A proposed method for the calculation of light emitting diode road lighting

2012 ◽  
Vol 44 (2) ◽  
pp. 186-196 ◽  
Author(s):  
S Zalewski
Energies ◽  
2019 ◽  
Vol 12 (6) ◽  
pp. 1109
Author(s):  
Roman Sikora ◽  
Przemysław Markiewicz

The paper presents the results of laboratory tests concerning the measurements of electrical parameters of road lighting luminaires. These measurements were focused on determining the dependence of the electrical parameters of the luminaires versus the changes of the RMS (Root Mean Square) value of the supply voltage and the level of disturbances in the supply voltage. The basic electrical parameters for light-emitting diode (LED) luminaires were analysed with the option of luminous flux adjustment if it existed. During the laboratory measurements, the luminaires were powered from the Agilent 6834B distorted voltage generator within the assumed acceptable range of the changes in the deformation level resulting from the applicable legal provisions for the reproduction of actual power supply conditions.


2016 ◽  
Vol 50 (2) ◽  
pp. 266-281 ◽  
Author(s):  
A Shahar ◽  
R Brémond ◽  
C Villa

Road delineation treatments enhance the ability of drivers to control their vehicle safely on winding roads. A simulator experiment compared night-time driving on a country road under three conditions: on an unlit road, on a road illuminated on curves by typical road luminaires, and on a road with an active lane delineation application, where self-luminous road studs are turned on to outline the lane and road edges as the driver approaches and passes the curves. The unlit condition induces greater lateral position variability and longer crossovers relative to the studs condition, demonstrating better lateral vehicle control in the latter. The luminaires condition induce greater lateral position variability in left curves, and longer crossovers in right curves, relative to the studs condition, which also demonstrates a better lateral vehicle control in the studs condition. At a subjective level, the participants perceived both the studs condition and the luminaires condition as safer, more comfortable and allowing better control than the unlit road. It was concluded that the tested application enhanced the ability of drivers to control the virtual car, as compared to an unlit road or road lighting.


2013 ◽  
Vol 291-294 ◽  
pp. 2749-2753 ◽  
Author(s):  
Xin Chen ◽  
Chun Hai Wu ◽  
Xiao Dong Zheng

This paper presents the measurement results of the reduced luminance coefficients of an asphalt pavement sample under three common light sources: high pressure sodium lamp (HPS), metal halide lamp (MH), and light-emitting diode (LED), with a specially designed two-dimensional gonioreflectometer. The relative spectral reflectances are obtained with calculation for three different incident angles which indicate light sources with high output in the long wavelength region may be more effective. The measured average luminance coefficient for HPS and MH are 17% larger than that of LED. It means that LED road lamps need higher illuminance than HPS and MH to realize the same brightness for road lighting.


2020 ◽  
pp. 144-148

Chaos synchronization of delayed quantum dot light emitting diode has been studied theortetically which are coupled via the unidirectional and bidirectional. at synchronization of chaotic, The dynamics is identical with delayed optical feedback for those coupling methods. Depending on the coupling parameters and delay time the system exhibits complete synchronization, . Under proper conditions, the receiver quantum dot light emitting diode can be satisfactorily synchronized with the transmitter quantum dot light emitting diode due to the optical feedback effect.


Sign in / Sign up

Export Citation Format

Share Document