Simultaneous multiple-point velocity measurements using laser-induced iodine fluorescence

1983 ◽  
Vol 8 (1) ◽  
pp. 51 ◽  
Author(s):  
J. C. McDaniel ◽  
B. Hiller ◽  
R. K. Hanson
2017 ◽  
Vol 48 (3) ◽  
pp. 616-633 ◽  
Author(s):  
G. Farina ◽  
S. Alvisi ◽  
M. Franchini

This paper presents a procedure for estimating discharge in a river cross-section based on the combined use of dimensionless isovels and point velocity measurements. Specifically, taking the Biot–Savart law on the magnetic field induced by an electric current in a wire as their basis as already done by other researchers, the authors propose a new formulation of the relationship characterizing the effect of the wetted perimeter on the range of velocities in a cross-section in order to take explicit account of roughness, expressed by means of Manning's coefficient. Once appropriately nondimensionalized, the isoeffect contours can be read as dimensionless isovels. Assuming in situ velocity measurements are available, discharge at a cross-section can be computed using two different methods. The proposed procedure was applied to six case studies characterized by river cross-sections which differed greatly from one another. The results show that the two methods proposed for estimating discharge lead to equivalent outcomes, and in all the cases the procedure as a whole enables a sufficiently accurate estimation of discharge, even when it is based on a limited number of velocity measurements or on the measurement of maximum surface-water velocity alone.


Author(s):  
David E. Montgomery ◽  
Robert L. West

Abstract Experimental spatial dynamics modeling involves using scanning lasers to sample surface shape and dynamic response of structures in order to verify structural dynamics design intent. Formation of accurate spatial models from laser-based measurements requires that laser position and orientation be registered relative to a fixed coordinate system. A three point direct registration procedure is defined for shape modeling using laser range and mirror deflection angles. Surface velocity measurements with a portable laser Doppler vibrometer (LDV) also require registration, but range information is unavailable. A multiple point indirect registration algorithm for the LDV is described that involves minimizing three nonlinear equations. A simulated laser rangefinder (LRF) was developed for demonstrating three point direct registration. The 3-D geometry of a compressor housing was modeled by combining range data from multiple laser positions. The multiple point indirect registration was applied to 3-D velocity response field reconstruction of a composite plate from velocity measurements scanned at three separate positions.


Author(s):  
M Walsh ◽  
T McGloughlin ◽  
D W Liepsch ◽  
T O'Brien ◽  
L Morris ◽  
...  

The objective of this investigation was to assess the use of experimentally estimated wall shear stresses to validate numerically predicted results. The most commonly cited haemodynamic factor implicated in the disease initiation and proliferation processes at graft/artery junctions is wall shear stress (WSS). WSS can be determined from the product of the viscosity of the fluid and the wall shear rate. Numerically, the wall shear rate is predicted using velocity values stored in the computational cell near the wall and assuming zero velocity at the wall. Experimentally, the wall shear rate is estimated by applying a curve-fit to near-wall velocity measurements and evaluating the shear rate at a specific distance from the wall. When estimating the wall shear rate from the laser Doppler anemometry (LDA) point velocity measurements, large differences between the experimentally estimated and numerically predicted WSSs were introduced. It was found that the estimated WSS distributions from the experimental results are highly dependent on the curve-fitting method used to calculate the wall shear rate. However, the velocity profiles for both the experimental and numerical investigations show extremely good comparison. It is concluded that numerical models should be validated using unprocessed LDA point velocity measurement and not estimated WSS values.


Ground Water ◽  
2015 ◽  
Vol 54 (3) ◽  
pp. 394-405 ◽  
Author(s):  
P.C. Schillig ◽  
J.F. Devlin ◽  
D. Rudolph

2008 ◽  
Vol 601 ◽  
pp. 281-315 ◽  
Author(s):  
S. C. C. BAILEY ◽  
S. TAVOULARIS

Velocity measurements were performed in a wing-tip vortex wandering in free-stream turbulence using two four-wire hot-wire probes. Vortex wandering was well represented by a bi-normal probability density with increasing free-stream turbulence resulting in increased amplitude of wandering. The most dominant wavelength of wandering was found to remain unaffected by free-stream conditions. Two-point velocity measurements were used to reconstruct the vortex velocity profile in a frame of reference wandering with the vortex. Increasing turbulence intensity was found to increase the rate of decay of the vortex peak circumferential velocity while the radial location of this peak velocity remained unchanged. These results are consistent with several possible vortex decay mechanisms, including the stripping of vorticity by azimuthally aligned vortical structures, transfer of angular momentum from the vortex to these structures during their formation and the deformation and breakup of the vortex by strong free-stream eddies.


Sign in / Sign up

Export Citation Format

Share Document