Rheological and Chemical Characteristics of Asphalt Binder Modified with Groundnut Shell Bio-oil

2020 ◽  
Vol 9 (1) ◽  
pp. 20190227 ◽  
Author(s):  
Dharamveer Singh ◽  
Chetan Yenare ◽  
Burhan Showkat
2021 ◽  
Vol 10 (1) ◽  
pp. 20200143
Author(s):  
Shashibhushan Girimath ◽  
Dharamveer Singh ◽  
Burhan Showkat

2019 ◽  
Vol 196 ◽  
pp. 134-143 ◽  
Author(s):  
Ran Zhang ◽  
Zhanping You ◽  
Hainian Wang ◽  
Mingxiao Ye ◽  
Yoke Khin Yap ◽  
...  

2021 ◽  
Vol 13 (7) ◽  
pp. 4039
Author(s):  
Sara A. Alattieh ◽  
Ghazi G. Al-Khateeb ◽  
Waleed Zeiada

Fatigue cracking and low-temperature cracking are two major distresses that occur in asphalt pavements. Fatigue cracking is a load-associated distress caused by the tensile stresses at the bottom/top of the asphalt concrete (AC) layer due to repeated traffic loading. On the other hand, low-temperature cracking occurs when tensile stresses built up with in the AC layer at low temperatures exceed the tensile strength of that layer. In this study, the performance of date seeds oil bio-modified asphalt binders (DSO-BMB) is evaluated against fatigue and low-temperature cracking. The DSO-BMBs are prepared using volume ratios of 1.5, 2.5, 3.5, 4.5, and 5.5% date seeds oil-to-asphalt binder. The base asphalt binder used in the study is a 60/70-penetration grade with a Superpave performance grade (PG) of PG 64–16. The dynamic shear rheometer (DSR) standard test was used to assess the fatigue performance of the bio-modified binders (BMBs), while the bending beam rheometer (BBR) test was used to test the BMBs for low-temperature performance. In addition, the DSR linear amplitude sweep (LAS) test was used to evaluate the fatigue tolerance behavior of the DSO-BMBs. The analysis and results of the study showed that the bio-oil enhanced the low-temperature performance. The low PG grade improved from −16 °C for the control asphalt binder to −28 °C for the BMB. Additionally, the fatigue resistance of the BMBs was improved as illustrated by the damage–characteristic curves of the modified asphalt binders from the visco-elastic continuum damage (VECD) analysis and the increase in the number of cycles to fatigue failure (Nf).


2016 ◽  
Vol 102 ◽  
pp. 496-504 ◽  
Author(s):  
Zhaojie Sun ◽  
Junyan Yi ◽  
Yudong Huang ◽  
Decheng Feng ◽  
Chaoyang Guo

2015 ◽  
Vol 77 (23) ◽  
Author(s):  
Noor Azah Abdul Raman ◽  
Mohd Rosli Hainin ◽  
Norhidayah Abdul Hassan ◽  
Farid Nasir Ani ◽  
M.Naqiuddin M.Warid ◽  
...  

Bio-oil which is derived from pyrolysis palm empty fruit bunch (EFB) is expected to be a potential alternative modifier for asphalt. This study focused on the effect of bio-oil on the penetration index (PI) asphalt. Bio-oil is blended between 2%-10% by weight of virgin asphalt penetration grade 80/100. Physical properties are measured and compared with virgin asphalt by the conventional physical binder test – softening point and penetration. The penetration index (PI) values is calculated to identify the typical values of asphalt type. Based on the findings, it was found that increased bio-oil content can effectively soften the asphalt at the same time maintain the temperature susceptibility. Modification asphalt is still within the grade 80/100 PEN with the addition of 10% maximum of bio oil. The stiffness of modified asphalt need to be further improved by addition polymer for better asphalt binder properties.


Molecules ◽  
2021 ◽  
Vol 26 (23) ◽  
pp. 7080
Author(s):  
Xiaorui Zhang ◽  
Chao Han ◽  
Xinxing Zhou ◽  
Frédéric Otto ◽  
Fan Zhang

Soybean-derived bio-oil is one of the vegetable-based oils that is gaining the most interest for potential use in the rejuvenation of aged asphalt binders. This laboratory study was conducted to characterize and quantify the diffusion and rheological properties of bio-oil-rejuvenated aged asphalt binder (BRAA) using soybean oil. In the study, the chemical structure of the soybean oil was comparatively characterized using an element analyzer (EA), gel permeation chromatography (GPC), and a Fourier infrared (FTIR) spectrometer, respectively. Based on the chemical structure of the bio-oil, BRAA molecular models were built for computing the diffusion parameters using molecular dynamic simulations. Likewise, a dynamic shear rheometer (DSR) test device was used for measuring and quantifying the rheological properties of the aged asphalt binder rejuvenated with 0%, 1%, 2%, 3%, 4%, and 5% soybean oil, respectively. The laboratory test results indicate that bio-oil could potentially improve the diffusion coefficients and phase angle of the aged asphalt binder. Similarly, the corresponding decrease in the complex shear modulus has a positive effect on the low-temperature properties of BRAA. For a bio-oil dosage 4.0%, the diffusion coefficients of the BRAA components are 1.52 × 10−8, 1.33 × 10−8, 3.47 × 10−8, 4.82 × 10−8 and 3.92 × 10−8, respectively. Similarly, the corresponding reduction in the complex shear modulus from 1.27 × 107 Pa to 4.0 × 105 Pa suggests an improvement in the low-temperature properties of BRAA. Overall, the study contributes to the literature on the potential use of soybean-derived bio-oil as a rejuvenator of aged asphalt binders.


2019 ◽  
Vol 37 (15) ◽  
pp. 1788-1799 ◽  
Author(s):  
Mohamadtaqi Baqersad ◽  
Hesham Ali ◽  
Farshad Haddadi ◽  
Iman Khakpour

Sign in / Sign up

Export Citation Format

Share Document