Interstitial laser irradiation of cerebral gliomas – neurobiological background, technique and typical results

2014 ◽  
Vol 3 (2) ◽  
Author(s):  
Wernholt von Tempelhoff ◽  
Frank Ulrich ◽  
Hans-Joachim Schwarzmaier

AbstractBackground:The most common type of primary brain tumors are gliomas. For patients unsuitable for open microsurgery having been treated by radiochemotherapy, laser irradiation has proven to be an alternative palliative option. From summer 1997 until winter 2006 we performed about 60 laser-interstitial thermotherapy (LITT) treatments, starting with patients with large recurrent tumors who had no other therapeutic option. In the present article we report about the neurobiological background, the technique and our experience with LITT of cerebral gliomas.Materials and method:For laser irradiation we used a specially designed light guide (LITT standard applicator; Trumpf Medizintechnik, Umkirch, Germany). The tip of this light guide is a special optical diffuser which is characterized by a homogeneous spherical or ellipsoid emission profile. The light guide was introduced into an appropriate protective sheath (Somatex, Teltow, Germany). For the laser light source, we used a continuous wave 1064-nm Nd:YAG laser (mediLas fibertom 4060 N; Dornier MedTech, Weßling, Germany). Laser irradiation was performed under general anesthesia in a 0.5 T open configuration magnetic resonance (MR) system (Signa SP; General Electric, Milwaukee, WI, USA). Usually, the tip of the light guide was positioned in the center of the tumor using the built-in localization system (Flashpoint 3000; IGT, Boulder, CO, USA) in combination, where appropriate, with a specially designed navigation system (Localite™, Bonn, Germany). The position of the light guide was then controlled using multiplanar reconstructions of T1-weighted sequences. For near real-time control, temperature monitoring was performed using an experimental software package based on the temperature-dependent shift of the MR signal. Laser irradiation was ceased when the temperature monitoring revealed a steady state temperature profile within the heated tissue. Since 2008 we have used traditional stereotactic targeting and methionine positron emission tomography/computed tomography (MET-PET/CT) instead of the ‘open’ MR system for planning and follow-up in LITT of brain tumors.Results:We started the LITT treatment of gliomas in the early 1990s (benign gliomas in eloquent regions/not suitable for surgery). In 1997 we started to treat patients with recurrent gliobastomas/anaplastic gliomas. All of these patients had an increased survival in comparison to the natural course of recurrent glioblastomas. There were no procedure-related deaths or permanent neurological deficits. Two factors seem to be important for the overall success of the LITT procedure: 1) an early enrollment in the LITT therapy after diagnosis of a tumor recurrence, and 2) a corresponding smaller tumor mass at the beginning of the therapy.Conclusion:Cytoreduction by laser irradiation seems to be a promising option for patients suffering from gliomas.

2001 ◽  
Vol 89 (12) ◽  
pp. 8273-8278 ◽  
Author(s):  
Yuri Kaganovskii ◽  
Irena Antonov ◽  
Fredrick Bass ◽  
Michael Rosenbluh ◽  
Audrey Lipovskii

2010 ◽  
Vol 14 (2) ◽  
pp. 459-467 ◽  
Author(s):  
Mayada Tahir

Cornea thermal damage due to incidental continuous wave CO2 laser irradiation is studied numerically based on bio-heat equation. The interaction of laser with tissue leads to a rapid temperature increased in target and the nearby tissue. As the temperature of the eye surface reaches 44?C, a sensation of pain will cause aversion response of the reflex blink and/or shifting away from the source of pain. The aim of the work is to predict numerically the threshold limit of incidental laser power that causes damage to the anterior part of the cornea, which can be healed within 2-5 days as long as damage is not exceeding the outer part of the eye (epithelium). A finite element analysis is used to predict temperature distribution through the cornea where the necroses region can be obtained using thermal dose equation. The thermal dose that required for damaging the cornea is predicted from previously published experimental data on rhesus monkeys and used later as a limit for shrinkage to human cornea. The result of this work is compared by international standard of safety and a good nearby result is obtained which verified the result of this work.


