracture and DMG at L3 [OR 2.08, 1.05-4.64]; low energy fracture and BMD at T8 [OR 0.39, 0.17-0.81]; thoracic vertebral fractures and BMD at T11 [OR 0.39, 0.17-0.81], cortical bone density at T11 [OR 0.64, 0.40-0.95], and fascial width at L4 [OR 0.67, 0.43-0.98]; lumbar vertebral fracture and BMD at L3 [OR 0.44, 95% CI 0.20-0.88]. Conclusion: Body composition measures uniquely associated with fracture outcomes. Lower vertebral trabecular bone density was associated with acute, high energy, thoracic vertebral, and lumbar vertebral fractures; lower lean muscle with high energy fractures; cortical bone density and facial (i.e. visceral cavity) width with thoracic vertebral fractures.

2010 ◽  
Vol 37 (7) ◽  
pp. 1473-1479 ◽  
Author(s):  
EDMUND K. LI ◽  
TRACY Y. ZHU ◽  
LAI-SHAN TAM ◽  
VIVIAN W. HUNG ◽  
JAMES F. GRIFFITH ◽  
...  

Objective.We assessed the relationship between vertebral fracture and bone microarchitecture in patients with systemic lupus erythematosus (SLE) on chronic corticosteroid therapy using high-resolution peripheral quantitative computed tomography (HR-pQCT).Methods.Fifty-nine Chinese women with SLE taking corticosteroid were selected to participate in a cross-sectional study. Vertebral fracture was confirmed semiquantitatively by lateral radiographs of the thoracic and lumbar spine. Density and microarchitecture at the distal radius were measured with HR-pQCT. Areal bone mineral density (aBMD) at hip and lumbar spine was measured by dual-energy x-ray absorptiometry (DEXA).Results.Twelve patients had vertebral fractures. The aBMD of spine or hip did not differ between those with and without vertebral fractures. Measures by HR-pQCT revealed that patients with vertebral fractures had significantly lower level of average bone density (p = 0.007), cortical bone density (p = 0.029), trabecular bone density (p = 0.024), trabecular bone volume to tissue volume (p = 0.023), and trabecular thickness (p = 0.011) than those without vertebral fractures. Independent explanatory variables associated with higher risk of vertebral fractures were older age (p = 0.013) and lower average cortical bone density (p = 0.029).Conclusion.Vertebral fracture in patients with SLE on chronic corticosteroid treatment was associated with alterations of bone density and microarchitectures measured by HR-pQCT and DEXA. However, alterations were more pronounced in measurements by HR-pQCT. Low cortical bone density and old age were significant predictors of vertebral fracture risk.


Bone Reports ◽  
2022 ◽  
pp. 101166
Author(s):  
Amandha L. Bittencourt ◽  
Maria Eugênia F. Canziani ◽  
Larissa D.B.R. Costa ◽  
Carlos E. Rochitte ◽  
Aluizio B. Carvalho

Bone ◽  
1988 ◽  
Vol 9 (4) ◽  
pp. 251-252
Author(s):  
P Lips ◽  
R Hesp ◽  
JR Green ◽  
R Wootton ◽  
L Klenerman ◽  
...  

Materials ◽  
2020 ◽  
Vol 13 (24) ◽  
pp. 5615
Author(s):  
Jie Jin ◽  
Gi-Tae Kim ◽  
Jae-Sung Kwon ◽  
Sung-Hwan Choi

Miniscrews have gained recent popularity as temporary anchorage devices in orthodontic treatments, where failure due to sinus perforations or damage to the neighboring roots have increased. Issues regarding miniscrews in insufficient interradicular space must also be resolved. This study aimed to evaluate the primary stability of miniscrews shorter than 6 mm and their feasibility in artificial bone with densities of 30, 40, and 50 pounds per cubic foot (pcf). The primary stability was evaluated by adjusting the intrabony miniscrew length, based on several physical properties: maximum insertion torque (MIT), maximum removal torque (MRT), removal angular momentum (RAM), horizontal resistance, and micromotion. The MIT and micromotion results demonstrated that the intrabony length of a miniscrew significantly affected its stability in low-density cortical bone, unlike cases with a higher cortical bone density (p < 0.05). The horizontal resistance, MRT, and RAM were affected by the intrabony length, regardless of the bone density (p < 0.05). Thus, the primary stability of miniscrews was affected by both the cortical bone density and intrabony length. The effect of the intrabony length was more significant in low-density cortical bone, where the implantation depth increased as more energy was required to remove the miniscrew. This facilitated higher resistance and a lower risk of falling out.


2017 ◽  
Vol 33 (1) ◽  
pp. 54-62 ◽  
Author(s):  
Elizabeth J Samelson ◽  
Serkalem Demissie ◽  
L Adrienne Cupples ◽  
Xiaochun Zhang ◽  
Hanfei Xu ◽  
...  

Sign in / Sign up

Export Citation Format

Share Document