Muscle Force per Cross-sectional Area is Inversely Related with Pennation Angle in Strength Trained Athletes

2008 ◽  
Vol 22 (1) ◽  
pp. 128-131 ◽  
Author(s):  
Shigeki Ikegawa ◽  
Kazuo Funato ◽  
Naoya Tsunoda ◽  
Hiroaki Kanehisa ◽  
Tetsuo Fukunaga ◽  
...  
Keyword(s):  
Muscle Force ◽  
Pennation Angle ◽  
Cross Sectional Area ◽  
Sectional Area ◽  
Cross Sectional

scholarly journals The influence of muscle pennation angle and cross-sectional area on contact forces in the ankle joint

2016 ◽  
Vol 52 (1) ◽  
pp. 12-23 ◽  
Author(s):  
Ran S Sopher ◽  
Andrew A Amis ◽  
D Ceri Davies ◽  
Jonathan RT Jeffers
Keyword(s):  
Pennation Angle ◽  
Muscle Architecture ◽  
Cross Sectional Area ◽  
Contact Forces ◽  
Sectional Area ◽  
Muscle Forces ◽  
Cross Sectional ◽  
Contact Loads ◽  
The Mean ◽  
And Function

Data about a muscle’s fibre pennation angle and physiological cross-sectional area are used in musculoskeletal modelling to estimate muscle forces, which are used to calculate joint contact forces. For the leg, muscle architecture data are derived from studies that measured pennation angle at the muscle surface, but not deep within it. Musculoskeletal models developed to estimate joint contact loads have usually been based on the mean values of pennation angle and physiological cross-sectional area. Therefore, the first aim of this study was to investigate differences between superficial and deep pennation angles within each muscle acting over the ankle and predict how differences may influence muscle forces calculated in musculoskeletal modelling. The second aim was to investigate how inter-subject variability in physiological cross-sectional area and pennation angle affects calculated ankle contact forces. Eight cadaveric legs were dissected to excise the muscles acting over the ankle. The mean surface and deep pennation angles, fibre length and physiological cross-sectional area were measured. Cluster analysis was applied to group the muscles according to their architectural characteristics. A previously validated OpenSim model was used to estimate ankle muscle forces and contact loads using architecture data from all eight limbs. The mean surface pennation angle for soleus was significantly greater (54%) than the mean deep pennation angle. Cluster analysis revealed three groups of muscles with similar architecture and function: deep plantarflexors and peroneals, superficial plantarflexors and dorsiflexors. Peak ankle contact force was predicted to occur before toe-off, with magnitude greater than five times bodyweight. Inter-specimen variability in contact force was smallest at peak force. These findings will help improve the development of experimental and computational musculoskeletal models by providing data to estimate force based on both surface and deep pennation angles. Inter-subject variability in muscle architecture affected ankle muscle and contact loads only slightly. The link between muscle architecture and function contributes to the understanding of the relationship between muscle structure and function.

Relationship between muscle force and muscle area showing glycogen loss during locomotion

1982 ◽  
Vol 97 (1) ◽  
pp. 411-420
Author(s):  
R. B. Armstrong ◽  
C. R. Taylor
Keyword(s):  
Muscle Force ◽  
Cross Sectional Area ◽  
Stride Frequency ◽  
Sectional Area ◽  
Triceps Brachii ◽  
Muscle Area ◽  
Cross Sectional ◽  
Triceps Brachii Muscle ◽  
The Cross ◽  
Fast Twitch

This experiment was designed to study the relationship between the cross-sectional area of rat skeletal muscle showing glycogen loss and the muscle forces exerted during exercise. Muscular force exerted by the extensors of the elbows and ankle was increased by 24% by loading rats with 24% of their body mass while running them on a treadmill at 30 m.min-1. VO2 increased by 24% and stride frequency was unchanged when the rats ran with loads. Cross-sectional areas of the elbow and ankle extensor muscles showing glycogen loss were compared from rats running with and without the load. We found a nearly direct proportionality between the changes in force and the changes in muscle area showing glycogen loss, i.e. when the force of the extensors was increased by 24%, the cross-sectional area of the elbow extensors showing glycogen loss increased by 28%, and that of the ankle extensor group increased by 24%. The more peripheral muscles in each group accounted for a greater proportion of the increase in cross-sectional area of the group showing glycogen loss (i.e. lateral and long heads of triceps brachii muscle accounted for 91% of the increase in the elbow extensor group, and gastrocnemius muscle accounted for 84% of the increase in the ankle extensor group). Most of the increases in muscle area showing glycogen loss occurred in fast-twitch-glycolytic fibres (84% in the elbow and 88% in the ankle). The data suggest that increasing muscle force requirements by 24% by loading resulted in proportional increases in cross-sectional area of muscles recruited to produce the force, i.e. that spatial recruitment primarily accounted for the elevation in force. The relatively greater increases in cross-sectional area showing glycogen loss of peripheral muscles within a group indicate the importance of studying whole groups of muscles when considering muscular recruitment patterns during exercise.

