Microwave Drying of Pitaya (Hylocereus) Peel and the Effects Compared with Hot-Air and Freeze-drying

2019 ◽  
Vol 62 (4) ◽  
pp. 919-928 ◽  
Author(s):  
Ying Ming Chew ◽  
V. An-Erl King
Keyword(s):  
Freeze Drying ◽  
Arrhenius Equation ◽  
Moisture Diffusivity ◽  
Microwave Drying ◽  
Effective Moisture Diffusivity ◽  
Fick’S Law ◽  
Fick's Law ◽  
Hot Air ◽  
Effective Moisture ◽  
Dpph Scavenging

Abstract. Microwave drying (MD) of pitaya peel was performed at 75, 225, 375, 525, and 750 W. The drying effects on the effective moisture diffusivity (De), total polyphenol content (TPC), betalain content, DPPH scavenging ability, and rehydration abilities of pitaya peel were examined. The data were compared with hot-air drying (HD) at 100°C for 4 h and freeze-drying (FD) for 24 h. The results showed that the MD kinetics of pitaya peel fit Fick’s law and the Arrhenius equation with an activation energy (Ea) of 34.08 W g-1. The De values of MD, which ranged from 2.35E-07 m2 s-1 (at 75 W) to 5.56E-06 m2 s-1 (at 750 W), indicated that the effectiveness of MD was appreciably higher than that of HD (2.44E-08 m2 s-1) and FD (4.43E-09 m2 s-1). Although MD resulted in decreased betacyanin (9.31 mg L-1 extract) and betaxanthin (6.58 mg L-1 extract) contents, the DPPH inhibition of pitaya peel remained at 75% due to an increase in TPC (115 mg GAE per 100 FW). MD of pitaya peel can also provide higher rehydration ability than HD and was comparable to FD. This study concludes that MD of pitaya peel was highly effective while maintaining high levels of TPC and DPPH inhibition. Keywords: Arrhenius equation, Effective moisture diffusivity, Fick’s law, Microwave drying, Pitaya peel.

Comparative Study on Drying of Selected Marine Products: Bombay Duck (Herpodon nehereus) and Prawn (Penaeus indicus)

2011 ◽  
Vol 7 (4) ◽  
Author(s):  
Ganesh Lotanrao Visavale ◽  
Parag P Sutar ◽  
Bhaskar Narayan Thorat
Keyword(s):  
Freeze Drying ◽  
Moisture Diffusivity ◽  
Effective Moisture Diffusivity ◽  
Hot Air ◽  
Effective Moisture ◽  
Page Model ◽  
Drying Behavior ◽  
Marine Products ◽  
Drying Rates ◽  
Bombay Duck

A study on drying of two types of fish, viz., Bombay duck and Prawn, using the open sun, a solar cabinet, hot air and freeze drying was carried out. The fish were dried to 5–6% moisture content. The drying rates were calculated and drying data were fitted to the Page model, and on the basis of R2 and RMSE values it was found that the Page model describes satisfactorily the drying behavior of Bombay duck and Prawn. Also, effective moisture diffusivity values were calculated during fish drying by different methods. The values of the average effective moisture diffusivity of Bombay duck and Prawn were in the range of 1.01 × 10-9 to 1.51 × 10-9 m2 s-1and 0.21 × 10-9 to 0.31 × 10-9 m2 s-1, respectively. Freeze drying was found to provide the best quality of dehydrated product, which was as expected. Solar cabinet drying was found to be a low-energy intensive process compared to freeze and hot air drying, resulting in a dehydrated product with acceptable quality.

