Gravity and Centrifugal Force

Two biomedical alloys, Ti -39 Nb -5.1 Ta -7.1 Zr ( TNTZ1 ) and Ti -35.3 Nb -5.1 Ta -7.1 Zr ( TNTZ2 ) were melted using LZ5 type centrifugal equipment for casting titanium. The solidification microstructures of TNTZ1 and TNTZ2 alloys cast in graphite crucible without centrifugal force are mostly big arborescent crystal with dispersed porosity in it. After pouring into a graphite mould under centrifugal force, the lower part of ingot showed mostly arborescent crystals with few equiaxed crystals, while the upper part of ingot is basically spherical equiaxed crystals. The solidification defects, such as dispersed pores were very difficult to find. Nb is supposed to refine the arborescent crystals. X-ray diffraction (XRD) analysis showed Ti -phase and Nb -phase existing in the above two alloys. The content of Ti was found relatively low in crystal interior and relatively high in crystal boundary. The content of Nb/Zr was uniform in whole microstructure.

Download Full-text

Study of the Effect of Centrifugal Force on Rotor Blade Icing Process

International Journal of Aerospace Engineering ◽

10.1155/2017/8695170 ◽

2017 ◽

Vol 2017 ◽

pp. 1-9 ◽

Cited By ~ 1

Author(s):

Zhengzhi Wang ◽

Chunling Zhu

Keyword(s):

Numerical Simulation ◽

Centrifugal Force ◽

Rotor Blade ◽

Flow Direction ◽

Three Dimensional ◽

Simulation Method ◽

Two Phase ◽

Numerical Simulation Method ◽

Calculation Results ◽

Flow Field Characteristics

In view of the rotor icing problems, the influence of centrifugal force on rotor blade icing is investigated. A numerical simulation method of three-dimensional rotor blade icing is presented. Body-fitted grids around the rotor blade are generated using overlapping grid technology and rotor flow field characteristics are obtained by solving N-S equations. According to Eulerian two-phase flow, the droplet trajectories are calculated and droplet impingement characteristics are obtained. The mass and energy conservation equations of ice accretion model are established and a new calculation method of runback water mass based on shear stress and centrifugal force is proposed to simulate water flow and ice shape. The calculation results are compared with available experimental results in order to verify the correctness of the numerical simulation method. The influence of centrifugal force on rotor icing is calculated. The results show that the flow direction and distribution of liquid water on rotor surfaces change under the action of centrifugal force, which lead to the increasing of icing at the stagnation point and the decreasing of icing on both frozen limitations.

Download Full-text