scholarly journals Assessment of Maximum Cross-Sectional Area and Volume of the Canine Biceps Brachii – Brachialis Muscles

2018 ◽  
Vol 40 (335) ◽  
pp. 28-31
Author(s):  
Armands Vekšins ◽  
Oskars Kozinda
Keyword(s):  
Muscle Force ◽  
Biceps Brachii ◽  
Cross Sectional Area ◽  
Muscle Volume ◽  
Sectional Area ◽  
Cross Sectional ◽  
Clinically Normal ◽  
Brachialis Muscle ◽  
Tomography Data ◽  
Area And Volume

Abstract The biceps brachii - brachialis muscles has attachment on the medial coronoid process (MCP) and proximal radius. It is considered that medial coronoid disease (MCD) can be caused by biceps brachii – brachialis muscle generated force to MCP. Computed tomography data from 31 dogs were analysed. The aim of this study was to compare biceps brachii – brachialis muscle volume and maximum cross-sectional area (mCSA) between clinically normal dogs to dogs with a MCD. Results showed that in dogs with MCD, biceps brachii - brachialis muscle volume and mCSA is smaller than in clinically normal dogs and therefore the generated muscle force cannot be considered as the main or accompanying cause of a MCD.

Ultrasound analyses of hamstrings muscle morphology changes whit sport

2020 ◽  
Vol 30 (Supplement_2) ◽  
Author(s):  
R Santos ◽  
A Tavares
Keyword(s):  
Morphological Changes ◽  
Muscle Thickness ◽  
Pennation Angle ◽  
Cross Sectional Area ◽  
Sectional Area ◽  
Echo Intensity ◽  
Fascicle Length ◽  
Cross Sectional ◽  
Muscle Morphology ◽  
Ultrasound Parameters

Abstract Introduction Physical activities and sports can change muscle morphology. Changes caused by regular physical exercise can be assessed by ultrasound parameters such as the pennation angle, cross-sectional area, echo-intensity and muscle thickness. Objectives This study aims to characterise and evaluate the morphological changes of the hamstring muscles through ultrasound parameters such as the pennation angle, fascicle length, cross-sectional area, echo-intensity and muscle thickness, and verify the existence of morphological changes between the dominant and non-dominant limb. Methodology Twenty-two young female divided in two groups (control group=11; athletes group=11) were submitted to an ultrasound examination at 50% of the posterior region of the thigh, for the semimembranosus and long portion of the femoral biceps muscles in the longitudinal and in a panoramic view. Results 22 athletes with a mean age of 22.25 years were evaluated. There were significant differences between the two groups in muscle morphology. The athletes group showed a higher value for muscle thickness, cross-sectional area, pennation angle and fascicle length and a lower value for muscle echo-intensity. This group also showed higher values for these parameters when dominant limb is compared with non-dominant. Conclusion Physical exercise causes changes in muscle morphology and ultrasound is a good method for the musculoskeletal assessment of athlete’s performance, since it is an imaging modality that allows to carry out comparative bilateral studies for athletes performance follow up and for preventive strategies against the sedentarism.

scholarly journals Rectus femoris muscle thickness and cross-sectional area on ultrasonography may predict isometric and isokinetic knee extension strength: A cross-sectional study

2021 ◽  
Author(s):  
Ufuk Şekir 9) ◽  
Uğur Can Yalaki ◽  
Bedrettin Akova
Keyword(s):  
Vastus Lateralis ◽  
Muscle Thickness ◽  
Rectus Femoris ◽  
Pennation Angle ◽  
Cross Sectional Area ◽  
Isokinetic Strength ◽  
Sectional Area ◽  
Cross Sectional ◽  
Rectus Femoris Muscle ◽  
Femoris Muscle