Microwave Drying of Tilapia Fillets: Kinetics and Modeling

2011 ◽  
Vol 396-398 ◽  
pp. 1306-1312 ◽  
Author(s):  
Bao Yan Zhang ◽  
Yin Zhe Jin ◽  
Yu Dong Cheng
Keyword(s):  
Experimental Data ◽  
Temperature Distribution ◽  
Mathematical Models ◽  
Output Power ◽  
Moisture Diffusivity ◽  
Microwave Drying ◽  
Effective Moisture Diffusivity ◽  
Effective Moisture ◽  
Tilapia Fillets ◽  
Kinetics Of

To study the effect of microwave output power on the drying kinetics of tilapia fillets, the drying experiments were carried out at 150W, 250W, 500W, 700W and 900W, respectively. And ten mathematical models were involved to fit experimental data. It was found that Midilli et al model gave a best fitness for this conditions applied. Besides, effective moisture diffusivity increased progressively from 1.6248×10-9(m2/s) to 10.0735×10-9(m2/s) as the power increased from 150W to 900W. In addition, to obtain more homogeneous samples, temperature distribution of tilapia fillets was analyzed when they were put in different layout forms.

Moisture Diffusivity and Energy Consumption during Microwave Drying of Plaster of Paris

2010 ◽  
Vol 5 (1) ◽  
Author(s):  
Magesh Ganesh Pillai ◽  
Iyyasamy Regupathi ◽  
Lima Rose Miranda ◽  
Thanapalan Murugesan
Keyword(s):  
Energy Consumption ◽  
Initial Moisture Content ◽  
Moisture Diffusivity ◽  
Operating Conditions ◽  
Microwave Drying ◽  
Effective Moisture Diffusivity ◽  
Experimental Conditions ◽  
Drying Time ◽  
Plaster Of Paris ◽  
Effective Moisture

The drying characteristics of plaster of paris (POP) under microwave conditions at different microwave power input, initial moisture content, sample thickness and drying time were studied. Further the experimental data on moisture ratio of POP for different operating conditions were obtained and calculations were made using nine basic drying model equations. The appropriate model with modified constants and coefficients to represent the drying kinetics of POP was found through the analysis of the statistical analysis. The effective moisture diffusivity of the drying process was also computed for different experimental conditions and a relationship between the drying rate constant and the effective moisture diffusivity was obtained. The energy consumption for microwave drying of plaster of paris at different experimental conditions were also computed.

Modelling Effective Moisture Diffusivity of Pumpkin (Cucurbita moschata) Slices under Convective Hot Air Drying Condition

2016 ◽  
Vol 12 (5) ◽  
pp. 481-489 ◽  
Author(s):  
Daniel I. Onwude ◽  
Norhashila Hashim ◽  
Rimfiel B. Janius ◽  
Nazmi Nawi ◽  
Khalina Abdan
Keyword(s):  
Activation Energy ◽  
Moisture Diffusivity ◽  
Effective Moisture Diffusivity ◽  
Slice Thickness ◽  
Cucurbita Moschata ◽  
Drying Time ◽  
Hot Air ◽  
Effective Moisture ◽  
Shrinkage Effect ◽  
Increasing Temperature

Abstract This study seeks to investigate the effects of temperature (50, 60, 70 and 80 °C) and material thickness (3, 5 and 7 mm), on the drying characteristics of pumpkin (Cucurbita moschata). Experimental data were used to estimate the effective moisture diffusivities and activation energy of pumpkin by using solutions of Fick’s second law of diffusion or its simplified form. The calculated value of moisture diffusivity with and without shrinkage effect varied from a minimum of 1.942 × 10–8 m2/s to a maximum of 9.196 × 10–8 m2/s, while that of activation energy varied from 5.02158 to 32.14542 kJ/mol with temperature ranging from 50 to 80 °C and slice thickness of 3 to 7 mm at constant air velocity of 1.16 m/s, respectively. The results indicated that with increasing temperature, and reduction of slice thickness, the drying time was reduced by more than 30 %. The effective moisture diffusivity increased with an increase in drying temperature with or without shrinkage effect. An increase in the activation energy was observed due to an increase in the slice thickness of the pumpkin samples.

scholarly journals Modelling the Drying Characteristics and Kinetics of Hot Air-Drying of Unblanched Whole Red Pepper and Blanched Bitter Leaf Slices