2019 ◽  
pp. 116-121
Author(s):  
Rares Filep ◽  
Dorin Nicolae Gherasim ◽  
Septimiu Popescu ◽  
Botond Tokes ◽  
Lucian Marginean

Endovascular treatment is a safe and efficient therapy for intracranial aneurysms with lower complication and mortality rates compared to surgical clipping. Wide-neck aneurysms still represent a challenge to complete and safe aneurysm occlusion in spite of techniques such as stent-assisted or balloon-assisted coiling, developed in order to achieve better occlusion rates. These techniques themselves may lead to further complications, so alternative methods such as the dual microcatheter technique were developed. This technique assumes that, via two microcatheters inserted into an aneurysm, simultaneous deployment of two coils achieves a stable coil frame without the use of adjunctive devices. The aim of this paper is to present a successfully treated basilar tip wide-neck aneurysm treated with the dual microcatheter technique.Case report. A 46-year-old male patient with acute onset of severe headache presented in the emergency room with altered state of consciousness. Non-enhanced CT scan showed subarachnoid and intraventricular haemorrhage. CT angiography revealed a wide-neck basilar tip aneurysm. Digital subtraction angiography confirmed the presence of an aneurysm with a wide, 4.9 mm neck.Dual microcatheter technique was chosen as the first treatment option, while a hypercompliant balloon was kept as backup. Two microcatheters were placed inside de aneurysm and two coils were introduced in order to form a stable framing coil mass that served as a support for further coils deployed in an alternately manner through each microcatheter. No procedural complication occurred, and the patient’s evolution was uneventful with no neurological deficits at discharge.Conclusion. The dual microcatheter technique is a safe and effective therapeutic option for wide-neck ruptured or unruptured intracranial aneurysms. Periprocedural complication rates are similar to simple coiling or balloon-assisted coiling, but lower than for stent-assisted coiling.


2011 ◽  
Vol 36 (4) ◽  
pp. 327-334 ◽  
Author(s):  
Shawn D. McGrane ◽  
David S. Moore

2017 ◽  
Vol 46 (10) ◽  
pp. 1003006
Author(s):  
孙 浩 Sun Hao ◽  
周大勇 Zhou Dayong ◽  
张宏超 Zhang Hongchao ◽  
陆 健 Lu Jian

2017 ◽  
Vol 19 (47) ◽  
pp. 31823-31829 ◽  
Author(s):  
Guoquan Liu ◽  
Shu-Hao Liou ◽  
Nikolay Enkin ◽  
Igor Tkach ◽  
Marina Bennati

Continuous wave laser irradiation of fullerene–nitroxide derivatives at room temperature leads to spin polarization and NMR signal enhancement of toluene solvent protons.


2019 ◽  
Vol 2019 ◽  
pp. 1-7
Author(s):  
Rayno Vic B. Janayon ◽  
Raphael A. Guerrero

Two laser sources operating at wavelengths of 632.8 nm (He-Ne) and 488 nm (Ar+) are used in examining the effects of coherent, low-power, continuous wave exposure on the development of Vigna radiata L. Presowing laser irradiation of seeds leads to an improvement of mung bean seedling characteristics, with increased values of hypocotyl length (an increase of up to 22.5%), root length (an increase of up to 28.8%), and seedling mass (a maximum increase of 29.2%). Measured parameters between seedlings from laser-irradiated seeds and from control samples are statistically different at a level of significance equal to 0.05. For both laser wavelengths, an optimal exposure time of 2 minutes is determined for enhanced growth of mung bean seedlings.


2014 ◽  
Vol 809-810 ◽  
pp. 369-376
Author(s):  
Tao Tao Wu ◽  
Li Jun Wang ◽  
Cheng Hua Wei ◽  
Chun Xu Pan ◽  
Lin Zhu Chen ◽  
...  

Steel 30CrMnSiNi2A slices were irradiated by a continuous wave fiber laser beam with the intensity of 14.5W/cm2. Alloy samples with various temperature processes were obtained by changing the laser irradiation time, irradiation times and atmosphere environment. X-ray diffraction, scanning electron microscope, energy dispersive spectrometer and nanoindentation system were employed to characterize their microstructure morphology and mechanical properties. Three layers were observed in the samples fracture, namely oxide film, hard brittle layer and alloy substrate. The hard brittle layer had a higher hardness and a lower toughness compared with the base metal. Referring to the temperature history, we deemed that the surface oxidation and the solid phase transformation were the main factors which changed laser coupling efficiency. The results also illuminated the correlation between the microstructure morphology and the response to laser irradiation of the samples.


Sign in / Sign up

Export Citation Format

Share Document