Objective: To examine the relationship between knee extensor strength and quadriceps muscle architecture evaluated with ultrasonography during relaxed and contracted situations. Materials and Methods: A total of 40 healthy participants (age range 18-40), doing sports at a recreational level were included. Pennation angle, muscle thickness, and cross-sectional area of the vastus medialis, vastus lateralis, and rectus femoris muscles were measured firstly during rest while participants are sitting on an isokinetic dynamometer with their knees at 0° and 60° of flexion. Thereafter, ultrasound evaluations were performed during maximal isometric contraction at 60° knee flexion and maximal isokinetic contraction at 30°/sec and 60°/sec speeds. The architectural parameters were correlated with peak isometric (measured at 60° knee flexion) and isokinetic (measured at 30°/sec and 60°/sec angular velocities) torque values. Results: Pennation angle (p<0.001), muscle thickness (p<0.001) and muscle cross-sectional area (p<0.001) of the vastus medialis muscle during rest, and isometric and isokinetic maximal contractions were higher than the vastus lateralis and rectus femoris muscles. Pennation angle, muscle thickness and muscle cross-sectional area parameters measured during rest, and isometric and isokinetic maximal contractions in the vastus medialis (r=0.39-0.64, p<0.05-0.01) and vastus lateralis (r=0.36-0.68, p<0.05-0.01) showed weak to moderate correlations with isometric and isokinetic peak torque. In rectus femoris muscle, on the other hand, except the weak correlation in pennation angle (r=0.35-0.49, p<0.05-0.01), muscle thickness (r=0.74-0.80, p<0.001) and cross-sectional area (r=0.71-0.80, p<0.001) had a moderate to strong correlation with isometric and isokinetic strength. Stepwise regression analysis indicated that rectus femoris cross-sectional area measured during knee relaxed at 60° flexion (R2=0.532-0.610) and rectus femoris muscle thickness measured during isometric and isokinetic contraction modes (R2=0.538-0.600) were decisive to predict the isometric and isokinetic strength of the quadriceps muscle. Conclusion: Contrary to pennation angle, muscle thickness and cross-sectional area of the rectus femoris measured during relaxed and contracted conditions may be determinative in predicting isometric and isokinetic strength.

scholarly journals The Muscle-Bone Relationship in X-Linked Hypophosphatemic Rickets

2013 ◽  
Vol 98 (5) ◽  
pp. E990-E995 ◽  
Author(s):  
Louis-Nicolas Veilleux ◽  
Moira S. Cheung ◽  
Francis H. Glorieux ◽  
Frank Rauch
Keyword(s):  
Bone Mass ◽  
Muscle Function ◽  
Muscle Force ◽  
Distal Tibia ◽  
Lower Extremities ◽  
Cross Sectional Area ◽  
Hypophosphatemic Rickets ◽  
Sectional Area ◽  
Cross Sectional ◽  
Study Objective

Context: We recently found that patients with X-linked hypophosphatemic rickets (XLH) have a muscle function deficit in the lower extremities. As muscle force and bone mass are usually closely related, we hypothesized that patients with XLH could also have a bone mass deficit in the lower extremities. Objective: The study objective was to assess the muscle-bone relationship in the lower extremities of patients with XLH. Setting: The study was carried out in the outpatients department of a pediatric orthopedic hospital. Patients and Other Participants: Thirty individuals with XLH (6 to 60 y; 9 male patients) and 30 age- and gender-matched controls participated. Main Outcome Measures: Calf muscle size and density as well as tibia bone mass and geometry were assessed by peripheral quantitative computed tomography. Muscle function was evaluated as peak force in the multiple 2-legged hopping test. Results: Muscle force was significantly lower in XLH patients than in controls but muscle cross-sectional area did not differ (after adjustment for tibia length). External bone size, expressed as total bone cross-sectional area, was higher in the XLH group than in controls. The XLH cohort also had statistically significantly higher bone mineral content. Conclusions: Patients with XLH have increased bone mass and size at the distal tibia despite muscle function deficits.

Sign in / Sign up

Export Citation Format

Share Document