2017 ◽  
Vol 5 (1) ◽  
pp. 24
Author(s):  
Samuel Enahoro Agarry
Keyword(s):  
Moisture Diffusivity ◽  
Effective Moisture Diffusivity ◽  
Red Pepper ◽  
Coefficient Of Determination ◽  
Drying Time ◽  
Drying Characteristics ◽  
Hot Air ◽  
Effective Moisture ◽  
Drying Curves ◽  
Kinetics Of

The objective of this study was to investigate the drying characteristics and kinetics of red pepper and bitter leaf under the influence of different drying temperatures. The drying experiments were carried out at dry bulb temperature of 35, 45, 55 and 75oC, respectively in an oven dryer. The results showed that as drying temperature increased, drying rate also increased and the drying time decreased. It was observed that un-sliced red pepper and sliced bitter leaf would dry within 2.5-12 h and 1.67-7 h, respectively at temperature ranging from 75 to 35oC. The drying of red pepper and bitter leaf was both in the constant and falling rate period. Four semi-empirical mathematical drying models (Newton, Page, Henderson and Pabis, and Logarithmic models) were fitted to the experimental drying curves. The models were compared using the coefficient of determination (R^2) and the root mean square error (RMSE). The Page model has shown a better fit to the experimental drying data of red pepper and bitter leaf, respectively as relatively compared to other tested models. Moisture transport during drying was described by the application of Fick’s diffusion model and the effective moisture diffusivity was estimated. The value ranges from 15.69 to 84.79 × 10-9 m2/s and 0.294 to 1.263 × 10-9 m2/s for red pepper and bitter leaf, respectively. The Arrhenius-type relationship describes the temperature dependence of effective moisture diffusivity and was determined to be 37.11 kJ/mol and 32.86 kJ/mol for red pepper and bitter leaf, respectively. A correlation between the drying time and the heat transfer area was also developed.

Effective moisture diffusivity and drying simulation of walnuts under hot air

2020 ◽  
Vol 150 ◽  
pp. 119283 ◽  
Author(s):  
Chang Chen ◽  
Chandrasekar Venkitasamy ◽  
Weipeng Zhang ◽  
Ragab Khir ◽  
Shrinivasa Upadhyaya ◽  
...  
Keyword(s):  
Moisture Diffusivity ◽  
Effective Moisture Diffusivity ◽  
Hot Air ◽  
Effective Moisture

scholarly journals Effective moisture diffusivity during hot air solar drying of tomato slices

2016 ◽  
Vol 62 (No. 1) ◽  
pp. 15-23 ◽  
Author(s):  
H. Samimi Akhijani ◽  
A. Arabhosseini ◽  
M.H. Kianmehr
Keyword(s):  
Moisture Diffusivity ◽  
Effective Moisture Diffusivity ◽  
Slice Thickness ◽  
Solar Drying ◽  
Air Velocity ◽  
Hot Air Drying ◽  
Chi Square ◽  
Air Drying ◽  
Hot Air ◽  
Effective Moisture

Mathematical modelling and effective moisture diffusivity of tomato (Lycopersicon esculentum) was studied during hot air solar drying. An experimental solar dryer with a swivel collector was used for experiments. The collector followed the solar radiation using a precious sensor. Drying experiments were performed in a thin layer hot air drying at slice thicknesses of 3, 5 and 7 mm and air velocities of 0.5, 1 and 2 m/s. The experimental data were fitted to different mathematical moisture ratio models and the Page model was selected as the best model according to correlation coefficient R<sup>2</sup>, chi-square &chi;<sup>2</sup> and root mean square error (RMSE) parameters. The maximum values of moisture diffusivity was&nbsp;6.98 &times; 10<sup>&ndash;9</sup> m<sup>2</sup>/s at air velocity of 2 m/s and slice thickness of 7 mm while the minimum value of the moisture diffusivity was 1.58 &times; 10<sup>&ndash;9</sup> m<sup>2</sup>/s at air velocity of 0.5 m/s and slice thickness of 3 mm.

Sign in / Sign up

Export Citation Format

Share Document