Application of the Taguchi Method to Optimize the Surface Quality of Gas Assist Injection Molded Composites

2000 ◽  
Vol 19 (17) ◽  
pp. 1352-1362 ◽  
Author(s):  
Shih-Jung Liu ◽  
Jer-Haur Chang
Keyword(s):  
Taguchi Method ◽  
Surface Quality ◽  
Injection Molded

Methods to Improve the Surface Quality of Microcellular Injection Molded Parts - A Review

2016 ◽  
Author(s):  
Carla Lima ◽  
Filipe Andrade ◽  
Cristina Kawakami ◽  
Cristiane Gonçalves ◽  
Walmir Peraro
Keyword(s):  
Surface Quality ◽  
Molded Parts ◽  
Injection Molded

The Effect of Polymer Additives on Surface Quality of Microcellular Injection Molded Parts

2011 ◽  
Vol 26 (4) ◽  
pp. 429-436
Author(s):  
J. Lee ◽  
L.-S. Turng ◽  
J. Peng ◽  
E. Dougherty ◽  
P. Gorton
Keyword(s):  
Surface Quality ◽  
Polymer Additives ◽  
Molded Parts ◽  
Injection Molded

Welding Parameter Optimization of Surface Quality by Taguchi Method

2014 ◽  
Vol 660 ◽  
pp. 109-113
Author(s):  
Chuan Huat Ng ◽  
Mohd Khairulamzari Hamjah
Keyword(s):  
Taguchi Method ◽  
Surface Quality ◽  
Weld Pool ◽  
Welding Current ◽  
Droplet Formation ◽  
Welding Parameter ◽  
Welding Parameters ◽  
Weld Parameters ◽  
Selection Of

An experimental study of GTAW was conducted to determine the optimization of weld parameters on the droplet formation in the surface quality of weld pools. These optimization investigations consisted of welding current, welding speed and feed rate. The strength and surface quality of weld pool were measured for each specimen after the welding parameter optimizations and the effect of these parameters on droplet formation were researched. To consider these quality characteristics together in the selection of welding parameters, the Orthogonal Array of Taguchi method is adopted to analyze the effect of each welding parameter on the weld pool quality, and then to determine the welding parameters with the optimal weld pool quality.

scholarly journals Influence of Finishing Operations and Melt Flow Index on Surface Quality of Injection Molded Parts

2016 ◽  
Vol 16 (2) ◽  
pp. 334-338 ◽  
Author(s):  
Jiří Čop ◽  
Ladislav Fojtl ◽  
Ondřej Bílek ◽  
Vladimír Pata
Keyword(s):  
Surface Quality ◽  
Melt Flow Index ◽  
Flow Index ◽  
Melt Flow ◽  
Molded Parts ◽  
Injection Molded

A novel method for improving the surface quality of microcellular injection molded parts

Polymer ◽  
2011 ◽  
Vol 52 (6) ◽  
pp. 1436-1446 ◽  
Author(s):  
Jungjoo Lee ◽  
Lih-Sheng Turng ◽  
Eugene Dougherty ◽  
Patrick Gorton
Keyword(s):  
Surface Quality ◽  
Molded Parts ◽  
Novel Method ◽  
Injection Molded
Sign in / Sign up

Export Citation Format

Share Document